Shure Microflex MX400SE Series Bedienungsanleitung
© 2016 Shure Incorporated
27A14049 (Rev. 2)
WIRED MICROPHONE
MX400SE
USER GUIDE
MICROFLEX SERIES
Printed in U.S.A.
Le Guide de l’Utilisateur
Guia del Usuario
Guida dell’Utente
Bedienungsanleitung
取扱説明書
Manual do Usuário
3
MX400SE
Shure Microflex®MX400SE Series microphones are miniature goose-
neck-mounted electret condenser microphones designed primarily for
speech and vocal pickup. Their high sensitivity and broad frequency
range make them suitable for recording, as well as sound reinforcement
applications.
The MX400SE series can be screwed onto a mic stand or the supplied 5/8
in. 27-threaded flange. They can be easily changed from side exit to bot-
tom exit to conceal the cabling. All models include an in-line preamplifier,
a 3.66 m (12 ft.) cable.
• Wide dynamic range and frequency response for accurate sound
reproduction
• Interchangeable cartridges that provide a choice of polar pattern for
each application
• Shock mount provides over 20 dB of isolation from surface vibration
noise
• Snap-fit foam windscreen
• RF filtering
MX400 microphones are available with 305 mm (12 in.) or 457 mm (18 in.)
goosenecks, with or without a mute switch. They are available in supercar-
dioid, cardioid and omnidirectional polar patterns.
• "S" models include a mute button and LED.
• "D" models include a desktop base with programmable mute button and
LED and logic input and output.
• "SE" models feature a surface mount flange with side-exit cable.
The polar pattern of the included cartridge is indicated by a model number
suffix:
/C Cardioid
/S Supercardioid
/O Omnidirectional
/N Cartridge not included
Interchangeable Cartridges
Microflex microphones use interchangeable cartridges that allow you to
choose the polar pattern for different installations.
R183
R184
R185
Omnidirectional
Supercardioid
Cardioid
Cartridge Polar Patterns
Snap-Fit Windscreen
• Snap into the groove below the cartridge.
• To remove, spread the gap with a screwdriver or thumbnail.
• Provides 30 dB of "pop" protection.
Preamp Gain
If necessary, the preamplifier gain can be reduced by 12 dB. Contact an
authorized Shure service center for information.
R6 and R4
R13 and R16
Q8
Q9
Q2
Q6
Q1
Q5
Q3
D1
Q4
Q7
C10
C11
C6
C9
C3
C11
RFI Filtering
Important: Microphones must be used with the RK100PK and RK202PK
plate-mounted preamp to optimize RF immunity.
4
Microphone Placement
• Aim the microphone toward the desired source, such as the talker.
• Aim it away from any unwanted source, such as a loudspeaker.
• Place the microphone within 15 to 30cm (6 to 12 in.) of the desired
sound source.
• Always use the supplied windscreen or optional metal windscreen to
control breath noise.
• If four or more microphones will be open at the same time, use of
an automatic mixer, such as the Shure SCM810 or SCM410, is
recommended.
Permanent Installation
Flange
1. Drill a 22 mm (7/8 in.) diameter hole in the desired location.
2. Trace and drill three starter holes for the sup-
plied screws using the flange as a template.
3. Insert the preamplifier through the mounting flange.
4. Slip the mounting flange retaining ring over the bottom of
the preamplifier and slide it up until it is flush to the bot-
tom of the flange. Then press the ring firmly into place.
5. Secure the flange to the mounting surface with three screws.
flange
retaining ring
5
Shock Mount
1. Drill a 44mm(1-3/4 in.) diameter hole in desired mounting surface.
2. Mark and drill starter holes for screws, us-
ing shock mount as a template.
3. Secure shock mount to mounting surface with screws.
4. Thread the supplied adapter onto the MX400SE micro-
phphone before inserting it into the shock mount.
Specifications
Cartridge Type
Electret Condenser
Frequency Response
50 to 17000 Hz
Polar Pattern
MX412SE/C, MX418SE/C Cardioid
MX412SE/S, MX418SE/S Supercardioid
Output Impedance
180Ω
Output Configuration
Active Balanced
Sensitivity
@ 1 kHz, open circuit voltage
Cardioid –35 dBV/Pa(18 mV)
Supercardioid –34 dBV/Pa(21 mV)
1 Pa=94 dB SPL
Maximum SPL
1 kHz at 1% THD, 1 kΩ load
Cardioid 124 dB
Supercardioid 123 dB
Equivalent Output Noise
A-weighted
Cardioid 28 dB SPL
Supercardioid 27 dB SPL
Signal-to-Noise Ratio
Ref. 94 dB SPL at 1 kHz
Cardioid 66 dB
Supercardioid 68 dB
Dynamic Range
1 kΩ load, @ 1 kHz
96 dB
Common Mode Rejection
10 Hz to 100 kHz
45 dB, minimum
Preamplifier Output Clipping Level
at 1% THD
–6 dBV (0.5 V)
Polarity
Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of
output XLR connector
Environmental Conditions
Operating Temperature –18–57°C (0–135°F)
Storage Temperature –29–74°C (–20–165°F)
Relative Humidity 0–95%
Power Requirements
11–52 V DC, 2.0 mA
Cable
3.0 m (10 ft) , attached
6
Certifications
Meets essential requirements of all applicable European Directives.
