Assembly Instructions
Figure 1
STEP 2
Connect End frame (#2) to Bottom Frame
(#1).
Lay assembly on the floor as shown in
Figure 1, Slide End Frame (#2) thru the
bracket welded at the end of Bottomframe
(#1), secure them with 2 Hex bolts (#7), 2
Washers (#8) and 2 Lock nuts (#9) for End
frame (#2).
See Figure 2 and Detail B.
Repeat this step for the other side.
STEP 1
Connect Bottom Frame (#1) together
using 2 Bottom support bracket (#5), 2
Mounting plate (#6), 8 Hex bolts (#12), 8
Washers (#13), and 8 Lock nuts (#14). See
Figure 1 and Detail A.
Detail A
Detail B
7
1
1
2
1
1
STEP 3
Connect Slant tube (#3) to End Frame (#2).
connect the bottom of Slant tube (#3) to Base
frame (#1) using 4 Hex bolts (#11), 4 Washers
(#13), and 4 Lock nuts (#14). See Detail D.
Tighten all the bolts and nuts.
Place Brace (#4) inside End Frame (#2), and
place Slant tube (#3) inside Brace (#4), Connect
them together using 4 Hex bolts (#10), 4 washers
(#13) and 4 Lock nuts (#14).See Detail C.
14
13 3
11
1
A
14
13
1
13
14
1
5
6
11
1
1
12
89987
2
1
2
B
14
4
13 10
2
3
10
2
2
3
3
C
Detail C
D
Detail D
Rope
2
2
page 2
STEP 4
Tie Rope(#15) to Side tubes in the front only
(#2),This will make the snow and rain slide off
easy and makes the cover look better on the log
rack.
Figure 2
Figure 3
Figure 4
Full & 1/4 -- Water repellent
covers sold separately.
For purchase call:
Toll free: 1-888-466-8600
or 203 591 9033
Product # 23328
1/4 Cover
Product # 23338
Full Cover
