SmallRig Forevala W60 Bedienungsanleitung
Wireless Microphone
User Manual
Drahtloses Mikrofon
Benutzerhandbuch
无线麦克风
用户手册
Preface
Thank you for purchasing SmallRig's products.
Important Notes
Please read this User Manual carefully.
Do not use the product in water because it is not dust or water
proof.
Do not let the product fall to the ground, be hit or suffered violent
impact.
Do not exert pressure on its LCD screen because over pressure will
cause permanent damage to the screen.
Do not use the product in the completely closed environment, or
it may lead to rise of internal temperature, which causes product
failure, ignition or other accident.
Do not leave the product in excessive heat, high temperatures can
cause the product to malfunction.
Do not place the product in a place where there are corrosive
chemical to protect the product from corrosion,corrosion may
cause the product to malfunction.
Do not place the product nearby any combustible or volatile
solution, or it may cause a fire disaster or smog.
Be sure to power the product off when it is not in use.
Use only a microfiber and dry cloth for cleaning the product.
Never remove the non-detachable lithium battery without
permission.
When the battery is not in use for a long time, please charge and
discharge the battery each 6-month, and provide it with
approximately 60% of the electric quantity to prolong its lifetime.
Since there are some hazardous substances in the battery, please
do not discard it. Instead, dispose of the product that is damaged
or will never be used according to the waste management
measures.
Note: To prolong the lifetime, please minimize the use of the
product while charging.
Warning
Please do not disassemble the product. If you suspect any
problem with the product, please contact the purchasing
platform and apply for after-sales treatment.
Standard Use of the Equipment
The standard use of the SmallRig Forevala W60 wireless
microphone includes
Read this manual carefully, especially the "Important Notes"
section.
Use and store the product under the working conditions specified
in this manual.
In the Box
Transmitter (TX)
Receiver (RX)
Storage Case
TRS to TRS Cable
TRS to TRRS Cable
Furry Windscreen
USB-C Charging Cable
SmallRig Metal Sticker
Carrying Bag
User Manual
Product Details
Transmitter
Transmitter Screen
① Microphone: built-in condenser microphone
② 3.5mm port: TRS external microphone jack
③ USB-C port: 5V charging port
④ Display: interactive LCD display
⑤ Power button: short press to mute on, long press to switch
on and off
⑥ Pairing key: short press low cut on, long press to pair
① Mute / Microphone works normally
② Signal intensity
③ Low cut function enabled
④ Transmitter battery power
⑤ Microphone audio bar of channel A / B
Operations
1.Switch button: long press to power on / off. "SmallRig" logo
appears on the LCD screen after power on. In power on mode,
short press to enter mute mode, and short press again to enter
normal mode.
2.Low cut function: short press the low-cut button to turn on / off
the low-cut function. When the low cut function is turned on, the
LCD screen displays the low-cut symbol.
3.Manual pairing: long press the "low cut/pairing" button to enter
pairing mode. When rebooting TX and entering pairing mode, the
signal display symbol will be dynamically displayed until it is
paired with the receiver (RX).
4. Charging function: the TX can be charged by connecting the
cable through the storage case or directly through the USB-C
charging cable, with charging dynamics displayed on the LCD
screen while charging.
Receiver
Receiver Screen
① Stereo: Stereo sound channel / Mono: Mono sound channel
① Knob 1:volume up or down for receiver A (press knob 1 and
knob 2 simultaneously to pair)
② Display: LCD display
③ Knob 2: volume up or down for receiver B (press knob 1 and
knob 2 simultaneously to pair)
④ Power button: receiver on / off
⑤ 3.5mm port 2: TRS / TRRS headphone monitor jack
⑥ 3.5mm port 1: TRS audio output port
⑦ USB-C port: 5V charging port
Operations
1.Switch button: long press to power on/ off. "SmallRig" logo
appears on the LCD screen after power on. In power on mode, for
each short press, the audio output switches between
mono/stereo, and the display will show "Mono" / "Stereo".
2. Gain adjustment: through the group A volume adjustment
knob, rotate it clockwise to increase the volume, and vice versa to
reduce the volume. Through group B volume adjustment knob,
rotate it clockwise to increase the volume, and vice versa to
reduce the volume. The gain is displayed in three colors, in which
green means below -12dB, yellow means -12dB ~ 0dB, and red
means above 0dB.
3. Manual pairing: the volume adjustment button on the RX is
used as a pairing button when pressing. When the volume
buttons of groups A and B are pressed simultaneously, the
receiver enters the pairing mode (for TX, long press the pairing
button). At the same time, the group information is flashing on
the display, until it is paired with the transmitter (TX) . After
connecting to the transmitter, the group information is of reverse
display, otherwise hollow display, in black font In pairing mode,
press any button to exit.
4. Charging function: the RX can be charged by connecting the
cable through the storage case or directly through the USB-C
charging cable, with charging dynamics displayed on the LCD
screen while charging.
② Receiver battery capacity
③ Microphone audio bar of channel A / Microphone audio
bar of channel B
④ Channel A output volume / Channel B output volume
Storage Case
1. Charging: red display when connected to the power supply to
charge RX/TX, and green display when RX / TX is fully charged.
2. Port: with USB-C charging port, and built-in USB-A charging cable
at the bottom of the storage case.
Operating Instructions
Transminer
Mount the transmitter to the collar via the back clip so that
the built-in microphone points in the direction of the audio
source.
(Note: In the process of use, for better concealment, it is
recommended that the back clip is fixed towards the
outside for use)
Use an external microphone
Plug the 3.5mm TRS microphone input cable into the
transmitters 3.5mm TRS external microphone jack. Clip the
transmitter to your belt via the back clip, then clip the lavalier
microphone on the other end to your collar.
(Note: When using an external microphone, the built-in
microphone will automatically turn off)
Receiver
Method for using with the camera
Clip the receiver to the camera's cold shoe mount via the
back clip. Connect the receiver to the camera via 3.5mm
TRS-TRS cable. Plug the headphones into the headphone
monitor hole for monitoring.
Inhaltsverzeichnis
Sprachen:
Beliebte Mikrofon Handbücher anderer Marken
IK Multimedia
IK Multimedia iRig Stream MIC PRO Bedienungsanleitung
DAPAudio
DAPAudio RM-101 Bedienungsanleitung
AKG
AKG CHM 21 Bedienungsanleitung
Sennheiser
Sennheiser evolution wireless series EM 100 Bedienungsanleitung
Sony
Sony C-48 Bedienungsanleitung
GIGAMEDIA
GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung
