Sinclair ASH-24CN Bedienungsanleitung
AIR CONDITIONER
Internet: http://www.sinclair-eu.com
E-mail: info@sinclair-eu.com
SPLIT AIR CONDITIONER WALL MOUNTED MODEL SINCLAIR
OWNER‘S MANUAL
ASH-24CN
NATURE SERIE
Before operating the unit please
carefully read this manual.
-- 1 --
1
WARNING
The power plug must be in-
serted tightly.
Otherwise, it can cause an electric
shock, overheating or fire.The
ground must be connected.
for the security of the air condi-
tioner, it should be safely connected
to earth.
The line that be connected to the
earth of the outdoor unit should be
connected correctedly and tightly.
Theinstructionsbeforeuse
Don’t pull out the power plug
during operation.
It can cause an electric shock
or fire.
Never splice the power cord or
use an extended cord.
It can cause overheating or fire.
Don’t use longer power lines
and don’t share a same socket
with other electric appliances.
It can cause an electric shock or
fife.
Don’t operate the Air condi-
tioner with wet hands.
It can cause an electric shock .
Don’t insert your hands or
stick into the air intake or
outlet vents.
It can cause danger.
danger
Don’t apply the cold wind to
the body for a longtime.
It cause the physical condition
deferioration and health prob-
lems.
When having a burning smell
or smoke, please turn off the
power supply and contact with
the Service center.
Don’t attempt to repair the
air conditioner by yourself.
You may cause further malfunc-
tions.
cut off the
power
Don’t connect
to gas or
Lighting
telephone
lines.
the earth wire
water pipes.
rods or
earth
66162002 6 02 11 30 10 241
2
Don’t use any other fuse ex-
cluding the fuse of correct
capacity.
Improper wire could cause the
breaking down or fire.
Be sure to pull out the power
plug as the Air Conditioner
will not be used for a longtime.
When cleaning, it is neces-
sary to stop driving and turn
off the power suply.
It occasionally cause the elec-
tric shock.
Don’t pull the power cord to
pull out the power plug.
It can cause fire.
Don’t place a space heater
near the air conditioner.
Air flow from the air conditioner
can cause incomplete combus-
tion to the space heater.
Keep combustible spray away
from the units.
It is likely to ignite and explore.
Please note whether the in-
stalled stand is firm enough
or not.
It leads to the falling of the unit
which causes the injury etc. oc-
casionally.
Don’t step on the top of the
outdoor unit. As falling off the
outdoor unit can be dangerous.
Don’t block the air intake or
outlet vents of both the out-
door and indoor units.
It can decrease the air condition-
ing capacity or cause a mal-func-
tion.
wire
66162002 6 02 11 30 10 242
-- 3 --
3
Name and function of each part
Indoorunit
Outdoor unit
Airin
Air out
Air in
Air out
Surface panel
Air cleaner
Air Filter A
Air Filter B
Wiring cover
Handling switch
Power line
Drain hose
Air outlet grille
Louver
Wireless remote
controller
Operation
Timer
Operation indicator (red) lights up when the unit is on, and flashes
when the unit is defrosting.
11
66162002 6 02 11 30 10 243
4
Name and Function-Remote control
COOL mode
DRY mode
FAN mode
HEAT mode
AUTO
Remote control operation procedure
Note:
Be sure that there are no obstructions between reciever and remote controller.
The remote control signal can be received at the distance of up to about 10m.
Don’t drop or throw the remote control.
Don’t let any liquid in the remote controller and put the remote controller
directly under the sunlight or any place where is very hot.
SWING button
When it is pressed, the
louvers start to rotate
automatically and stop
when repressed.
TEMP.button
SET TEMP.increases 1oC
by pressing button once,
and decreases 1oC by press-
ing button once.
At COOL mode operation,
SET TEMP. can be selected
from16oCto 30oC.
At DRY mode operation,
SET TEMP. can be selected
from16oCto30oC
At HEAT mode operation,
SET TEMP. can be selected
from16oCto 30oC.
MODE button
Press this button to
change the operation
mode in order of
FAN button
Presse this button to
change the fan speed of:
AUTO FAN
1/0 button
Press this button to turn
on or turn off the unit.
1/0
66162002 6 02 11 30 10 244
-- 5 --
5
Liquid crystal displayer
It shows all set contents.
SLEEPbutton
Press this button to set
SLEEP operation. and
stop when repressed
TIMER OFF button
At operating, press TIMER
OFF button, set OFF
TIME in range of 0 to 24
hour to stop the unit auto-
matically.
Name and Function-Remote control .(Remove the cover)
This type of remote controller is a kind of new current controller. some
buttons of the controller which are not available to this Air conditioner
will not be described below.
Operate on unmentioned buttons would not impact on the normal use.
1/0
Note:
0- 24h
Timer
cancellation
TIMER ON button
At stopping, press TIME ON but-
ton, set ON TIME in range of 0 to
24 hour at the interral of 0.5h to
start the unit automatically.
0- 24h
Timer
cancellation
66162002 6 02 11 30 10 245
6
4. Press FAN button, set fan
speed.
3. PressSWING button, the
louvers start to rotate au-
tomatically,and stopwhen
repressed.
5. Press TEMP. button, set
suitable SET TEMP.
2. Press MODE button, set
operation mode.
1. Plug in, press 1/0 button, then
air conditioner is turned on.
COOL mode operation procedure
1/0
Accordingtodifferencebetweenroomtemp.andsettemp.,microcomputercancontrolcool-
ing on or not.
If room temp. is higher than set temp. , compressor runs at COOL mode.
If room temp. is lower than set temp., compressor stops and only indoor fan motor runs.
SET TEMP. should be in range of 16oC to 30oC.
66162002 6 02 11 30 10 246
-- 7 --
7
HEAT mode operation procedure
3.Press SWING button, the
louvers start to rotate auto-
matically, and stop when re-
press it.
4.Press FAN button, set fan
speed.
5.Press TEMP. button, set
suitable SET TEMP.
1.Plug in, press 1/0 button,
then air conditioner is turned
on.
2.Press MODE button, set
operation mode.
1/0
If room temp. is lower than set temp. , compressor runs at HEAT mode;
If room temp. is higher than set temp., compressor and outdoor fan motor stop, only indoor
fan motor runs, louver motor makes the louvers horizontal, after about one minute, indoor
fan motor will stop .
SET TEMP. should be in range of 16oC to 30oC.
When the unit (cool only) recieved the con-
trol signal which is used under the heat mode,
it will operate according to the FAN mode.
66162002 6 02 11 30 10 247
8
DRY mode operation procedure
Ifroomtemp.is lower thansettemp. ,compressor,outdoorand indoorfanmotor stop. If
room temp. is between 2oC of set temp., Air conditioner is drying. If room temp. is
higher than set temp., it’s at COOL mode.
SET TEMP. should be in range of 16oC to 30oC.
3. PressSWING button, the
louvers start to rotate au-
tomatically, and stop
when repress it.
4. Press TEMP. button, set
suitable SETTEMP.
2. Press MODE button, set
operation mode.
Air speed couldn’t be
changed after the “ ”
being set.
1. Plug in, press 1/0 button,
then air conditioner is
turned on.
1/0
66162002 6 02 11 30 10 248
-- 9 --
9
AUTO mode operation procedure
UnderAutomode operation,standardSETTEMP.is25oCforCOOLmodeand20oCfor
HEAT mode .
1. Plug in, Press 1/0 button, then
air conditioner is turned on.
2. According to room temp., mi-
crocomputer can automatically set
operation mode, so
as for best effect.
1/0
66162002 6 02 11 30 10 249
Inhaltsverzeichnis
Andere Sinclair Klimaanlage Handbücher
Sinclair
Sinclair ASH-09AIE2 Bedienungsanleitung
Sinclair
Sinclair SDV5 SDV5-100EAS Bedienungsanleitung
Sinclair
Sinclair ZOOM Series Bedienungsanleitung
Sinclair
Sinclair ASH-09AISR SYMPHONY SERIES Bedienungsanleitung
Sinclair
Sinclair ASF-60AN Bedienungsanleitung
Sinclair
Sinclair Spectrum Series Bedienungsanleitung
Sinclair
Sinclair ASC-24BI Bedienungsanleitung
Sinclair
Sinclair ASC-18BI Bedienungsanleitung
Sinclair
Sinclair MS-H07AICN PT Bedienungsanleitung
Sinclair
Sinclair AST-24BI Bedienungsanleitung
Sinclair
Sinclair SF-C4M Series Bedienungsanleitung
Sinclair
Sinclair MS-E48AIN Bedienungsanleitung
Sinclair
Sinclair ASH-09AF Kurzanleitung
Sinclair
Sinclair ELEMENT Series Bedienungsanleitung
Sinclair
Sinclair SYMPHONY MS-H09AISW PT Bedienungsanleitung
Sinclair
Sinclair MV-PBI Series Bedienungsanleitung
Sinclair
Sinclair MC-C24AI Bedienungsanleitung
Sinclair
Sinclair MS-H07AIC PT Bedienungsanleitung
Sinclair
Sinclair MULTI SYSTEM SERIES Bedienungsanleitung
Sinclair
Sinclair ASH-09AP Bedienungsanleitung
