Sinclair MULTI SYSTEM SERIES Bedienungsanleitung

USER'S MANUAL

AMC-12AN

MOBILE SERIES

...............................................

.......................................

..................................

.............................................

............................................

...........................................

....................

16-17

........................................

4-7

8-10

...........

CONTENTS

SUMMARY

WORKING PRINCIPLE

MODEL AND SPECIFICATIONS

STRUCTURE

OPERATING METHODS

NAMES AND FUNCTIONS OF THE REMOTE CONTROLLER

CARE AND MAINTENANCE

TROUBLE SHOOTING

USER NOTICES

AFTER SERVICE

.................................

....................................

OPE RATION OF THE REMOTE CONTROLLER

11-12

........

13-15

ACCESSORIES AND INSTALLATION OF HEAT EXHAUST HOSE

. .........................................

CIRCUIT DIAGRAM

－2－

SUMMARY

－1－

SINCLAIR MOBILE AIR CONDITIONER is a small, moveable air conditioner. It possess the

functions of COOL, DRY and the Separate Ventilation, and depends on different places, it

can be moved as will. It is fit for home and office use, especially fit for the house with many rooms.

With the compact configuration, excellent workmanship, elegant appearance, it is convenient for moving,

energy saving, and low noise.

Note: Please read this manual carefully before operating the unit, the manual is used for reference,

and the technical parameters are subject to change without notice.

WORKING PRINCIPLE

With the help of upper motor, the airflow of indoor passes through the evaporator becomes the

cooling wind, but with the help of lower motor, the airflow of indoor passes through the condenser

becomes the heating wind. It was designed two duct systems in its structure The heating wind is discharged

by the rear outlet, the cooling wind is discharged by the front outlet, flow-guided by the louver, and it

brings the gentle cooling airflow, and the low temperature environment is maintained.

The Working Principle

Cooling wind

Upper

motor

Lower

motor

Evaporator

Airflow 1

Airflow 2

Capillary

Heating wind

Condenser

sledoM

)W( yticapac gnilooC

egatlov detaR

ycneuqerf detaR

)A( tnerruc tupni gnitaeH/gnilooc .xaM

Max.cooling/Heating input Power(W)

m( wolfriA

)h/

tnuoma egrahc dna tnaregirfeR

)Bd()teltuo ria looc()sserp dnuos( esioN

)g k( ).W.N( thgieW

H( noisnemiD ×

)mm( )D

)W( yticapac gnitaeH

042-022 V~

zH05

AMC-12AN

3500

6/--

7/--

1400/--

1550/--

450

R410A 800g

840X500X450

－2－

SPECIFICATION

4. Noise is tested 1m in front of front air outlet vent under cool air state, it is sound press grade.

5. Please refer performance parameter on nameplate as standard. The design are subject to be changed without notice.

3. Max. cooling input power is tested under cooling mode when indoor temp. dry bulb 35℃and wet bulb 24℃.

Note: 1. Cooling capacity is tested when indoor temp. dry bulb 35℃and wet bulb 24℃(indoor outside is the

2. Heating capacity is tected when indoor temp. dry bulb 20℃and wet bulb 15℃.

same) with air outlet pipe min Length.

Cooling/Heating rated current(A)

Cooling/Heating rated power(W)

Max.heating input power is tested under heating mode when indoor temp. dry bulb 27℃and wet bulb 25℃.

－3－

STRUCTURE

Front

Rear

Air outlet

Controller panel

Handle

Remote box

Upper air inlet grille

Air exhaust outlet

Lower air inlet grille

OPERATING METHODS

50cm

-4-

The working range of COOL mode and HEAT mode is 16 -

30 , the working range of.

At DRY mode,the static pressure range is 0 ～25 pa.

When operating, the unit should be placed on the horizontal place, more

than 50cm away from the wall orother obstructions.

The working range of COOL

mode,Heat mode and DRY

mode.

Location requirement

Power supply Before the unit is power-on, please check the following:

The power supply is rated voltage 10%.

The power plugs and the

sockets can be supported by the current

that is more than 16A.

The thread section of the lead wires and any continued use lead wire

is no less than 2.5mm2.

The air conditioner must be safety earthed. Earth wire must be

connected to the special device of the building. In order to provide

the good earthing for the air conditioner.

