Shure X2U Bedienungsanleitung

XLR-to-USB Signal Adapter

X2u

27A12073 (Rev. 3)

N108

MIC GAIN

VOLUME

MONITOR

English

Français

Deutsch

Español

Italiano

日本語

中文

한국어

AVERTISSEMENT !

L'ÉCOUTE AUDIO À UN VOLUME SONORE EXCESSIF PEUT CAUSER DES

LÉSIONS AUDITIVES PERMANENTES. RÉGLER LE VOLUME LE PLUS BAS

POSSIBLE.

Une surexposition à des volumes sonores excessifs peut causer des lésions aux

oreilles entraînant une perte auditive permanente due au bruit. Se conformer aux

directives ci-dessous, établies par l'Occupational Safety Health Administration

(OSHA) pour les limites de durée d'exposition aux pressions acoustiques (SPL)

avant de risquer des lésions auditives.

SPL de 90 dB

pendant 8 heures

SPL de 95 dB

pendant 4 heures

SPL de 100 dB

pendant 2 heures SPL de 105 dB

pendant 1 heure

SPL de 110 dB

pendant 1/2 heure

SPL de 115 dB

pendant 15

minutes

SPL de 120 dB

À éviter : risque de lésions auditives

WARNING!

LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT

HEARING DAMAGE.

USE AS LOW A VOLUME AS POSSIBLE.

Over exposure to excessive sound levels can damage your ears resulting in permanent

noise-induced hearing loss (NIHL). Please use the following guidelines established by

the Occupational Safety Health Administration (OSHA) on maximum time exposure to

sound pressure levels before hearing damage occurs.

90 dB SPL

at 8 hours

95 dB SPL

at 4 hours

100 dB SPL

at 2 hours

105 dB SPL

at 1 hour

110 dB SPL

at ½ hour

115 dB SPL

at 15 minutes

120 dB SPL

Avoid or damage may occur

SAFETY PRECAUTIONS

The possible results of incorrect use are marked by one of the two symbols -

“WARNING” AND “CAUTION” - depending on the imminence of the danger and the

severity of the damage.

WARNING: Ignoring these warnings may cause severe injury or death as a

result of incorrect operation.

CAUTION: Ignoring these cautions may cause moderate injury or property

damage as a result of incorrect operation.

WARNING

• If water or other foreign objects enter the inside of the device, fire or electric shock

may result.

• Do not attempt to modify this product. Doing so could result in personal injury

and/or product failure.

CAUTION

• Never disassemble or modify the device, as failures may result.

• Do not subject to extreme force and do not pull on the cable or failures may result.

• Keep the device dry and avoid exposure to extreme temperatures and humidity.

WARNING: This product contains a chemical known to the State of California

to cause cancer and birth defects or other reproductive harm

MIC GAIN

VOLUME

MONITOR

12(+)

3()

1.18 in

(30 mm)

4.96 in

(126 mm)

General Description

The X2u compact universal XLR-to-USB adapter enables you to connect any

microphone directly to your computer.

A XLR Connector

BTri-color peak level indicator: Green = signal, Yellow = peak, Red = clipping

C MIC GAIN: Adjusts microphone input level before the analog to digital

conversion.

D Headphone jack: For zero-latency direct monitoring.

E VOLUME: Adjusts headphone volume.

F MONITOR: Blends pre-recorded playback from the computer with live

audio from the microphone.

G +48V: Phantom power switch for condenser microphones. Switch off for

microphones that do not require phantom power (conserves battery life

when connected to a laptop).

H Blue phantom power indicator

I USB: Illuminates green when properly connected to a powered computer

USB port.

JUSB Connector: Digital audio interface

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

MONITOR

USB Connection

Connect to a powered USB port using a standard

cable (supplied).

The green USB light should illuminate and the

plug-and-play driver will install automatically.

You are then ready to record with your favorite

audio software.

XLR Connection

Connect directly to a microphone, or use an XLR cable and secure

the adapter to a microphone stand using the supplied straps.

Note: Make sure to use a powered USB port.

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

MONITOR

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

MONITOR

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

MONITOR

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

MIC GAIN

VOLUME

MONITOR

VOLUME

MONITOR

MIC GAIN

MONITOR

Monitoring While Recording

The headphone jack provides direct monitoring of the mi-

crophone signal while recording, without any of the delay

that occurs if you were to monitor this signal through the

computer’s headphone output.

Warning: Turn the VOLUME control down before plugging

in headphones

You can also monitor previously recorded tracks while re-

cording a new track. Adjust the MONITOR thumb slider to

balance levels from pre-recorded and live audio.

Note: Be sure to turn off monitoring in your software for

the track to which you are recording.

