5
SimpliFire • SF-INC36 Service Manual • 4200-960 • 8/23
LED LIGHT HARNESS
(WHITE/BLUE/RED/BROWN)
JUNCTION BOX (BLUE/PURPLE) AC POWER CORD
(TO JUNCTION BOX RECEPTACLE)
12VDC POWER SUPPLY
(YELLOW/BLACK)
SNAP IN-PLACE
BECM
Figure 3.5 ACM Wiring
1. Follow the REMOVAL step from 3.1, to remove the
Decorative Front.
2. Remove logs, Refractory, Ember Media, and orange
light lter from Ember tray.
3. From the underside of the Display Bracket Shelf,
bend the two tabs securing Ember tray straight
downward. See Figure 3.6.
4. Lift the Ember Tray/Grate assembly up and away
from the display bracket.
3. Remove the LED Light Bar, lifting up to disengage
Hook/Loop fastener.
4. Replace the self-adhesive Hook/Loop to the replace-
ment LED Light Bar, reconnect and position the re-
placement LED Light Bar
3.3.3. Grate Replacement
1. Follow the removal steps through 3.3 to remove the
ember tray and gain access to the underside of the
ember tray.
2. Remove the two Phillips screws securing the Grate to
the Ember Tray. See Figure 3.6.
3. Install replacement grate by reinstalling the removed
Phillips screws.
4. Reassemble the appliance by following all the per-
formed REMOVAL steps in reverse.
3.3.4. Log Replacement Refractory Replacement
Ember Media Replacement
1. Follow the Refractory, Media and Log placement in-
structions found in the appliance installation manual.
Replacement
1. To replace the Ember Tray, remove the grate from
the existing tray assembly, by removing two Phillips
screws from the underside of the Ember Tray. Retain
and reuse the screws to secure the Grate to the re-
placement Ember Tray.
2. Ensure the tabs of the replacement ember tray are
bent down vertically to make it possible to position
them through the slots in the Display Bracket Shelf
3. Secure by bending the tabs 90° and ush with the un-
derside of the Display Bracket Shelf.
3.3.1. Fuel Bed Light Filter
1. If replacing the bottom fuel bed light lter, set the new
lter in place on top of the ember tray before reinstall-
ing the ember tray, media, and logs.
Removal
3.2.5. USB A to B, DC Cable Replacement
1. After the Decorative front has been removed, following
the Removal Steps in 3.1, the USB-A to USB-B cable
and the DC male to DC male cable between the BECM
and the computer are fully accessible and may be re-
placed.
Figure 3.6
3.3.2. Fuel Bed LED Replacement
1. Follow the removal steps through 3.3 to remove the
ember tray and gain access to the fuel Bed LED
2. Disconnect the White/Blue/Red/Brown 4-Wire LED
harness from the LED light bar.
3.3. Logs, Media, Refractory, and Ember Tray
Removal/Replacement