The appliance must be positioned so that the plug is accessible,

If the supply cord is damaged, it must be replaced by the manufacturer

or its service agent or a similarly qualified person in order to avoid a hazard.

The appliance shall not be installed in the laundry.

The minimum clearance from the appliance to combustible surface is 50cm.

When children use the appliance, it must be supervised by adults or supervisors.

The appliance shall be installed in accordance with national wiring regulations.

The appliance is for indoor use only.

OPERATING METHODS

● Can not use the steel wire or the brass wire replace the fuse, the

capability of the fuse must be appropriate.

In order to avoid the power

cord damaged and electrical leakage, do not fix the power supply on the

knife edge or the sharp object.

● The wiring must be operated by the professional

and according

to the national regulations.

－5－

－6－

OPERATING METHODS

Names and Functions- Remote Controller

ON/ OFF key

MODE key

COOL mode

Set TEMP.

DRY mode

FAN mode

Control paneland the function

1. "ON/ OFF " key

Press once to start and press once more to stop the unit.

2."MODE" key

Press this button to change the operation mode in order of:

COOL → DRY → FAN → HEAT

3. key

In "COOL"and "HEAT" mode, press

" ""

" once, the SET TEMP. will decrease 1

" once, the SET

TEMP.

key

" "" "

will increase 1℃（１），

The SET TEMP. can

be selected from 16℃（６１）～３０℃（８６）．

Press

℃（１）

" °F

°F

°F°F

HEAT

mode

→ COOL

－7－

OPERATING METHODS

1). To select a place near the door and window, install the exhaust duct.

2). Press "MODE" key to select "COOL" mode.

3). Press key to set the suitable temp.16℃（６１）～30℃（８６）．

When the unit is running in the COOL mode, in order to keep the good cooling effect,

please pay more attention to:

１）． If there is the direct sunlight near the window, please use the curtain to shield .

２）． not use other heat sources in the air conditioner

room.

Please close the door and window, in order to obtain the better dehumidifying effect:

Press "MODE" key, select the "DRY" mode, the unit will run in the "DRY" mode, at the

same time, the upper motor is running at the low speed, it is not adjustable.

COOLmode

CAUTION

DRY mode

When in cooling or dehumidifying mode, the dew water will drain into the tank.

When the tank gets full, the indicator will flash, and the buzzer will sound eight times,

LED window shows error code “H8”，at the same time the unit stop running.

WATER

Cut off the power supply, move the appliance to a suitable place to pull out the plug

and pour out the water in tank. When water is drained out completely, re-insert the plug

back into the drainage pipe to avoid dew water leakage. (As figurre shown below Fig 1) When

restart the appliance,it must be set again.

METHOD OF

DRAINAGE

Drainage Pipe

Rubbe Plug

Fig 1

"""°F°F

1). Press "MODE" key to select "HEAT" mode.

2). Press key to set the suitable temp.16℃（６１）～30℃（８６）．

HEAT mode

"""°F°F

When the unit running in cool mode,do

-8-

●

AUTO

COOL

DRY

FAN

HEAT (Note:no for coolling

FAN FAN speed button

Press this button once, fan speedwill change

as below: Auto

Low speed Middle speed

High speed

Note:Under the Dry mode, the fan speed isn't

●

Simpleness swing mode is defaulted for wireless

remote control, in this mode, press this button,

(＋/－)

16 ～30℃

●

Note: Be sure that there are no obstructions between receiver and remote control; Don't drop

or throw the remote control; Don't let any liquid in the remote control and put the remote control

directly under the sunlight or any place where is very hot

Signal transmitter

Remote control

ON/OFF

ON/OFF button

Press this button, the unit will be started or stopped,

which can clear the timer or sleeping function of

last time.

●

only unit)

.PMET button

(＋/－)

When press +button , the setting temp. will b

increasedby1 (1 ),When press-button,the

setting temp. will be decreased by 1

The temp. will be changed quickly

the button continuously and setting temp. range

℃

by pressing

●

Swing up and down button

℃

below.

Press this button, the running mode

will change as

Mode button

MODE

could turn on or turn off the Up and down

swing function.

