Smarte SmartNet X Top Channel Bedienungsanleitung
C. Chapman Page 1 SNX Top Channel 4.11.2004 V1.0
Ranmore Manor, Ranmore Common, Dorking, Surrey, RH5 6SX
Tel: +44 (0)1483 283 365 Fax: +44 (0)1483 281 511
Procedure for setting SmartNet X Top Channel
The Top Channel feature allows users to specify the uppermost source/input.
There are two methods of setting up this feature.
Manual.
(
You will need to be able to see the Yellow LED on the front of the SmartNet)
Equipment List
You will need the following list of equipment;
¾1 x Classic Smart 4 Infrared handset.
¾1 x UTP Patch Cable.
¾1 x SLX-RX200.
¾1 x SM-EYE Infrared Eye.
¾1 x SmartNet X to be configured.
Procedure
1. Connect the equipment listed above as shown in the diagram below.
2. Power down the SmartNet hub.
3. Make a note of the setting on the rotary switch on the right hand side of the front of the
SmartNet unit.
4. Set the rotary switch so that the arrowhead points to position F.
5. Re-power the SmartNet hub. The Yellow LED will Blink 4 times and stop.
C. Chapman Page 2 SNX Top Channel 4.11.2004 V1.0
6. From User position ONE enter the Top Channel as two digits. (Valid Range = 01 to 16).
As the first digit is entered the Yellow LED will blink once. When the second digit is
entered the hub will validate the Channel number;
¾If the Channel number entered is valid the Yellow LED will blink back the entered
Channel number.
¾If the Channel number entered is invalid the Yellow LED will blink once for a longer
period of time.
7. To find out what the current Top Channel setting is. Press -/-- or 10 button and the
current setting will be blinked back.
8. If the newly entered setting is correct power down the hub again. Re-set the hex switch
to position noted in step 3 above and then restore power.
9. If the entered setting is incorrect simply re-enter it.
Note: If at power up the rotary switch is not set to position F the hub will blink
back the current Top Channel setting before continuing with normal operation.
Via Serial Port
It is also possible to both set and read the Top Channel setting by Sending commands to the
SmartNet via the RS422 port.
Please refer to the SmartNet Protocol Document for more information regarding this.
Inhaltsverzeichnis
Andere Smarte Netzwerk-Router Handbücher
Beliebte Netzwerk-Router Handbücher anderer Marken
NETGEAR
NETGEAR FS526T - Switch Bedienungsanleitung
Korenix
Korenix JetNet 5710G Series Bedienungsanleitung
Automated Logic
Automated Logic ZN551 Betriebsanleitung
Cisco
Cisco ASR 1000 Series Bedienerhandbuch
EnGenius
EnGenius ESR-9710 Bedienungsanleitung
Cisco
Cisco 805 Series Bedienungs- und Sicherheitshinweise