Shure 33-44 Series Bedienungsanleitung

1/5

33-44 Series -- Phono Cartridge

General Description

Shure cartridges can be used in DJ or Hi-Fi applications.

The M70BX is not recommended for heavy scratching.

Install Your Cartridge

1. Carefully remove the stylus from the cartridge. See Figure 1.

2. Use needle-nose pliers to connect the colored wires from the tonearm headshell to the corresponding pins on

the cartridge. See Table 1 and Figure 2.

Table 1. Cartridge Wiring

HEADSHELL WIRE COLOR PIN

RIGHT "HOT" RED R

RIGHT GROUND GREEN RG

LEFT "HOT" WHITE L

LEFT GROUND BLUE LG

Figure 1

Shure Incorporated

2/5

Figure 2

Figure 3

1. Attach the cartridge to the headshell using the screws supplied. See Figure 3. Tighten the screws after posi

tioning the cartridge (and headshell weight, if desired) according to one of the methods described below.

2. Carefully insert the stylus into the cartridge.

Choose a Method for Cartridge Positioning

HI-FI Setup: For maximum fidelity and minimal record wear, position the cartridge using an alignment protractor or

the overhang gauge supplied with your turntable. Level your tonearm (See Figure 7). Use Table 2 and "Setting a

Precise Tracking Force", below, to set the typical tracking force for your cartridge. Set the anti-skate control to the

same number as the tracking force.

Shure Incorporated

3/5

Figure 4

Standard DJ Setup: Mount cartridge at rear of headshell. Set tonearm height to 4-5. Set tracking force to 3

grams. Set anti-skate control to 0.

Figure 5

Unorthodox DJ Setup: Reverse the counterweight and mount it flush with the end of the tonearm. Mount car

tridge (with headshell weight) flush with the front edge of the headshell. Set anti-skate control to 0.

Figure 6

Level Your Tonearm

Figure 7

Extra Skip Resistance for DJ's:

Mount the cartridge at a 23 degree angle as shown, so that the cartridge points to the tonearm pivot. Set anti-skate

to 0.

Shure Incorporated

4/5

Setting a Precise Tracking Force

1. After mounting the cartridge on the tonearm, rotate the circular weight at the back of the tonearm until the nee

dle floats evenly above the record.

2. Hold the circular weight in place and rotate the calibration ring to read zero. The tonearm should still float even

ly above the record.

3. Rotate the weight until the calibration ring indicates the desired tracking force.

Care and Cleaning

•DJs: Don't use more tracking force than necessary to prevent skipping. Excess force will burn records, damage

needles, and reduce sound quality.

•Clean the stylus with the supplied cleaning brush.

Brush from the back to the front only, as shown in Figure 9.

Figure 9

Cartridge Specifications

Table 2. Cartridge Specifications

Shure Incorporated

5/5

Car

tridge

Replace

ment Sty

lus

Stylus

Color

Stereo Output (1 KHz

at 5 cm/sec peak

recorded velocity)

Frequency

Response in

Tracking

Force Range

(grams)

Typical

Tracking

Force

(grams)

M44-7 N44-7 White 9.5 mV 20 to 20,000 1-3 3

M44G N44G Gray 6.2 mV 20 to 20,000 .75-1.5 1.5

M35S N35S Char

treuse

5.0 mV 20 to 20,000 3-5 4

35X N35X White 6.0 mV 20 to 20,000 1.5-3 3

M70BX N70BX Beige .0 mV 20 to 18,000 1.5-3 3

SC35C SS35S Light

Blue

5.0 mV 20 to 20,000 4-5 4.5

All Cartridges and Styli

•Standard ½ inch mount for DJ turntables

•Wide diameter styli for reduced record wear

•Optimum Load:

◦47 K Ohms, M44: 400-500 pF

◦M35, M70BX, SC35C: 200-300 pF

•Inductance:

◦M44: 720 Mh, M35

◦SC35C: 425 mH

◦M70BX: 600 mH

•Channel Separation: 20 dB at 1KHz

Inhaltsverzeichnis

Andere Shure Mikrofon Handbücher

Shure

Shure 545SD Bedienungsanleitung

Shure

Shure Microflex MX200 Series Bedienungsanleitung

Shure

Shure MXCW Bedienungsanleitung

Shure

Shure WH10 Bedienungsanleitung

Shure

Shure MODULINK 810 Bedienungsanleitung

Shure

Shure Microflex MX400SE Series Bedienungsanleitung

Shure

Shure Ranger2 419A Bedienungsanleitung

Shure

Shure KSM44A Bedienungsanleitung

Shure

Shure SM58 Bedienungsanleitung

Shure

Shure DL4 DuraPlex Bedienungsanleitung

Shure

Shure PGA 52 Bedienungsanleitung

Shure

Shure SM90 Gebrauchsanweisung

Shure

Shure Microflex MX391 Series Bedienungsanleitung

Shure

Shure UNIDYNE 580SA Bedienungsanleitung

Shure

Shure 520DX Bedienungsanleitung

Shure

Shure 527B Bedienungsanleitung

Shure

Shure R96 Bedienungsanleitung

Shure

Shure VP83F Bedienungsanleitung

Shure

Shure KSM9 Bedienungsanleitung

Shure

Shure BETA 87C Bedienungsanleitung

Shure

Shure RS220 Bedienungsanleitung

Shure

Shure UNISPHERE 565SD Bedienungsanleitung

Shure

Shure SM10A Bedienungsanleitung

Shure

Shure ROSWELLITE KSM313 Bedienungsanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

Sony

Sony C-48 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

JLab

JLab GO TALK Bedienungsanleitung

Renkforce

Renkforce TY-109 Bedienungsanleitung

Trust

Trust 31008 Bedienungsanleitung