Sharp PC-9800T Bedienungsanleitung
Notice for Users in the USA
FCC Statement
WARNING - FCC Regulations state that any unauthorized changes
or modifications to this equipment not expressly approved by the
manufacturer could void the user’s authority to operate this
equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the FCC
Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
A shielded I/F cable is required to insure compliance with FCC
regulation for Class B computing equipment.
* As an Energy Star Partner, SHARP has determined that this product
meets the Energy Star guidelines for energy efficiency.
Declaration of Conformity
i
SHARP PERSONAL COMPUTER, PC-9800T
This device complies with part 15 of the FCC rules. Operation is subject to the following
conditions:(1)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Responsible Party: SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430
TEL: 1-800-BE-SHARP
About the Modem
This equipment PC-9800T complies with Part 68 of FCC rules. On
the bottom of this equipment is a label that contains, among other
information, the FCC registration number and ringer equivalence
number (REN) for this equipment. If requested, this information must
be provided to the telephone company.
The modem jack of this equipment complies with Sub-part F of Part
68 of FCC rules.
The REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive RENs on the telephone
line may result in the devices not ringing in response to an incoming
call. In most, but not all areas, the sum of the RENs should not
exceed five (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs contact the
telephone company to determine the maximum REN for the calling
areas.
If the terminal equipment causes harm to the telephone network, the
telephone company will notify you in advance that temporary
discontinuance of service may be required. But if advance notice isn't
practical, the telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a complaint
with the FCC if you believe it necessary.
The telephone company may make changes in its facilities,
equipment, operations, or procedures that could affect the operation of
the equipment. If this happens, the telephone company will provide
advance notice in order for you to make the necessary modifications
in order to maintain uninterrupted service.
ii
If trouble is experienced with this equipment, please contact Sharp
Electronics Corp. for repair and (or) warranty information (Refer to
the end of this section). If the trouble is causing harm to the telephone
network, the telephone company may request you remove the
equipment from the network until the problem is resolved.
The equipment cannot be used on public coin service provided by the
telephone company. Connection to Party Line Service is subject to
state tariffs. (Contact the state public utility commission, public
service commission or corporation commission for information.)
iii
The Telephone Consumer Protection Act of 1991 makes it unlawful
for any person to use a computer or other electronic device, including
fax machines, to send any message unless such message clearly
contains in a margin at the top or bottom of each transmitted page or
on the first page of the transmission, the date and time it is sent and an
identification of the business or other entity, or other individual
sending the message and the telephone number of the sending
machine or such business, other entity, or individual. (The telephone
number provided may not be a 900 number or any other number for
which charges exceed local or long-distance transmission charges.) To
program this information, refer to the manual of the communication
software.
CAUTION about CD-ROM Drive
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
CAUTION about Battery
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer's instructions.
Copyright
It is the intent of Sharp that this product be used in full compliance
with the copyright laws of the United States and that prior permission
be obtained from copyright owners whenever necessary.
Product Information and Customer Assistance
For Product Information and Customer Assistance:
Call: 1-800-BE-SHARP (237-4277)
Sharp Electronics Corp.
Sharp Plaza
iv
Mahwah, NJ 07430
v
Notice for Users in Canada
About Modem
The REN is 0.3.
The Industry Canada label identifies certified equipment.
This certification means that the equipment meet certain
telecommunications network protective, operational and safety
requirements. The department does not guarantee the equipment will
operate to the user's satisfaction.
Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local
telecommunications company.
The equipment must also be installed using an acceptable method of
connection. In some cases, the company's inside wiring associated
with a single line individual service may be extended by means of a
certified connector assembly (telephone extension cord). The
customer should be aware that compliance with the above conditions
may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equipment
malfunctions, may give the telecommunications company cause to
request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical ground
connections of the power utility, telephone lines and internal metallic
water pipe system, if present, are connected together. This precaution
may be particularly important in rural areas.
CAUTIONUsers should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.
vi
“The Load Number (LN) assigned to each terminal device denotes
the percentage of the total load to be connected to a telephone loop
which is used by the device. To prevent overloading, the termination
on a loop may consist of any combination of devise subject only to the
requirement that the total of the Load Numbers of all the devices does
not exceed 100.”
Product Information and Customer Assistance
For Product Information and Customer Assistance:
Call: 1-905-890-2100
Sharp Electronics of Canada Ltd.
335 Britannia Road East,
Mississauga, Ontario, L4Z 1W9
Canada
vii
Notice for Users in Australia
Service Inquiries
Please contact your dealer for service if required or contact Sharp
Corporation of Australia on 1-800-807820 (free call) for referral to
your nearest Sharp authorised Service Centre. Details can be found
on the warranty card inserted with the documentation.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Do not dispose of large quantities of used Lithium batteries at the
same time.
Copyright
Copyright may exist in material you wish to record. Copying or
broadcasting such material without permission of the relevant
licensees or owners of the copyright is prohibited by law.
SHARP is not in a position to authorise the copying or broadcasting of
copyright materials and nothing in this OPERATION MANUAL
should be implied as giving that authority.
viii
Notice for Users in the UK
IMPORTANT
The wires in this mains lead are coloured in accordance with the
following code:
BLUE: Neutral
BROWN: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the
terminals in your plug proceed as follows.
The wire which is coloured BLUE must be connected to the
terminal which is marked with the letter Nor coloured black.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter Lor coloured red.
This apparatus must be protected by a 3A fuse in the mains plug or
di ib i b d
This apparatus is approved under approval number NS/G
1234/J/100003 for indirect connection to the public
telecommunication system in the United Kingdom.
Service Inquiries
For customer and service support, please refer to the documentation
included with your notebook.
Copyright
Recording and playback of any material may require consent, which
SHARP is unable to give. Please refer particularly to the provisions
of the Copyright Act 1956, the Dramatic and Musical Performers
Protection Act 1958, the Performers Protection Acts 1963 and 1972
and to any subsequent statutory enactments and orders.
ix
Notice for Users in Europe
This equipment complies with the requirements of
Directives 89/336/EEC and 73/23/EEC as amended by
93/68/EEC.
Dieses Gerät entspricht den Anforderungen der EG-
Richtlinien 89/336/EWG und 73/23/EWG mit Änderung
93/68/EWG.
Ce matériel répond aux exigences contenues dans les
directives 89/336/CEE et 73/23/CEE modifiées par la
directive 93/68/CEE.
Dit apparaat voldoet aan de eisen van de richtlijnen
89/336/EEG en 73/23/EEG, gewijzigd door 93/68/EEG.
Dette udstyr overholder kravene i direktiv nr. 89/336/EEC
og 73/23/EEC med tillæg nr. 93/68/EEC.
Quest' apparecchio è conforme ai requisiti delle direttive
89/336/EEC e 73/23/EEC, come emendata dalla direttiva
93/68/EEC.
Ηεγκατασταση αυτη ανταποκρινεται στιζ απαιτησειζ
των οδηγιων τηζ Ευρωπαïκηζ Ενωσηζ 89/336/EOK
κατ 73/23/EOK, óπωζ οι κανονισµοι αυτοι
συµπληρωθηκαν απó την οδηγια 93/68/EOK.
Este equipamento obedece às exigências das directivas
89/336/CEE e 73/23/CEE, na sua versão corrigida pela
directiva 93/68/CEE.
Este aparato satisface las exigencias de las Directivas
89/336/CEE y 73/23/CEE, modificadas por medio de la
93/68/CEE.
x
Inhaltsverzeichnis
Andere Sharp Laptop Handbücher
Sharp
Sharp Actius PC-GP22W Bedienungsanleitung
Sharp
Sharp PC-AL27 - Actius AL27 - Mobile Athlon 64 1.6... Bedienungsanleitung
Sharp
Sharp Actius PC-UM32W Bedienungsanleitung
Sharp
Sharp Actius PC-GP22W Bedienungsanleitung
Sharp
Sharp PC-MM1 series Bedienungsanleitung
Sharp
Sharp Actius PC-GP20 Bedienungsanleitung
Sharp
Sharp Actius PC-TN10W Bedienungsanleitung
Sharp
Sharp PC-MR70 Bedienungsanleitung
Sharp
Sharp Actius PC-UM30W Bedienungsanleitung
Sharp
Sharp Actius PC-MV14 Betriebsanleitung
Sharp
Sharp PC-MC20 Series Bedienungsanleitung
Sharp
Sharp Actius PC-GP20 Betriebsanleitung
Sharp
Sharp Actius PC-MC22 Bedienungsanleitung
Sharp
Sharp Actius PC-UM20 Bedienungsanleitung
Sharp
Sharp Actius PC-UM32W Bedienungsanleitung
Sharp
Sharp PC-A250 Bedienungsanleitung
Sharp
Sharp UM20 Bedienungsanleitung
Sharp
Sharp PC-W100T Bedienungsanleitung
Sharp
Sharp PC-AV18 Series Bedienungsanleitung
Sharp
Sharp Actius PC-GP20 Bedienungsanleitung
