SmartRG SE80ac Bedienungsanleitung

SE80

Quick Start Guide

Details

To minimize unwanted AC line noise that may degrade the performance of your SE80, take

advantage of the filtered outlet on the unit for powering your AC devices - especially USB

and other cell phone chargers, dimmer-capable lamps, plasma TVs and other devices

employing switching power supplies. Plug a power strip into the SE80 for additional filtered

capacity.

The bottom of the unit has a reset button and a gigabit Ethernet port.

Installing your SE80ac

Connect one end of an Ethernet cable into the Ethernet port

of the SE80ac and the other end to a LAN port on a SmartOS

router.

Plug the SE80ac into a nearby electrical outlet.

The LED flashes red. Wait for the LED to flash white. This pro-

cess may take about 2 minutes.

Once the LEDstays white, you can unplug the SE80ac and move

it to the location where you want it.

The LEDs repeat the colors and flashing. When the light glows

solid white again, connection is accomplished and you can log

into your network.

FCC Interference Statement

This device complies with Part 15 of the Federal Communication Commission Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one of the following measures:

lReorient or relocate the receiving antenna.

lIncrease the separation between the equipment and receiver.

lConnect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

lConsult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for com-

pliance could void the user's authority to operate this equipment.

This transmitter must not be co-located or operating in conjunction with any other antenna or trans-

mitter.

Operations in the 5.15-5.25GHz band are restricted to indoor usage only.

Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with greater than 20cm between the radiator & your

body.

Industry Canada statement

This device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two con-

ditions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-

ference received, including interference that may cause undesired operation.

Le présent appareil est conforme aux CNR d’ ISED applicables aux appareils radio exempts de licence.

L’exploitation est autorisée aux deux conditions suivantes : (1) le dispositif ne doit pas produire de

brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage

susceptible de provoquer un fonctionnement indésirable.

Caution :

(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for

harmful interference to co-channel mobile satellite systems;

(iii) where applicable, antenna type(s), antenna models(s), and worst-case tilt angle(s) necessary to

remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be

clearly indicated.

Avertissement:

(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une util-

isation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites

mobiles utilisant les mêmes canaux;

(iii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et

les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au

masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués.

Radiation Exposure Statement

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with greater than 20cm between the radiator & your

body.

Déclaration d'exposition aux radiations

Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environ-

nement non contrôlé. Cet équipement doit être installé et utilisé à plus de 20cm entre le radiateur et

votre corps.

Inhaltsverzeichnis

Andere SmartRG Drahtloser Zugangspunkt Handbücher

SmartRG

SmartRG PL60 Bedienungsanleitung

Beliebte Drahtloser Zugangspunkt Handbücher anderer Marken

D-Link

D-Link DWL-2100AP - AirPlus Xtreme G Bedienungsanleitung

Ubiquiti

Ubiquiti NanoStation NSM2 Bedienungsanleitung

Cisco

Cisco Aironet 1550 Series Bedienungsanleitung

Aruba

Aruba IAP-335 Bedienungsanleitung

Advantek Networks

Advantek Networks AWN-AP-54MR Bedienungsanleitung

IP-COM

IP-COM AP355 Bedienungsanleitung

Buffalo

Buffalo AirStation WLA-L11G Bedienungsanleitung

EnGenius

EnGenius EnStationACv2 Bedienungsanleitung

D-Link

D-Link DAP-3662 Bedienungsanleitung

Widelink

Widelink ezWave WAP-1100 Series Bedienungsanleitung

Edimax

Edimax CAP1200 Bedienungsanleitung

xG Technology

xG Technology xMax CN1300 Bedienungsanleitung

Ubiquiti

Ubiquiti LBE-5AC-Gen2 Bedienungsanleitung

Aruba

Aruba AP-203R Bedienungsanleitung

LuXout Shades

LuXout Shades LUXSHADE MOTION Bedienungsanleitung

CreatComm

CreatComm TB5F Bedienungsanleitung

SineDigital

SineDigital MW-1500AP(H) Bedienungsanleitung

TP-Link

TP-Link AP9650 V1 Bedienungsanleitung