Gain Adjustment

For maximum audio quality, set the MIC GAIN as high as

possible. The peak level indicator should remain a steady

green while recording, flickering yellow at the highest

sound volumes.

Lower the MIC GAIN if the peak level indicator shows red

at any time during a performance.

USB Audio Device Driver

If you encounter problems, make sure the driver was properly installed.

Windows Operating Systems

From the Control Panel, open Sounds and Audio Devices.

In the Audio tab, look for Shure Digital in the drop-down

menus for Sound playback and Sound recording.

Macintosh OSX Operating Systems

Open the Sound Preference window from System Preferences.

Select Shure Digital from both the Input and Output tabs.

Note: GarageBand users: open GarageBand before plugging in the

microphone to automatically select the USB device.

Troubleshooting

Problem Solution

No USB power indicator light Verify port is powered USB 1.1 or 2.0.

No sound in headphones Turn up the VOLUME or MIC GAIN thumb slider.

Sound is distorted Turn down MIC GAIN.

Source sounds delayed Turn off software monitoring in the computer

software.

Headphones are not loud

enough

Windows: From Control Panel, choose Sound and

Audio Devices, select Audio tab, click Volume under

Sound playback and turn up Volume Control.

Mac: From System Preferences, Choose Sound,

Select Output tab and turn up Output volume.

Microphone input is too quiet

in headphones

Turn down MONITOR thumb slider

SPECIFICATIONS

Note: specifications are subject to change.

Frequency Response 20 to 20,000 Hz ±1 dB

Input Impedance

(@ 1 kHz)

1.6 kΩ

Maximum Input Level 0 dBV

Power Requirements USB-powered, 500 mA, maximum

Phantom Power Supply 48 V, 10 mA

Digital Noise Floor

(20 Hz to 20 kHz, A-weighted)

Minimum MIC GAIN setting: −81 dB FS

Maximum MIC GAIN setting: −78 dB FS

Sampling Rate up to 48 kHz

Bit Depth 16 bit

Peak Signal Indicator

(Tri-color)

OFF: −30 dB FS

Green: −30 to −12 dB FS

Yellow: −12 to 0 dB FS

Red: >0 (digital converter clipped)

Adjustable Gain Range 50 dB

Headphone Output 3.5 mm (1/8 inch)

60 mW @ 32 Ω

Andere Handbücher für X2U

Inhaltsverzeichnis

Andere Shure Adapter Handbücher

Shure

Shure A15LA Bedienungsanleitung

Shure

Shure A27M Bedienungsanleitung

Shure

Shure RMCE-TW2 Bedienungsanleitung

Shure

Shure X2U Bedienungsanleitung

Shure

Shure X2U Bedienungsanleitung

Shure

Shure RMCE-TW1 Bedienungsanleitung

Shure

Shure RMCE-TW2 Bedienungsanleitung

Shure

Shure X2U Bedienungsanleitung

Shure

Shure A27M Bedienungsanleitung

Shure

Shure A710-MSA Bedienungsanleitung

Shure

Shure X2U Bedienungsanleitung

Shure

Shure A27M Bedienungsanleitung

Shure

Shure RMCE-TW2 Bedienungsanleitung

Shure

Shure A27M Bedienungsanleitung

Shure

Shure RMCE-TW1 Bedienungsanleitung

Beliebte Adapter Handbücher anderer Marken

PCB Piezotronics

PCB Piezotronics 090B274 Bedienungsanleitung

Gossen MetraWatt

Gossen MetraWatt AT3-III E Bedienungsanleitung

Akribis

Akribis ITF-21-BISS-MIT Bedienungsanleitung

Auvidea

Auvidea J20 Produkthandbuch

Tenda

Tenda W54U Bedienungsanleitung

ROHO

ROHO AGILITY Bedienungsanleitung

PROLiNK

PROLiNK WN2001 Bedienungsanleitung

Hawking

Hawking HUF2 Bedienungsanleitung

Airlink101

Airlink101 AWLC4030 Bedienungsanleitung

NETGEAR

NETGEAR XAV101v1 - Powerline AV Ethernet Adapter Bedienungsanleitung

Philips

Philips SWA4554S/10 Bedienungsanleitung

JVC

JVC TS-C9D2B Gebrauchsanweisung

NETGEAR

NETGEAR A6100 Bedienungsanleitung

D-Link

D-Link DWA-121 Bedienungsanleitung

Philips

Philips SWA2037 Bedienungsanleitung

Basalte

Basalte 0610-20 Bedienungsanleitung

Yealink

Yealink EHS40 Bedienungsanleitung

RCA

RCA AH57R Bedienungsanleitung