6
Replace the safety fuse
Before making the replacement disconnect the appli-
ance from the mains power supply.
The fuse compartment is close to the mains power con-
nector (Fig. 3). Use a slotted screwdriver to remove the fuse
carrier (2) and replace the fuse (3). Insert a new spare fuse
(4). Use only T 5A H fuses.
Fig.3
• Beware of power supply cables.
Position the power supply cables so that they do not consti-
tute an obstruction. Position the power supply cables where
they cannot be reached by children. Install the units as
close as possible to the wall electrical socket outlet.
Do not tread on the power cables, make sure that they
are not tangled or pulled; do not expose the power cables
to heat sources; make sure that the power cables do not
become knotted or kinked. If the power cables become
damaged, stop using the system and request the assistan-
ce of an authorised technician.
• Disconnect the apparatus from the mains power supply
in the event of electrical storms and when not in use.
To avoid damage that could be caused by lightning striking
in the vicinity of your home, disconnect the unit in the event
of electrical storms or when the system will remain unused
for prolonged periods.
• Avoid contact with liquids and exposure to humidity.
Do not use the unit near water (sinks, tanks, etc.); do not
place objects containing liquids on top of or near the unit
and do not expose them to rain, humidity, dripping water
or spray; do not use water or liquid detergents to clean the
unit.
• Prevent the unit from overheating.
In order to allow the Projector cooling, keep at least 40 cm
( 16”) of space between the rear of the projector and the
nearest wall or obstruction. Do not place the devices near
heat sources such as heaters, radiators or other devices
that generate heat (including amplifiers).
Do not obstruct ventilation openings.
Do not place the unit in confined, poorly ventilated positions
(bookcases, shelves, etc.).
• Do not expose the eyes to the intense light emitted by
the lamp.
Never look directly at the lamp through the ventilation
opening when the unit is switched on.
Risk of eyesight impairment. Ensure also that children do
not look directly at the lamp.
• Beware of the lens movements
Avoid positioning objects close the lens. The movements
( horizontal and vetical) could be obstructed by objects,
or damage may arise from the fall of the objects.
• Position the unit on a stable surface.
To avoid serious injury to persons and damage to property,
make sure the units are placed on a level, flat and stable
surface from which they cannot fall, tip over or slide. Pay
special attention if the units are placed on a trolley so that
they can be moved around. Ensure that the units are not
subjected to impact.
•
Do not insert objects through the unit openings.
Make sure that no objects are inserted inside the units. If this
should occur, disconnect the unit from the power supply
immediately and call an authorised technician.
• Energy Saving
When the system is left idle for a long period disconnect
the Projector from the main power supply.
This precaution allows to save energy and to prevent wear
and tear of the electronics devices.
