SMART-AVI RGB2VGA Bedienungsanleitung

THE RGB TO DVI(/VGA) CONVERTER

Welcome to the RGB to DVI(/VGA) Converter

Family!

Thank you for purchasing an RGB to DVI(/VGA) Converter! We appreciate your business,

and we think you’ll appreciate the many ways that your enhanced RGB Graphic system will

save you money, time, and effort.

That’s because our RGB to DVI(/VGA) Converter is all about breaking away from the

traditional model of attaching a new display to an old graphic source. You can encounter

many potential problems in connecting a flat screen to an RGB graphic source – unless you

use our RGB to DVI(/VGA) Converter products! Attach a flat screen to any graphic source

and match the output to your requirements. The RGB to DVI(/VGA) Converter – the one-stop

answer for all your RGB adapting needs! And with a special adaptor cable (not supplied as

standard), you can also attach a screen to a CGA or EGA source.

This manual will tell you all about your new RGB to DVI(/VGA) Converter, including how

to install, operate, and troubleshoot it. For an introduction to the Converter, see Chapter 2.

The Converter product codes covered in this manual are:

K238-3F: RGB to DVI (or VGA) Converter

THE RGB TO DVI(/VGA) CONVERTER

Copyrights and Trademarks

the prior written consent of the manufacturer.

Information in this document is subject to change without notice and the manufacturer shall

not be liable for any direct, indirect, special, incidental or consequential damages in

connection with the use of this material.

All trademark and trade names mentioned in this document are acknowledged to be the

property of their respective owners.

Disclaimer

While every precaution has been taken in the preparation of this manual, the manufacturer

assumes no responsibility for errors or omissions. Neither does the manufacturer assume any

liability for damages resulting from the use of the information contained herein. The

manufacturer reserves the right to change the specifications, functions, or circuitry of the

product without notice.

The manufacturer cannot accept liability for damage due to misuse of the product or due to

any other circumstances outside the manufacturer’s control (whether environmental or

installation related). The manufacturer shall not be responsible for any loss, damage, or injury

arising directly, indirectly, or consequently from the use of this product.

Cautions and Notes

The following symbols are used in this guide:

CAUTION. This indicates an important operating instruction

that should be followed to avoid any potential damage to

hardware or property, loss of data, or personal injury.

NOTE. This indicates important information to help you make the best use of this

product.

EMPTY PAGE

THE RGB TO DVI(/VGA) CONVERTER

EUROPEAN UNION DECLARATION OF CONFORMITY

This is to certify that, when installed and used according to the instructions in this

manual, together with the specified cables and the maximum cable length <3m, the

Units are shielded against the generation of radio interferences in accordance with the

application of Council Directive 89/336/EEC as well as these standards:

EN 55022: 1999 Class B

EN 55024: 1999

IEC 61000-4-2: 2001

IEC 61000-4-3: 2001

IEC 61000-4-4: 2001

EN 61000-3-2 2001

EN 61000-3-3 2002

The device was tested in a typical configuration with PC.

SAFETY PRECAUTIONS AND INSTALLATION GUIDELINES

Safety Precautions and Installation Guidelines

To ensure reliable and safe long-term operation, please note the following installation

guidelines:

• Only use in dry, indoor environments.

• The Converter and any power supplies can get warm. Do not locate them in an enclosed

space without any airflow.

• Do not place a power supply directly on top of a unit.

• Do not obstruct a unit’s ventilation holes.

To safeguard against personal injury and avoid possible

damage to equipment or property, please observe the

following:

• Only use power supplies originally supplied with the

product or manufacturer-approved replacements. Do not

attempt to dismantle or repair any power supply. Do not

use a power supply if it appears to be defective or has a

damaged case.

• Connect all power supplies to grounded outlets. In each

case, ensure that the ground connection is maintained

from the outlet socket through to the power supply’s AC

power input.

• Do not attempt to modify or repair this product

THE RGB TO DVI(/VGA) CONVERTER

Contents

1. Quick Setup 8

1.1 Video Input/Output 9

1.2 Command Summary 10

2. Overview 11

2.1 Introduction 11

2.2 Glossary 11

2.3 Features 13

2.4 Product Range 14

2.5 Compatibility 15

2.6 How to Use This Guide 15

3. Installation 17

3.1 Package Contents 17

3.2 Connection Cable Requirements 18

3.3 System Setup 19

3.4 Diagnostic LEDs 21

4. Device Control 22

4.1 Opening the OSD 23

4.2 Using the OSD 25

5. Monitor Setup 34

6. RGB to DVI(/VGA) Converter Setup 35

6.1 Overview 35

6.2 Setup Instructions for RGB Input 36

6.3 Setup of a new Video Mode 38

7. Troubleshooting 40

7.1 Video 40

CONTENTS

Appendix A: Example Applications 42

Appendix B: Rack Mount Options 43

Appendix C: System Upgrade 45

Appendix D: Supported Video Modes 45

Appendix E: Calling Technical Support 48

Appendix F: Specifications 49

Appendix G: Connectors and Cables 50

THE RGB TO DVI(/VGA) CONVERTER

1. Quick Setup

This section briefly describes how to install your RGB to DVI(/VGA) Converter and optimize

the video signals. Unless you are an experienced user, we recommend that you follow the full

procedures described in the rest of this manual. Refer to the command summary on page 10

when following this procedure.

Install system

1. Connect the RGB to DVI(/VGA) Converter to the RGB (video) source.

2. Connect a display to the RGB to DVI(/VGA) Converter.

3. Power up the system.

Carry out the Monitor Setup

procedure (please refer to the

monitor’s manual and see

page 34 in this manual).

Carry out Setup of a new Video Mode procedure

(please follow the instructions on page 38).

