7
2.2 - POSITIONING
Position the pallet, with the slicer, on a flat
surface and take off (a) the sharpe-ner from the
slicer (Fig. n°12).
At this point turn the machine on its side (Fig.
n°13) and unscrew, with the proper wrench
provided, the 4 nuts which fasten the slicer.
Remove the 4 washers and unscrew the 4
fastening tie rods on the wooden pallet. Take off
the pallet and fasten the 4 feet provi-ded.
Finally, put the sharpener in its place.
Position the slicer in the predestined place.
The dimensions indicated in Tab. 1-2-3
(according to the model) must be kept in mind
for the plane where the slicer will be installed,
therefore it must be wide enough, well-levelled,
dry, smo-oth, robust, stable about 80 cm high off
the ground and at least 20 cm from walls,
objects, shelves, etc. (Fig. n°14) in respect to
the space necessary for its use and
safeguarding. Furthermore the machine must be
pla-ced in an environment with a maximum
humidity of 75%, not salty and with a
temperature between +5°C and +35°C; in any
case in environments which do not lead to
deviations of the above.
Make sure the graduated handgrip is inposiion
“0”.
Check the alignment of the blade-plane thickness
gauge by running a finger (Fig. n°16) from the
blade towards the thickness gauge plane (never
in the op-posite direction). Unscrew and screw
the foot (1) until the correct alignment is found
(Fig. n°17), then screw the rub-ber part (2) to fix
everything (Fig. n°17).
a
~ 80cm
20cm
Fig. n°12 Fig. n°13
Fig. n°14
Fig. n°15
Fig. n°16 Fig. n°17
20cm
20cm
1
2
20cm
