Siemens SMS-S Bedienungsanleitung

Siemens Building Technologies

Fire Safety

P/N 315-033200C-5

INTRODUCTION The Model SMS-S Manual Station from Siemens

Building Technologies, Inc. is an addressable device

containing advanced control panel communication

technology. This technology, which provides two-

direction communication with the control panel,

produces an Intelligent Initiating Device. The SMS-S

is single action.

PROGRAMMING Refer to Figure 1 to locate the opening on the SMS cover that allows access to the

programming holes which are on the SMS printed circuit board.

To connect the SMS to the SDPU Programmer/Tester, insert the plug from the SDPU

cable provided with the Programmer/Tester into the opening on the SMS as shown

in Figure 2. Because SMS devices are polarity insensi-

tive, the programming plug can be inserted into the

programming holes in either direction.

To prevent potential damage to the SDPU DO NOT

connect an SMS to the SDPU until at least one wire is

removed from terminals 1 or 2 of the SMS.

Follow the instructions in the SDPU Manual

(P/N 315-033260C) to program the SMS to the desired

address. Record the device address on the label

located on the SMS front panel. The SMS can now

be installed and wired to the system.

OPERATION The SMS-S manual station operates with the FS-250C Control Panel via the FDLC

Device Loop Card.

The SMS-S manual station housing has a pull down lever that locks in position after

releasing a spring loaded switch. (See Figure 4.) To indicate the manual station is

activated, the pull down lever remains down and locked until the station is physically

reset.

The SMS-S is reset by opening the hinged housing cover with an Allen key and then

closing and locking the cover.

Figure 1

SMS Cover

Single Action Manual Station

Installation Instructions

Models SMS-S

OPENING TO

PROGRAMMING

POINTS

PLUG FROM

SDPU

LOCATING TAB

PROGRAMMING

POINTS

Figure 2

Connecting the SDPU Plug

INSTRUCTIONS

WIRING

INSTALLATION Distribute the manual station boxes throughout the protected area so that they

are unobstructed, readily accessible, and located in the normal exit path. Place the

manual station according to the regulations of the authorities having jurisdiction.

Surface Mounting Mount the backplate to a Model MC-5 Backbox as shown in Figure 4.

Flush Mounting Mount the backplate to a user supplied single gang switchbox.

Do not overtighten the screws. Overtightening may distort the backplate.

Figure 3

Wiring Information

TO NEXT ADDRESSABLE DEVICE

LINE 1

LINE 2

EARTH GROUND

FROM INITIATING CONTROL PANEL

OR PREVIOUS ADDRESSABLE DEVICE

NOTES:

1. Recommended wire sizes:

18 AWG minimum, 14 AWG maximum

2. Wire larger than 14 AWG can damage the connector.

3. When using shielded cable without metal raceway or with nonmetallic

raceway, the shields should be terminated at the device ground

terminal. If the device box is already grounded by another means, such as

being mounted to a grounded structure, the wire shields should be

continuous and must be grounded solely at the point of origin; for

example, at the control panel.

4. When using shielded cable with metal raceway, the wiring shields shall

be continuous and grounded solely at the point of origin.The device

ground terminal shall be connected to the grounded device box.

5. When using metal raceway without shielded cable, connect the device

ground terminal to the grounded device box.

6. Metal raceway should be thoroughly grounded throughout the system.

7. CX-2 Addressable Device Loop ratings:

Voltage: 31V max.

18V min. (pulsing)

Current maximum: 1mA

8. The SMS-S is a polarity insensitive device. Line 1 and Line 2 can be either

line of the FDLC or loop.

Siemens Building Technologies

Fire Safety

P/N 315-033200C-5

3½ INCH DEEP

SWITCH BOX

(USER SUPPLIED)

MODEL

MC-5

BACKPLATE

SURFACE

MOUNTING

ENCLOSURE

FLUSH

MOUNTING

ENCLOSURE

HOUSING HINGED

TO BACKPLATE

HOUSING

LOCKING

SCREW

5½ in.

3 in.

4 in.

2¾ in.

3½ in.

NAMEPLATE

Figure 4

Mounting The SMS

Siemens Building Technologies, Ltd.

2185 Derry Road West

Mississauga, Ontario L5N 7A6 Canada

Andere Siemens Controller Handbücher

Siemens

Siemens Simatic S7-300 Bedienungsanleitung

Siemens

Siemens IQHeat Bedienungsanleitung

Siemens

Siemens 6MD85 Bedienungsanleitung

Siemens

Siemens SIMATIC NET SCALANCE WLC711 Bedienungsanleitung

Siemens

Siemens SINAMICS S120 Technisches Dokument

Siemens

Siemens ST950ELV Bedienungsanleitung

Siemens

Siemens SIMOVERT MASTERDRIVES SBP Bedienungsanleitung

Siemens

Siemens SIRIUS 3RW44 Benutzerhandbuch

Siemens

Siemens SQM5 Series Betriebsanleitung

Siemens

Siemens LOGO! Bedienungsanleitung

Siemens

Siemens QPA84 Bedienungsanleitung

Siemens

Siemens RAJA+ 3TE7111-2SC18-1A Series Leitfaden

Siemens

Siemens SIMATIC S7-200 Bedienungsanleitung

Siemens

Siemens AEROGYR RWI65.01 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Siemens

Siemens SIMATIC NET CP 1613 A2 Bedienungsanleitung

Siemens

Siemens SIMATIC S7-1200 Benutzerhandbuch

Siemens

Siemens GXD 31.1 Series Bedienungsanleitung

Siemens

Siemens S7-1200 TELECONTROL Bedienungsanleitung

Siemens

Siemens SSC161.05UT Bedienungsanleitung

Siemens

Siemens LMV37.4 Series Bedienerhandbuch

Siemens

Siemens SIRIUS M200D Bedienungsanleitung

Siemens

Siemens instabus JB520C23 Bedienungsanleitung

Siemens

Siemens LMV37.4 Series Bedienerhandbuch

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung

3M MicroTouch EX113 Bedienungsanleitung

KUHN

KUHN TKS Bedienungsanleitung

S&C

S&C PMH Bedienungs- und Wartungshandbuch

Regin

Regin CORRIGO L10 Bedienungsanleitung