Done

Yes

Do you have a

DVI monitor?

Is the RGB video

mode in the list of

supported modes?

(see page 46)

Do you

have a flat screen

(TFT)?

Yes

QUICK SETUP

1.1 Video Input/Output

If possible, always use a DVI output to a monitor from the RGB to DVI(/VGA) Converter,

especially with flat screens. This provides the optimum video signal. If you use a VGA output

from the RGB to DVI(/VGA) Converter, it must convert the digitized data to analogue

values. Similarly, if your TFT screen uses a VGA input, it must digitize the signal from the

RGB to DVI(/VGA) Converter. In these cases, the built-in video processors (in the TFT)

must determine the resolution and pixel phase for an optimized digitization. Your RGB to

DVI(/VGA) Converter allows you to optimize the video signal manually or automatically

using its on-screen utility (see Chapter 4). If you are using a VGA input to a TFT monitor,

please follow the manufacturer’s instructions.

You may have several possible options for video source output/monitor input. If this is the

case, for the optimum video quality, please select the highest ranked available combination

from the following table:

Video Quality RGB to DVI(/VGA)

Converter input RGB to DVI(/VGA)

Converter output

1 RGB progressive scan

RGBS progressive scan DVI

2 RGB video (e.g. from

SCART) interlaced DVI

3 RGB progressive scan

RGBS progressive scan VGA

4 RGB video (e.g. from

SCART) interlaced VGA

THE RGB TO DVI(/VGA) CONVERTER

1.2 Command Summary

The following table summarizes the remote control buttons and ‘hot’ key command

sequences used in system configuration and video tuning on the RGB to DVI(/VGA)

Converter.

Infrared Remote Control (IR-RC) Command Utility *

Exit OSD

<X>

Enter OSD <O> + <S>

+ <D>

+ <Enter>

Accept and store

modified parameter

Select Submenu

Select parameter

modification

<S>

Select next

position

Increase

parameter

<R>

Select previous

position

Decrease

parameter

<L>

Direct Brightness

Control

Direct Contrast

Control

Reset to factory

defaults

(press twice!)

Back to the Menu

selection

* Commands are not case-sensitive.

Inhaltsverzeichnis

Andere SMART-AVI Medienkonverter Handbücher

SMART-AVI

SMART-AVI V2V-SC4KUHD Bedienungsanleitung

SMART-AVI

SMART-AVI CVH-01 Bedienungsanleitung

SMART-AVI

SMART-AVI HDS-4PS Bedienungsanleitung

SMART-AVI

SMART-AVI SMCVG2DVI Bedienungsanleitung

SMART-AVI

SMART-AVI UHDN-4P Duo Bedienungsanleitung

SMART-AVI

SMART-AVI DVS4P Bedienungsanleitung

SMART-AVI

SMART-AVI SaviStreamer E300 Bedienungsanleitung

SMART-AVI

SMART-AVI HSA-100-S Bedienungsanleitung

SMART-AVI

SMART-AVI SMCYPB2VGA Bedienungsanleitung

SMART-AVI

SMART-AVI UUX-PLUS Bedienungsanleitung

SMART-AVI

SMART-AVI HDN-4P Bedienungsanleitung

SMART-AVI

SMART-AVI SaviStreamer SAVI-ST-E300 Bedienungsanleitung

SMART-AVI

SMART-AVI V2V series Bedienungsanleitung

SMART-AVI

SMART-AVI V2V-AV2HV Bedienungsanleitung

SMART-AVI

SMART-AVI VS4PS Bedienungsanleitung

SMART-AVI

SMART-AVI EZWALL-pro 3x3 v3 Bedienungsanleitung

SMART-AVI

SMART-AVI V2V-H2V-01 Bedienungsanleitung

SMART-AVI

SMART-AVI DVS8PS Bedienungsanleitung

SMART-AVI

SMART-AVI V2V Series Bedienungsanleitung

SMART-AVI

SMART-AVI SM-HDMV-16X-PLUS Bedienungsanleitung

SMART-AVI

SMART-AVI V2V-MPC Bedienungsanleitung

SMART-AVI

SMART-AVI V2V-SC4KUHD Bedienungsanleitung

SMART-AVI

SMART-AVI V2V Series Bedienungsanleitung

SMART-AVI

SMART-AVI SMCCV2DVI Bedienungsanleitung

Beliebte Medienkonverter Handbücher anderer Marken

SoundTraxx

SoundTraxx Blunami BLU-2200 Bedienungsanleitung

SPROLINK

SPROLINK VA1 Bedienungsanleitung

Acclaim Lighting

Acclaim Lighting DDC-1-AC Bedienungsanleitung

Nikon

Nikon AF-S TC-20E III Bedienungsanleitung

Axis

Axis AXIS Q7406 Bedienungsanleitung

Omega

Omega TAC80B-J Bedienungsanleitung

Zoom

Zoom Thunderbolt TAC-2R Bedienungsanleitung

OST

OST iConverter 10/100M Bedienungsanleitung

Vertiv

Vertiv Netsure Bedienungsanleitung

birddog

birddog MINI Bedienungsanleitung

Roland

Roland GI-10 Bedienungsanleitung

Wallenstein

Wallenstein WX310 Bedienungsanleitung

Pace

Pace MSS 200-1 Bedienungsanleitung

Solar Converters

Solar Converters EQ 12/24-50 Bedienungsanleitung

CYP

CYP EL-7400V Bedienungsanleitung

TIE

TIE MIDI 1i1o Bedienungsanleitung

DCS

DCS Vivaldi Upsampler Bedienungsanleitung

Westermo

Westermo MCW-211 SERIES Bedienungsanleitung