Eligible for CE marking.
The CE Declaration of Conformity can be obtained from Shure
Incorporated or any of its European representatives. For contact informa-
tion please visit www.shure.com
The CE Declaration of Conformity can be obtained from: www.shure.com/
europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str. 12
75031 Eppingen, Germany
Phone: 49-7262-92 49 0
Fax: 49-7262-92 49 11 4
Email: [email protected]
9.14 mm
(0.36 in.)
MX412SE: 361.21 mm (14.221 in.)
MX418SE: 500.91 mm (19.721 in.)
19.56 mm
(0.77 in.)
48.6 mm
(1.9 in.)
8.4 mm
(0.33 in.)
11.68 mm
(0.46 in.)
31.8 mm
(1.252 in.)
4.5 mm
(.178 in.)
150o
120o
150o
120o
180o
30o
60o
90o
30o
60o
0
150o
120o
150o
120o
180o
30o
60o
30o
60o
–5 dB
0
90o
–5 dB
–10 dB
–15 dB
90o90o
500 1,000 2,000 5,000 10,000 20,000
50 100 20020
0
+10
–10
500 1,000 2,000 5,000 10,000 20,000
50 100 20020
0
+10
–10
500 1,000 2,000 5,000 10,00050 100 20020
0
+10
–10
250 Hz
500 Hz
1000 Hz
2500 Hz
6400 Hz
10000 Hz
250 Hz
500 Hz
1000 Hz
2500 Hz
6400 Hz
10000 Hz
250 Hz
500 Hz
1000 Hz
2500 Hz
6400 Hz
10000 Hz
150o
120o
150o
120o
180o
30o
60o
90o
30o
60o
0
150o
120o
150o
120o
180o
30o
60o
30o
60o
–10 dB
–15 dB
0
90o
–10 dB
–15 dB
–20 dB
90o
150o
120o
150o
120o
180
o
30o
60o
90o
30o
60o
0
90o
150o
120o
150o
120o
180
o
30o
60o
90o
30o
60o
0
–5 dB
–10 dB
–15 dB
90o
90o
20,000
–20 dB
–5 dB
–10 dB
–15 dB
–20 dB
–5 dB
–20 dB
–5 dB
–20 dB –20 dB
–15 dB
–10 dB
Hz
Hz
Hz
Andere Handbücher für Microflex MX400SE Series
5
Inhaltsverzeichnis
Andere Shure Mikrofon Handbücher
Shure
Shure KSM44 Bedienungsanleitung
Shure
Shure Unisphere I PE566 Bedienungsanleitung
Shure
Shure Microflex MX400S Bedienungsanleitung
Shure
Shure KSM42 Bedienungsanleitung
Shure
Shure WM98 Bedienungsanleitung
Shure
Shure AM8T Bedienungsanleitung
Shure
Shure KSM32 Bedienungsanleitung
Shure
Shure 545SD Bedienungsanleitung
Shure
Shure BETA 91A Bedienungsanleitung
Shure
Shure CVB Bedienerhandbuch
Shure
Shure KSM42 Bedienungsanleitung
Shure
Shure ROSWELLITE KSM313 Bedienungsanleitung
Shure
Shure MV88+ Bedienungsanleitung
Shure
Shure UNISPHERE 565SD Bedienungsanleitung
Shure
Shure SM12A Bedienungsanleitung
Shure
Shure A88SM Bedienungsanleitung
Shure
Shure MX150/C Bedienungsanleitung
Shure
Shure 275SK Bedienungsanleitung
Shure
Shure SV100 Bedienungsanleitung
Shure
Shure Easyflex EZG/12 Bedienungsanleitung
Beliebte Mikrofon Handbücher anderer Marken
IK Multimedia
IK Multimedia iRig Stream MIC PRO Bedienungsanleitung
DAPAudio
DAPAudio RM-101 Bedienungsanleitung
AKG
AKG CHM 21 Bedienungsanleitung
Sennheiser
Sennheiser evolution wireless series EM 100 Bedienungsanleitung
Sony
Sony C-48 Bedienungsanleitung
GIGAMEDIA
GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung
