Smartwares 10.006.74 Bedienungsanleitung

Users manual 4 - 140

Gebruikershandleiding 27 - 37

Gebrauchsanweisung 15 - 26

Mode d’emploi 38 - 48

Manual de usuario 60 - 70

Instrukcja obsługi 49 - 59

RM218 - 10.006.74

-1-

LED

1Activate - Aktivieren - Activar = 5sec.

Test - Prüfung - Prueba = 1x

-2-

Lock - Fixierstift

Fijación pin

-3-

Test - Prüfung - Prueba

Entree

50cm

MINIMUM EXTRA

100cm

GROUND/ERDGESCHOSS/BEGANEGROND/Pr.ETAGE/PARTER/PLANTA BAJA

ATTIC/BODEN/ZOLDER/MANSARD/PODDASZE/ÁTICO

-4-

IMPORTANT INFORMATION

1. General product information:

The smoke alarm device, if properly installed and maintained,

sounds the alarm at an early stage of the fire. This can give

you those extra valuable seconds to evacuate your home and

call the fire department. The smoke alarm device works with

an 3V lithium battery. Under normal conditions the service life

of the battery is up to 10 years. When the battery is (almost)

empty, the smoke detector indicates this by an audible “beep”.

This indicator sounds every 30-40 seconds during minimum 30

days. End of life, replace complete smoke alarm device!

2. Make/model number: Smartwares RM218

3. Power supply: 3V DC CR123A Lithium

(not replaceable battery)

4. Certification marks:

5. Scope of application: Smoke alarm device for buildings with

residential function.

GB SMOKE ALARM DEVICE

0786

RM218-001CPR

EN14604:2005/AC:2008

Smartwares RM218 G214064

-5-

6. Function: Gives a warning when smoke caused by a fire is

detected.

7. Description: Smoke alarm device based on the photocell

principle, which means that the alarm monitors the air for

smoke caused by fire. smoke alarm device does not detect

heat, gas or fire.

8. Advice: Keep these instructions in a safe,

easily accessible place.

9. Caution: The alarm is designed in order to detect smoke; it

cannot prevent a fire.

10.Caution: The smoke alarm device should not be painted.

Protect the smoke alarm device from dust during renovation

work.

11.Caution: The smoke alarm device should not be

taped/covered (this causes loss of functionality).

12.Caution: Keep the smoke alarm device out of the reach of

children.

Press test button (1) and hold it for above 5 seconds until LED

lights, and release it within 1 second, the unit will generate a

“beep” indicates that it is activated and goes into work status.

CAUTION: Activate smoke alarm first or else there is no function

for this unit.

Test the unit to ensure proper operation by pressing the test

button, this will sound the alarm if the electronic circuitry, horn,

and battery are working. If no alarm sounds, there is a defective

battery or other failure.

ACTIVATION

TESTING

-6-

NOTE: WEEKLY TESTING IS REQUIERED

DO NOT: Use an open flame to test your alarm, you could

damage the alarm or ignite combustible materials and start a fire.

CAUTION: Due to the loudness (85 decibels) of the alarm.

Always stand an arms-length always from the unit when testing.

Test the alarm weekly to ensure proper operation. Erratic or low

sound coming from your alarm may indicate a defective alarm.

1. What is the best place to mount a smoke alarm device

* In the middle of the ceiling but at least 50cm from every edge.

* At least one on each floor.

* In every bedroom.

* In the hallway and stairwell.

* On the landing.

* In the living room.

* In the storage room or rooms with electrical appliances.

2. The alarm should not be installed in:

* A space where the temperature can drop below 4

and above 40°C

* In humid areas.

* Right next to doors or windows and not near a fan or radiator.

Do not install smoke alarm device on the Wall !

INSTALATION

-7-

Do not install the alarm in a place with difficult access, which could

make it difficult to operate the test button and maintenance. The

alarm can be installed quickly and easily. Install the base plate on the

selectedlocationusingtheprovidedscrews.

3. Mounting

* Take the fixation pin out of the ground plate

* Screw the mounting plate with 2 screws on the celling

* Activate the smoke alarm device before mounting

* Fix the smoke alarm device on the mounting plate by turning,

till you hear a “click”

* Put the fixation pin in the hole

* Test the smoke alarm device by pushing the test button

4. Caution

* Do not cover the smoke alarm device with tape! When SMOKE

is detected, you will hear a loud intermittent sound (85dB).

5. Recommendation

* Increase the detection area by installing several smoke alarm

devices

During the smoke alarm is alarming, you push the test button, it will

be paused the smoke alarm alarming for approx. 10 minutes. The

red LED will flash every 8 seconds, it indicates the smoke alarm

deviceis running into the hush mode. >>>

ALARM SILENCE (hush mode)

-8-

Smoke alarm devices are designed to minimize nuisance alarms.

