9 10
9.Admin Card Operation
9.1 Add Card
10.User Operation
11 Other Operation
11.1 Remove Alarm
8.2 Reader Mode Settings
11.2 Reset to Factory Default
Change the user code by ID number
Change the user code by card
Note：
When the alarm is activated, user can remove the alarm by reading a valid card or pressing
valid admin code .
Note：
The default code “1234” of matching card can’t open the door unless revising other
codes.
Note：
ID number has to be known from admin before changing the code, user code can’t be
default code “1234”.
Note:
Registered user data won’t be deleted when reset to factory default.
Users can reset to the factory default when the admin code is forgotten, or tthe default settings
have been modified, operation as below:
Power off, press and hold the # key or the exit button continuously, power on, release the # key
or the exit button until hearing beep sound twice, the admin code has been reset to 999999,
factory default settings are successful.
Enter programming Menu Operation steps Description Default
value
Press * Admin
code #
(Default admin
code is "999999")
New admin code #
new admin code # Change admin code
Set device number
Wiegand output：26-58 bits
Keypad transmission format 4 bits
Keypad transmission format 8 bits
Virtual card number output
(0-255)#
(26-58)#
0#
1#
2#
Read card Old code # New code # New code #
#
Press
ID number Old code # New code # New code #
Press
9.2 Delete Card
Note：
The delete card is used to delete card users continuously and quickly. When you read the
admin delete card at the first time, you will hear short "BEEP" sounds twice and the indicator
light turns orange, it means you have entered into delete user programming, when you read the
admin delete card at the second time, you will hear long "BEEP" sound once, the indicator light
turns red, it means you have exited the delete user programming.
Read admin delete card Read the 1
st
user card Read the 2
nd
user card Read admin delete card
…
Note：
The add card is used to add card users continuously and quickly. When you read the
admin add card at the first time, you will hear short "BEEP" sounds twice and the indicator light
turns orange, it means you have entered into add user programming, when you read the admin
add card at the second time, you will hear long "BEEP" sound once and the indicator light turns
red, it means you have exited the add user programming.
Read admin add card Read the 1
st
user card Read the 2
nd
user card Read admin add card
…
00
51
52
53
0
Disable the keypad backlight
Enable the keypad backlight
Time of keypad backlight: 2-99 sec
Disable buzzer
0#
1#
(2-99)#
0#
63
64
1
1
0
Alarming time range: 1-99 min
Alarming time sets 0S, means no alarm
(1-99)#
0#
42 0
Reader mode
Standalone access control mode
Relay toggle mode
0#
1#
2#
Enable light indicator
Disable light indicator
1#
0#
62 1
03 1
999999
26
10.1 Change the User Code
Read admin card Read valid user card Press admin codeor or #
