Shell SH912 Bedienungsanleitung
POL BOOSTSTATUS
Red LED
Green / Red LED
Jump Start
Troubleshooting
Jumper cable signal
POL SoundStatus Cause
Off OffSolid Green
Off Off
Flashing
Green
1. Vehicle’s battery cannot be detected.
Off Off
Red & Green
light flashes
alternately
Over-voltage protection.
Over-current protection
Off Off
Red light
flashes rapidly
1. High temperature protection.
2.Voltage of the jump starter is too
low / overdischarge protection.
Jump started 4 consecutive times within
10 minutes.
Off
Solid Red
Red light
flashes slowly
Solid Red
Flashing
Green
Off
Off
Constant
Beeping
3. Jumper cable not connected
to the jump starter.
Reversed polarity protection. Battery clamps
are connected to the wrong
polarities of the vehicle battery.
Off
2. Short circuit protection.
3. Vehicle’s battery voltage is too low
or cannot be detected.
*WARNING Use “BOOST” with extreme care. Clamps must be tightly connected to the correct polarities
of the vehicle’s battery before pressing boost button. Spark proof and other safety protections will be
disabled after pressing boost button. This mode generates very high current. Sparks will generate when
clamps touch or are connected to each other. It may cause damage to the product and the vehicle’s
electrical system if not used properly. Seek professional assistance if you are not sure about using this mode.
Solutions
Jump start the vehicle.
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery.
Press “BOOST” on the jumper cable. Solid green LED light will turn on. Jump start the vehicle.
*See warning below.
Disconnect the jump starter and jumper cable from the vehicle. The vehicle’s battery voltage is
higher than applicable. This product is suitable for 12V battery only.
Disconnect the jump starter and jumper cable from the vehicle. Check and make sure the vehicle
starter is not stuck. Wait 30 seconds. Follow jump starting vehicle instructions to jump start the
vehicle.
Disconnect the clamps from the vehicle’s battery. Unplug the jumper cable from the jump
starter. Let the jump starter cool down by putting it in a cool and ventilated place.
Charge the jump starter.
Do not jump start more than 4 times. Disconnect the clamps from the vehicle’s battery.
Unplug the jumper cable from the jump starter. Consult a mechanic.
Connect jumper cable to the jump starter before connecting the clamps to the vehicle battery.
Disconnect the clamps from the vehicle’s battery. Unplug the jumper cable from
the jump starter. Follow jump starting vehicle instructions to jump start the vehicle.
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery
Make sure the clamps are securely connected to the correct polarities of the vehicle’s battery
Charging Portable Devices
1. Connect your portable device with one end of the USB
cable, and insert the other end to one of the output ports:
USB-A 1, USB-A 2 or Type-C port, of the jump starter. Note: to
use the fast charging function, please use the Type-C port.
Compatible with: smart phones, tablets, digital cameras, mobile
gaming devices, wireless earphones and more.
Note: Charging time will vary depending on the portable device
and the device’s battery capacity.
2. Charging will begin as soon as the connections are made.
3. Once the charging is completed, disconnect your portable device
and unplug the USB cable from the jump starter.
Inhaltsverzeichnis
Andere Shell Fernstartsystem Handbücher