When unit is turned off, synchronously press

"+" and Up and down swing buttons, it could

be switched between the simpleness swing

mode and stationary swing mode, at this time,

blinks 2 seconds.

In Stationaryswingmode,pressthisbutton,the

angle forUp and downswingasshowinbelow:

When upand downswinglouverisworking,

whenturnofftheunit,thesiwnglouver will

●

immediatelystop atcurrentposition.

shows upanddownswing louverswingsback

andforthasshowin the abovefigure.

adjustable, low fan speed is imperative,

butwhenoperatingthisbutton,thewireless

remote control will send this signal.

NAMESANDFUNCTIONSOFTHEREMOTECONTROLLER

(1 )

℃°

F°

FAN

AUTO

OPER

HEALTH

AIR

FILTER

TURBO

ON/OFF

X-FAN

HOUR

HUMIDITY

ON/OFF

MODE

FAN

X-FAN

TURBO

TEMP TIMER

SLEEP LIGHT

Andere Handbücher für MULTI SYSTEM SERIES

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Sinclair Klimaanlage Handbücher

Sinclair

Sinclair ASP-09AI Bedienungsanleitung

Sinclair

Sinclair ASE-36AH Bedienungsanleitung

Sinclair

Sinclair KING ASH-09AK Bedienungsanleitung

Sinclair

Sinclair MV-F BI Series Bedienungsanleitung

Sinclair

Sinclair Spectrum Series Bedienungsanleitung

Sinclair

Sinclair ASD-42BI Bedienungsanleitung

Sinclair

Sinclair ASC-60AN Bedienungsanleitung

Sinclair

Sinclair SDV5 Series Bedienungsanleitung

Sinclair

Sinclair SDV5 C1A Series Bedienungsanleitung

Sinclair

Sinclair ASH-18AK Series Bedienungsanleitung

Sinclair

Sinclair ASH-09AIM2 PT Bedienungsanleitung

Sinclair

Sinclair ASF-12A Bedienungsanleitung

Sinclair

Sinclair SMH-100IRA? SMH-140IRA Bedienungsanleitung

Sinclair

Sinclair MV-H**BIF series Bedienungsanleitung

Sinclair

Sinclair ASE-76AH Bedienungsanleitung

Sinclair

Sinclair SF-08C Bedienungsanleitung

Sinclair

Sinclair CONSOLE ASP-12BI Bedienungsanleitung

Sinclair

Sinclair MATRIX ASH-18AIM PT Bedienungsanleitung

Sinclair

Sinclair SDV5 Series Bedienungsanleitung

Sinclair

Sinclair CONSOLE ASP-09BI Bedienungsanleitung

Sinclair

Sinclair SDV4-180EA Bedienungsanleitung

Sinclair

Sinclair ASF-12A Bedienungsanleitung

Sinclair

Sinclair ASGE-09AIN WK Bedienungsanleitung

Sinclair

Sinclair ASH-18BIF Bedienungsanleitung

Beliebte Klimaanlage Handbücher anderer Marken

Spheros

Spheros CC 355 Bedienungsanleitung

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE Bedienungsanleitung

Panasonic

Panasonic CS-E12HKEW Bedienungsanleitung

nedis

nedis ACMB1WT7 Bedienungsanleitung

Samsung

Samsung AR KV Series Leitfaden

Daikin

Daikin FCFV50A Bedienungsanleitung

Fujitsu

Fujitsu Inverter ASBA30JFC Bedienungsanleitung

Toshiba

Toshiba RAS-M10SMUV-E Bedienungsanleitung

Daikin

Daikin FXLQ20MAVE Bedienungsanleitung

Hitachi

Hitachi RAS-E24CAK Bedienungsanleitung

CIAT

CIAT Magister 2 Series Leitfaden

Bestron

Bestron AAC6000 Bedienungsanleitung

Hisense

Hisense 7K Technisches Handbuch

Frigidaire

Frigidaire FFRE0533S1E0 Bedienungsanleitung

Samsung

Samsung AS09HM3N Bedienungsanleitung

Frigidaire

Frigidaire CRA073PU11 Betriebsanleitung

Soleus Air

Soleus Air GB-PAC-08E4 Bedienungsanleitung

McQuay

McQuay MCK020A Bedienungsanleitung