Sentry360 FS-DM-DOME-HB Bedienungsanleitung
1
FS-DM-DOME-HB
FullSight™Dome with Heater Blower
Installation Guide
Revision: 10/9/2014
Copyright © 2007-2013 Sentry360
FS-DM-DOME-HB 2
Installation Guide
I. Description
The FS-DM-DOME-HB is suitable for indoor and outdoor use, and has
been designed for rapid installation. The extended dome cover permits
unhindered 360° viewing. The case has been produced using die-
castings aluminum materials, powder coating and a high impact-
resistant, ultra-transparent cover. Both side and rear entry cable ports
are provided. The housing is IP66 rated.
II. Specifications
Model
FS-DM-DOME
Options
Blower / Heater/ POE Board
Input Voltage
DC48V POE
Power Consumption
9.6W oHs
Operational Range
Temperature / -40~+60°C
Humidity / 0~95%
Heater Blower
Heater : ON 4
±3
Size
IP DOME
φ148.4(W)x160.8(H) m/m
φ130.5(W)x155.3(H) m/m
Weight
1.8 KG
Material
Body：Aluminum（ADC-12）
Window: Transparent cover
Water Proof Rating
IP66
Accessories Supplied
5mm Wrench (1ea), Plastic Expansion/Plug (4ea), M4 steel screw –(4ea), 1
Network Cable
FS-DM-DOME-HB 3
Installation Guide
III. Package Contents
Dome Enclosure (1)
Hexagonal Allen Wrench (1)
Plastic Screw Anchors (4)
1” Philips Screws (4)
3/8th” Hexagonal Screw (1)
Ethernet Cable (1)
FS-DM-DOME-HB 4
Installation Guide
IV. FullSight™Camera Installation Instructions:
A. Locate and loosen Screws.
a) Find the 4 Hexagonal screws located around the ring of the
glass enclosure.
FS-DM-DOME-HB 5
Installation Guide
b) Loosen the 4 screws with the hexagonal wrench packaged
with the dome.
FS-DM-DOME-HB 6
Installation Guide
B. Remove the vandal-proof lid by lifting it from the base.
Internal components overview:
Blower
Camera Plate
POE Port
Optional DC
Conduit Holes
FS-DM-DOME-HB 7
Installation Guide
C. Locate and remove the camera plate by unscrewing the Philips
screw attaching it to the dome.
D. Attach the camera plate to the camera using the 3/8th” screw
packaged with the dome.
(NOTE: Washers may be required)
FS-DM-DOME-HB 8
Installation Guide
Side Conduit Knockout Hole
Bottom Conduit Knockout
Hole
E. Select a conduit knockout hole
Depending on what surface you are mounting the camera to,
choose between one of the two conduit knockout holes to use
for the cables:
Conduit knockout holes:
FS-DM-DOME-HB 9
Installation Guide
F. Remove the plug of the conduit knockout hole you have
selected by using a large flathead screwdriver.
G. Insert your external Ethernet cable through the conduit
knockout hole and plug it into the open POE port.
FS-DM-DOME-HB 10
Installation Guide
H. Connect the Ethernet cable provided with the dome to the
camera.
(NOTE: If powering camera with DC power, you can connect your external network cable
directly to the camera for direct data transmission)
Inhaltsverzeichnis
Andere Sentry360 IP-Kamera Handbücher
