SmarTerminal Smart Compact SMP-3000 Bedienungsanleitung

RFID Gun reader

for SmartCompact

User Manual

SmarTerminal Computers, Inc.

Ver 0.931, SEP 2007

Page 1 2/1/2008

Disclaimer

SmarTerminal and SmartCompact are registered trademarks of

Sammi Information Systems Co., Ltd.

All other brand names, product names, or trademarks belong to their respective

holders.

Head Quarters

Sammi Information Systems Co.,Ltd.

103-15, Galwor –dong, Yongsan-Gu, Seoul, Korea

Tel. 82 -2-790-5508 / Fax. 82-2-790-5509

Email. [email protected]

Web. www.sammicomputer.co.kr

Us Office

SmartTerminal Computers, Inc.

5200 Orange Ave. Suite 212

Cypress, CA90630

Tel. 1-714-761-5300 Fax. 1-562-252-8272

Email. [email protected]

Web. www.smarterminal.com

Page 2 2/1/2008

Table of Contents

Introduction....................................................................................................................................... 4

Chapter 1 Get to know more about RFID Gun reader................................................................... 5

1.1 Make sure you have everything ....................................................................................... 5

1.2 Appearance ........................................................................................................................ 6

1.2.1 Front side .................................................................................................................... 6

1.2.2 Rear side...................................................................................................................... 6

1.2.3 Top side ....................................................................................................................... 8

1.2.4 Bottom side................................................................................................................. 8

1.2.5 Left side....................................................................................................................... 8

1.2.6 Right side .................................................................................................................... 9

1.2.7 With Protective rubber cover .................................................................................... 9

Chapter 2 Power settings and connections ................................................................................ 10

2.1 Remove / Install batteries in RFID Gun reader.............................................................. 10

2.2 Battery charging using power adapter.......................................................................... 11

2.2.1 Charging with AC/DC adapter ................................................................................. 11

2.2.2 Charging with Battery charger................................................................................ 12

Chapter 3 Setting up SmartCompact RFID Gun reader.............................................................. 13

3.1 How to set CAB Files in SmartCompact........................................................................ 13

3.2 How to connect SmartCompact to RFID Gun reader................................................... 16

3.3 How to remove SmartCompact from RFID Gun reader................................................ 17

Chapter 4 Using RFID Gun reader................................................................................................ 18

4.1 How to operate RFID Gun reader................................................................................... 18

4.1.1 How to install program files in SmartCompact........................................................... 18

4.1.2 How to operate RFID Gun reader ................................................................................. 21

Appendix A...................................................................................................................................... 23

RFID Gun reader Specification Highlights............................................................................... 23

Appendix B...................................................................................................................................... 24

Version Table............................................................................................................................... 24

Page 3 2/1/2008

Introduction

This quick reference guide allows you to use all the advanced features of SmartCompact effectively.

Please go through it once before using SmartCompact handheld terminal.

User's Information

Cautions

Modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate the equipment.

FCC compliance Information

This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and 2. This device must accept any interference

received. Including interference that may cause undesired operation.

Information to User

This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio Frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver- Connect the equipment into an outlet on a

circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

RF exposure statement

"To maintain compliance with FCC's RF exposure guidelines, this equipment should be installed and

operated with minimum distance 20cm between the radiator and your body. Use only the supplied antenna."

Page 4 2/1/2008

Chapter 1 Get to know more about RFID Gun reader

1.1 Make sure you have everything

9RFID Gun reader main unit (UHF)

9Standard battery pack (2200 mAH Li-ion)

Optional accessories

9Spare battery pack (2200 mAH Li-ion)

93 pack battery charger – under development

9AC/DC adapter

9Protective rubber cover

Page 5 2/1/2008

1.2 Appearance

1.2.1 Front side

UHF antenna

Features and description

Features Function / Description

RFID Antenna RFID antenna is located in front side of Gun reader

1.2.2 Rear side

LED

Display

Gun handle

Power LED

Battery Capacity

Communication LED

RF Strength LED (1 ~ 5)

Rear panel features

Page 6 2/1/2008

Name Function

Power LED Shows green light for 5 seconds when user triggers the gun

Battery capacity LED Shows battery capacity status (see below table for details)

Communication LED When IrDAcommunication is successful between Gun reader and

SmartCompact, Communication LED shows green light (blinking)

as user triggers the gun.

RF Strength LED Shows RFID power level from 1~5

LED color change according to battery capacity

Name Function

0 ~ 30% charged : red

30 ~ 80% charged : blue

80 ~ 100% charged : green (fully charged)

Page 7 2/1/2008

1.2.3 Top side

Screws for attaching

to SmartCompact

1.2.4 Bottom side

2200mAH battery

1.2.5 Left side

Battery out switch

Page 8 2/1/2008

nd description

Features Function / Description

Features a

Battery out button To take out battery, user should push this button.

1.2.6 Right side

Features and description

Features Function / Description

DC input jack To charge RFID reader, user should connectAC/DC adapter

to this DC input jack.

1.2.7 With Protective rubber cover

Features and description

ction / Description

Features Fun

Protective rubber vibration, user can additionally

cover

To protect from shock and

cover SmartCompact and/or RFID Gun reader.

DC input jack

Page 9 2/1/2008

Chapter 2 Power settings and connections

2.1 Remove / Install batteries in RFID Gun reader

ress the battery out button and remove battery in below direction:

Push and secure the battery in the gun reader until hearing a click sound:

battery out button

Page 10 2/1/2008

Inhaltsverzeichnis

Andere SmarTerminal Barcode-Lesegerät Handbücher

SmarTerminal

SmarTerminal SmartCompact Bedienungsanleitung

Beliebte Barcode-Lesegerät Handbücher anderer Marken

POSMicro

POSMicro Datalogic PowerScan D7100 Bedienungsanleitung

Marson

Marson MT780 Kurzanleitung zur Einrichtung

NCR

NCR RealPOS Bedienungsanleitung

Motorola

Motorola SE3300 Kurzanleitung zur Einrichtung

Element

Element P130BT Bedienungsanleitung

Motorola

Motorola Symbol LS3008 Installations- und Betriebshandbuch

Meec tools

Meec tools OBD-II / VAG Bedienungsanleitung

SICK

SICK CLP 100 Bedienungsanleitung

Royal Tag SA

Royal Tag SA I-Read Bedienungsanleitung

Welch Allyn

Welch Allyn IMAGETEAM 3800 Bedienungsanleitung

Meteor

Meteor 8310 Bedienungsanleitung

Denso

Denso BHT-500B Bedienungsanleitung

Datalogic

Datalogic Heron HD3130 Bedienungsanleitung

Motorola

Motorola MP6000 Montageanleitung

Newland

Newland NLS-HR15-BT Bedienungsanleitung

ARTDEV

ARTDEV AS-1310 Bedienungsanleitung

Aopos

Aopos AS290 Bedienungsanleitung

ENS

ENS 367-5455 Bedienungsanleitung