Page 2 64-309-48_004-Manual-A-Comfort_RevGR1.5-ENG-CH.doc
www.EcoStarter.com
For a complete understanding of the product, and before initiating any connection,
it is important to entirely read through the instructions.
The following MUST be read and done to get started:
Chapter 1 / page 3: Installation and configuration:
- About your SIM card (and inserting it correctly)
- Installation, connection to the power source
- Mobile network coverage
- “Identification” of keyboard, wireless sockets,
temperature sensors, etc.
- Input of mobile phone numbers to which
A-Comfort will send alarm and status messages.
Chapter 4 / page 16: SMS control (for remote control of A-Comfort):
-Turn switches on/off (e.g. for stoves)
-Turn alarm on/off
-Get status message from A-Comfort
During the setup procedure, you will be led through a number of steps that are further
explained in other chapters (e.g., several menus described in Chapter 2, as well as SMS
control in Chapter 4).
Terms and Notions Used in this Manual
Input panel: The keyboard on the A-Comfort central unit.
Keyboard: Small wireless remote control for on-site usage.
Node: Plug-in wireless 230V socket for controlling electric current and
connecting sensors.
Inputs: Inputs 1 and 2 on the underside of the wireless socket (node).
Menu 1.7: (example) Menus are organized hierarchically. The example “Menu 1.7” refers
to Main menu 1, Sub-menu 7.
PIR: “Passive InfraRed Sensor”, usually called
IR sensor
or
motion
detector
.
Registration: Operation by which a wireless accessory or extension is identified
for the first time by the central unit it will depend on.
Temperature surveillance: A function where A-Comfort sends you a message if the
temperature falls down to e.g. 4°C or raises up to e.g. 20°C.
Requires a temperature sensor to be connected to input 1 of your
node.
Thermostatic control
(T-Control): With a temperature sensor connected to input 1 of your node, and a
stove or radiator plugged into the socket, the built-in thermostatic
regulation allows you to choose between comfort temperature and
eco-temperature.
Personal code A 4-digit password (factory-set to
1234)
that A-Comfort requires
in all SMS commands, and in certain commands executed locally.
Not to be confused with the PIN code (of the SIM card), which, in
contrast, has to be deactivated!