Combustion particles from cooking may set off the alarm if the alarm

is located close to the cooking area. Large quantities of combustible

particles are generated from spills or when grilling/frying. Using the

fan on a range hood that vents to outside (non-recirculating type)

will also help remove these combustible particles from the kitchen.

The alarm silence (test button) is extremely useful in a kitchen area

or other areas prone to nuisance. The hush feature is to be used only

when a known alarm condition, such as smoke from cooking

activates the alarm. The smoke alarm device is desensitized by push

the alarm silence (hush mode) on the smoke alarm device cover, if

the smoke is not too dense, the alarm will silence to indicate that the

alarm is in a temporarily desensitized condition. The smoke alarm

device will automatically reset after approximately 10 minutes, if

after this period, particles of combustion are still present, the alarm

will sound again. The alarm silencer (hush mode) can be repeatedly

untilthe air has been cleared of the conditioncausingthe alarm.

NOTE: Dense smoke will override the alarm silencer and sound a

continuous alarm, the smoke alarm goes back to normal work

status from hush mode

CAUTION: Before using the alarm silence (hush), identify the

source of the smoke and be certain a safe condition exists.

-9-

PREVENTIVE MAINTENANCE

IMPORTANT INSTRUCTIONS IN CASE OF FIRE ALARM

Testing

The smoke alarm device is provided with a test button. Push it in

until the alarm sounds. The signal stops when the button is

released. Test the alarm at least once a week.

Cleaning

For the best performance, the smoke alarm device must be

dusted once a month and vacuumed every 6 months. Remove the

detector from the ceiling plate and carefully vacuum the detector.

Do not touch the inside with the nozzle of the vacuum cleaner.

Then test the alarm.

Caution : The smoke detector loses its effectiveness if it is

covered.

Warning : The smoke alarm device should not be painted /

taped. Do not test the smoke alarm device with

candles, flames, cigarettes, etc.

A smoke alarm device is part of your fire protection together with fire

extinguishers, escape ladders, ropes as well as your choice of

building materials during renovations. Also make sure that there is

an escape route; discuss this with your children, make sure anyroom

canbe evacuatedwithout opening the door, >>>

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Smartwares Rauchmelder Handbücher

Smartwares

Smartwares RM520 Bedienungsanleitung

Smartwares

Smartwares FSM-127 Bedienungsanleitung

Smartwares

Smartwares FSM-121 Bedienungsanleitung

Smartwares

Smartwares RM149 Bedienungsanleitung

Smartwares

Smartwares RM250 Bedienungsanleitung

Smartwares

Smartwares RM620 Bedienungsanleitung

Smartwares

Smartwares RM620 Bedienungsanleitung

Smartwares

Smartwares RM520 Bedienungsanleitung

Smartwares

Smartwares RM218 Bedienungsanleitung

Smartwares

Smartwares RM174RF Bedienungsanleitung

Smartwares

Smartwares FSM-126 Bedienungsanleitung

Smartwares

Smartwares RM520 Bedienungsanleitung

Smartwares

Smartwares FSM-114 Bedienungsanleitung

Smartwares

Smartwares RM149H Bedienungsanleitung

Smartwares

Smartwares RM218 Bedienungsanleitung

Smartwares

Smartwares RM220 Bedienungsanleitung

Smartwares

Smartwares RM520 Bedienungsanleitung

Smartwares

Smartwares SH8-90126 Bedienungsanleitung

Smartwares

Smartwares FSM-127 Bedienungsanleitung

Smartwares

Smartwares RM149A Bedienungsanleitung

Smartwares

Smartwares FSM-123 Bedienungsanleitung

Smartwares

Smartwares ELRO RM142F Bedienungsanleitung

Smartwares

Smartwares FSM-114 Bedienungsanleitung

Beliebte Rauchmelder Handbücher anderer Marken

x-sense

x-sense SD19-W Bedienungsanleitung

FireAngel

FireAngel Thermoptek ST-622 Bedienungsanleitung

teko

teko Astra-42A Bedienungsanleitung

Siemens

Siemens PE-11C Bedienungsanleitung

System Sensor

System Sensor DH500ACDC Bedienungsanleitung

Resolution Products

Resolution Products RE612 CryptiX Bedienungsanleitung

First Alert

First Alert PC900V Bedienungsanleitung

Eminent

Eminent EM6590 E-Domotica Bedienungsanleitung

Ei Electronics

Ei Electronics Ei Ei168RC Bedienungsanleitung

Carrier

Carrier Kidde Quell Q301 Bedienungsanleitung

VESDA

VESDA VLF-500 Bedienungsanleitung

ELRO

ELRO FS8110 Bedienungsanleitung

Heiman

Heiman SMOKI NS-626PHS Bedienungsanleitung

Family Gard

Family Gard FG225 Bedienungsanleitung

Regin

Regin SDD-S65 Bedienungsanleitung

Aparton

Aparton ASD-10 Bedienungsanleitung

Greystone

Greystone DSD120 Bedienungsanleitung

LST

LST ÜMS-55000-841 Bedienungsanleitung