Smartgen SG361 Bedienungsanleitung
SG361 GSM/GPRS Module
USER MANUAL
Smartgen Technology
Chinese trademark
English trademark
Smartgen —make your generator smart
Smartgen Technology Co., Ltd.
No. 28 Jinsuo Road
Zhengzhou City
Henan Province
P. R. China
Tel: +86-371-67988888
+86-371-67981888
+86-371-67991553
+86-371-67992951
+86-371-67981000(overseas)
Fax: 0086-371-67992952
Web: http://www.smartgen.com.cn/
http://www.smartgen.cn/
Email: [email protected]
All rights reserved. No part of this publication may be reproduced in any material
form (including photocopying or storing in any medium by electronic means or
other) without the written permission of the copyright holder.
Smartgen Technology reserves the right to change the contents of this document
without prior notice.
If colors of actual products are different from those mentioned within this manual,
please take the actual product as the standard.
Software Version
Date
Version
Content
2014-02-23
1.0
Original release.
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 3 of 8
Contents
1OVERVIEW....................................................................................................... 4
2PRODUCT FEATURE....................................................................................... 5
2.1 TECHNICAL PARAMETERS .................................................................5
2.2 STRUCTURE.........................................................................................6
3TYPICALAPPLICATION AND INSTALLATION STEPS.................................... 7
3.1 TYPICALAPPLICATION........................................................................7
3.2 INSTALLATION STEPS......................................................................... 7
3.3 INSTALLATION......................................................................................8
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 4 of 8
1 OVERVIEW
SG361 GSM/GPRS Module has SMS (Short Message Service) function and
GPRS data transmission function.
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 5 of 8
2 PRODUCT FEATURE
2.1 TECHNICAL PARAMETERS
Power supply: DC( 8~32)V；
Four-frequency GSM/GPRS module; Working frequency: GSM/GPRS
850/900/1800/1900MHz;
Control (GSM 07.07, 07.05) via AT command;
GPRS multi-slot class 10/8;
GPRS mobile station class B;
GPRS class 10：maximum 85.6 kbps (downstream rate);
SMS: text mode/PDU mode;
Antenna Interface：50Ω/SMA (Female);
SIM card：1.8/3V, Automatic detection; Drawer type card slot;
Power supply Interface: pluggable terminals;
RS232 Communication interface: TX、RX、GND;
Working Temperature：(-30~+70) ºC;
Storage Temperature：(-30~+80) ºC;
Humidity：95% (No condensation);
Case Dimensions(mm)：89x66x26mm(L*W*H);
Weight: 151g.
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 6 of 8
2.2 STRUCTURE
1、TERMINAL
TX：Sending end; connect to RX of RS232 interface.
RX：Receiving end; connect to TX of RS232 interface.
GND：Ground wire; connect to ground wire of RS232 interface.
B+：Positive power supply; voltage range: (8~32)V
B-：Negative power supply
2、NETWORK STATUS INDICATOR (RED)
LED STATUS
DESCRIPTION
Off
Not work
64ms On/800ms Off
Not registered to the network
64ms On/3000ms Off
Registered to the network
64ms On/300ms Off
GPRS communication is ok.
3、SIM CARD SLOT
Drawer type card slot, used for installing the SIM card
4、ANTENNA INTERFACE
Fit with standard SMA interface and 50Ωmatching impedance.
Connect the antenna to SMA interface and then
tighten the screws.
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 7 of 8
3 TYPICAL APPLICATION AND INSTALLATION STEPS
3.1 TYPICAL APPLICATION
3.2 INSTALLATION STEPS
1 INSERT SIM CARD
The drawer of the SIM card will pop up after the yellow key is pressed using needle.
Insert the SIM card into the slot and then close the drawer.
2 INSTALLANTENNA
Connect the antenna to SMAinterface and then tighten the screws.
3 COMMUNICATE WITH CONTROLLER
Details connection way pleases refer to Chapter 3.1 TYPICAL APPLICATION
4 CONNECT POWER LINE
The power should not less than 5W to ensure the operation is smoothly as the
power supply voltage of the SG361 module is DC(8~32)V. The system is normal
running if the network status indicator is “64ms On/300ms Off”and users can
control data transmission via AT command.
SG361 GSM/GPRS Module
SG361 GSM/GPRS Module Version 1.0 2014-02-23 Page 8 of 8
3.3 INSTALLATION
It is fixed by two M3 screws when installed and the center distance is 61.5mm. The
overall dimensions please refers to as following:
Inhaltsverzeichnis
Andere Smartgen GSM/GPRS-Modul Handbücher
