Simrad PI32 Bedienungsanleitung

PI32 Bottom sensor attachment

Contact -

bottom sensors can detect bottom contact with a precision of just a few centimeters when

correct stay and detection chain lengths are used. Optimal sensor performance requires that these

lengths are configured with regard to both each other and the gear in use (the standard delivery

includes a 63 cm stay and 39 cm detection chain for use with 14 to 16 inch bobbins or rock hoppers).

Configuration -

the desired bottom detection distance is relative to the diameter of

the rock hoppers, bobbins or other gear in use. This relationship can be determined

and precise stay and detection chain length adjustments made as described below.

Setup

- lay the bottom sensor on an elevated surface and observe detection wire movement while

simulating bottom contact by raising the weight. Adjust the detection chain length as necessary. Tilt the

weight approximately 25°(

is due to drag through the water) opposite the towed direction and adjust

the stay length so that it begins to be taught. Avoid extra links at the weight ends when shorting chains.

IMPORTANT: Weights must be removed from a bottom sensors with a long stays and detection

chains before they transit the drum when hauling to prevent damage.

To attach a PI32 Bottom sensor:

1.) Locate the middle of the footrope and bend the attachment ring for the stay to the “bottom” and

two strops attached to karabiners on either side to its “top”. The strops should create a bridle about

15 to 20 cm in length that will securely hold the bottom sensor in a stable position.

2.) Bend the penetration ring for the detection wire about 30 cm below the footrope as illustrated.

Attach the bottom sensor and check that its feeler strap passes through the centre of the penetration

ring. Remove the netting on the inside of the penetration ring.

3.) Attach the rubber strops so that the bottom sensor is held horizontally when towed.

IMPORTANT: Carefully attach the sensor to the inside of the trawl so that it is not subject to

damage or torn off during fishing operations. The sensor’s feeler strap must always be allowed to

pass freely through the centre of the penetration ring when it is deployed.

Rock hopper,

bobbins, etc.

Attachment ring for the

stay bent securely to the

“bottom”of the footrope.

Karabiners are bent securely to the “top” of the footrope. If the bottom sensor is

attached to the wings, the length of the lashings must be adjusted so that the sensor

points toward the mother vessel when towed.

Penetration ring for

the feeler strap.

Weight and stay hang

freely under the trawl.

30 cm

Touch Down

Feeler strap

Detection

chain

Weight

Lift Off

Stay

Rock hopper

Bottom

End link

(851-164641B)

Note 1

Note 1:

The stay can also be attached to the steel spacer between the bobbins/rock

hopper if the footrope is held fairly stable relative to the gear.

Andere Handbücher für PI32

Inhaltsverzeichnis

Andere Simrad Schiffsausrüstung Handbücher

Simrad

Simrad IS42J Bedienungsanleitung

Simrad

Simrad TP10 Bedienungsanleitung

Simrad

Simrad MS70 Bedienungsanleitung

Simrad

Simrad Pump-1 Bedienungsanleitung

Simrad

Simrad GO XSE Series Bedienungsanleitung

Simrad

Simrad ES60 - REFERENCE MANUAL REV H Bedienungsanleitung

Simrad

Simrad AP70 MK2 Bedienungsanleitung

Simrad

Simrad IS20 Wind Bedienungsanleitung

Simrad

Simrad NSS9 evo3S Bedienungsanleitung

Simrad

Simrad SX90 - DATASHEET FOR NAVAL AND COAST GUARD REV... Bedienungsanleitung

Simrad

Simrad ITI TRAWL SYSTEM - SERIAL DATA COMMUNICATION REV... Bedienungsanleitung

Simrad

Simrad EK80 Bedienungsanleitung

Simrad

Simrad ES70 - DOWNLOAD AND INSTALLATION REV B Bedienungsanleitung

Simrad

Simrad EY500 Bedienungsanleitung

Simrad

Simrad BoatConnect Bedienungsanleitung

Simrad

Simrad ES60 - DATASHEET REV A Bedienungsanleitung

Simrad

Simrad CR40 MKII Bedienungsanleitung

Simrad

Simrad Maris ECDIS900 Bedienungsanleitung

Simrad

Simrad AP48 Bedienungsanleitung

Simrad

Simrad SD1 Bedienungs- und Wartungsanleitung

Simrad

Simrad S3009 Bedienungsanleitung

Simrad

Simrad EQ33-2 Bedienungsanleitung

Simrad

Simrad PI HBU - REV A Bedienungsanleitung

Simrad

Simrad NSO evo3S MPU Bedienungsanleitung

Beliebte Schiffsausrüstung Handbücher anderer Marken

Clarion

Clarion CMS2 Reparaturanleitung

EBS

EBS M7000 Bedienungsanleitung

Kongsberg

Kongsberg M3 Bathy Bedienungsanleitung

NPK

NPK SCS-1002 Bedienungsanleitung

Furuno

Furuno FE-800 Bedienungsanleitung

Harken

Harken 1561 Bedienungsanleitung

Notifier

Notifier FS-BSO Bedienungsanleitung

Raymarine

Raymarine ST40 Bedienungsanleitung

E2S

E2S E2XS112UL Bedienungsanleitung

R2Sonic

R2Sonic 2026 Bedienungsanleitung

COBHAM

COBHAM SAILOR 6000 Bedienungsanleitung

Clarion

Clarion GR10BT Reparaturanleitung

Raymarine

Raymarine Maxiview ST80 Benutzerhandbuch

GUIDANCE MARINE

GUIDANCE MARINE 20- Series Montageanleitung

Raymarine

Raymarine ST60 Tridata Benutzerhandbuch

olympia electronics

olympia electronics ΒS-531/1/MAR Bedienungsanleitung

Sonic

Sonic 2024 Bedienungsanleitung

Quicksilver

Quicksilver 88688A25 Handbuch