Shure Beta 98HC Bedienungsanleitung

Condenser Instrument

Microphone

Models Beta 98H/C and

WB98H/C User Guide

27B3102 (AE)

2001, Shure Incorporated Printed in Mexico

ENGLISH

GENERAL

The Shure BETA 98H/C is a premium cardioid condenser instrumental microphone that clamps onto the bell of wind

instruments or onto the rim of percussion instruments. The integrated gooseneck and ratcheting swivel joint allows the

microphone to be easily positioned and secured in place, and an isolation shock-mount reduces the transmission of

instrument “key noise” and other mechanical noise. A gooseneck angle brace is included to provide better retention

of the microphone placement during more active performances (see Figure 9 for application).

The BETA 98H/C features transformerless preamplifier circuitry, which improves linearity across the full frequency range.

The preamplifier is attached to the microphone via a 10-foot high-flex cable. The MX1–BP battery-powered preamplifier

is available as an optional accessory and provides exceptional performance in situations where phantom power is not

available.

The pickup pattern of the BETA 98H/C provides high gain-before-feedback and excellent rejection of unwanted noise.

Its high maximum sound pressure level (SPL) enables it to handle the extreme demands of brass, woodwind and

percussion instruments.

The microphone is supplied with a snap-on windscreen, a storage bag, a gooseneck angle brace, and a cable

management device. The preamplifier can be powered by any 11–52 Vdc phantom power supply.

ENGLISH

FEATURES

•

Tailored frequency response for open, natural sound reproduction

•

An isolation shock-mount reduces the transmission of instrument “key noise” and other mechanical noise

•

Adjustable gooseneck and ratcheting swivel joint allow for optimal microphone positioning

•

Gooseneck angle brace retains microphone placement in more active performances

•

Compact, lightweight construction provides a low degree of visibility

•

Designed for use in high SPL environments

•

Uniform cardioid pattern provides for high gain-before-feedback and excellent rejection of ambient sound

•

Interchangeable microphone cartridges with different pick-up patterns are available

•

Legendary Shure quality, ruggedness and reliability

MODEL VARIATIONS

BETA 98H/C includes microphone, 3 m (10 ft.) high-flex cable terminated to an inline preamplifier, two snap-on

windscreens, a gooseneck angle brace, and a cable management device.

WB98H/C includes microphone, 1.6 m (5.3 ft.) high-flex cable terminated to 4–pin mini connector (TA4F) for wireless

applications, two snap-on windscreens, a gooseneck angle brace, and a cable management device.

ENGLISH

APPLICATIONS AND PLACEMENT

The most common BETA 98H/C applications and placement techniques are described below. Keep in mind that micro-

phone technique is largely a matter of personal taste; there is no one “correct” microphone position.

SAXOPHONE(see Figure 4): Clamp the microphone onto the bell of the saxophone, so the microphone is a few inches

from and facing into the bell. This will produce a bright tonal balance while minimizing feedback and leakage.

SOPRANO SAXOPHONE (see Figure 5): Clamp the microphone onto the bell of the saxophone and adjust the gooseneck

so the microphone is facing the keys of the instrument, a few inches from the lower keys. This will produce a warm and

full tonal balance. For a brighter tone, adjust the gooseneck so the microphone is facing into the bell, a few inches away.

TROMBONE PLACEMENT (see Figure 6): Clamp the microphone onto the bell of the trombone and adjust the goose-

neck so the microphone is facing directly into the bell, a few inches away. This will produce a bright tonal balance while

providing maximum isolation.

TRUMPET PLACEMENT (see Figure 7): Clamp the microphone onto the bell of the trumpet and adjust the gooseneck

so the microphone is facing directly into the bell, a few inches away. This will produce a bright tonal balance while provid-

ing maximum isolation.

DRUM PLACEMENT (see Figure 8): Clamp the microphone onto the drum rim and adjust the gooseneck so the micro-

phone is aiming a few inches above the drum head and an inch from the rim. This provides a full tonal balance.

ENGLISH

SPECIFICATIONS WB98H/C Microphone (with standard test cir-

cuit shown in Figure 1) BETA 98H/C Microphone (with preamplifier)

Type Condenser (electret bias)

Polar Pattern Unidirectional (cardioid). See Figure 2.

Frequency Response 20 to 20,000 Hz. See Figure 3.

Output Impedance 1200 Rated at 150.0 (actual)

Recommended minimum load

impedance: 1 k

May be used with loads as low as 150 with re-

duced clipping level)

Output Level

(0 dB = 1 volt per Pascal) Open Circuit Voltage: –56.5 dB (1.5 mV) Open Circuit Voltage: -56 dB (1.6 mV)

Output Clipping Level

(at 1kHz, THD < 1%) -9 dBV (0.35 V) 2.5 kload 11 dBV (3.5 V). . . . . . . . . . . . . . . .

1.0 kload 3 dBV (1.4 V). . . . . . . . . . . . . . . . .

Maximum SPL 143.5 dB 2.5 kload 163 dB. . . . . . . . . . . . . . . . . . . . . . .

1.0 kload 155 dB. . . . . . . . . . . . . . . . . . . . . . .

ENGLISH

SPECIFICATIONS BETA 98H/C Microphone (with preamplifier)WB98H/C Microphone (with standard test cir-

cuit shown in Figure 1)

Dynamic Range (maximum SPL to

A-weighted noise level) 112.5 dB 132 dB (2.5 kload)

Output Noise (equivalent SPL) 31 dB typical, A-weighted

Signal-to-noise ratio 63 dB at 94 dB SPL (IEC 651)

Polarity Positive pressure on microphone diaphragm

produces positive voltage on pins 3 and 4 with

respect to pin 1 (ground).

Positive pressure on microphone diaphragm

produces positive voltage on pin 2 relative to

pin 3 of preamplifier output connector.

Recommended Operating Voltage 5 V (pin 2 to pins 3 and 4) 11 to 52 Vdc Phantom

Environmental Conditions Operating temperatures: –7°C to 49°C (20°F to 120°F). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Storage temperatures: –29°C to +74°C (–20°F to 165°F). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Relative Humidity: 0 to 95%. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Net Weight Microphone w/cable and 4–pin mini connector

(TA4F): 65 g (2.3 oz.) Microphone w/cable and 4–pin mini connector

(TA4F): 65 g (2.3 oz.)

Preamplifier: 96 g (3.4oz.)

ENGLISH

FIGURE 1

TYPICAL POLAR PATTERN

FIGURE 2

STANDARD TEST CIRCUIT

+–

1.0 F

431

20 K

100 K V Out

ENGLISH

TYPICAL FREQUENCY RESPONSE

FIGURE 3

1 cm (.4 in.)

61 cm (2 ft.)

ENGLISH

CERTIFICATION

The Beta 98H/C conforms to European EMC Directive 89/336/EEC, and is eligible to bear the CE marking. Meets

applicable tests and performance criteria in European standard EN 55103 (1996), parts 1 and 2, for residential (E1)

and light industrial (E2) environments. The WB98H/C conforms to European EMC Directive 89/33/EEC, and is

eligible to bear the CE marking. Meets EMC requirements as an ancillary device per EN 300 445 (1996).

REPLACEMENT PARTS

Preamplifier with 4–pin mini connector (TA4F) (for WB98H/C only) RPM626. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Preamplifier Assembly RPM440. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Clamp and gooseneck assembly (less cartridge, windscreen),

with 3 m (10 ft.) stripped and tinned cable RPM540. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Windscreen (4 per package) RK183WS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Cardioid cartridge RPM108. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Supercardioid cartridge RPM110. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Cable Management Device CMD–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Battery Powered Supply MX1–BP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Cable connector (for WB98H/C only) WA330. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Gooseneck Angle Brace 65A1963. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .