Smeg FD260P Bedienungsanleitung
GB Instructions for use
Refrigerator-freezer
305888
We thank you for the confidence you have shown by purchasing our appliance.
We wish you a lot of pleasure using the appliance.
The refrigerator-freezer is intended for use in households.
The lower part is the refrigerator compartment intended for storing fresh food at temperatures
above 0°C.
The upper part is the freezer compartment intended for freezing fresh food and long-term storage
of frozen food (up to one year, depending on the type of food). This compartment is labeled with four
stars / asterisks.
Important warnings ..................................................... 3
A few tips on how to save power with your
refrigerator-freezer combo ........................................ 4
Appliance description................................................. 5
Installation and connection........................................ 6
Changing the door opening direction ....................... 8
Appliance operation.................................................. 10
Recommended food arrangement in the appliance13
Storing food in the refrigerator ................................ 14
Freezing fresh food and storing frozen food.......... 15
Defrosting the appliance........................................... 17
Cleaning the appliance ............................................. 19
Troubleshooting ........................................................ 20
Information on appliance noise ............................... 21
2
305888
• This appliance is manufactured in compliance with relevant
safety standards. However, it is still advisable it is not used
without due supervision by persons with diminished physical,
motoric, or mental capabilities or persons with inadequate
experience or knowledge. The same recommendation applies
to minors using the appliance.
• Before connecting the appliance, carefully read the instructions
for use which describe the appliance and its correct and safe
use. The instructions apply to several types/ models; therefore,
they may include descriptions of settings and equipment that
may not be available in your refrigerator.
• Remove the packaging that is intended for protecting the
appliance or its respective parts during transport.
• Spacers are fitted in the corners of the doors; these should
be removed and the plugs attached (only with some models)
should be inserted into the openings.
• Before connecting to the power mains, the appliance should
be left to stand still in upright position for at least 2 hours.
Thus, operation errors due to the effect of transport on the
cooling system will be much less likely to occur.
• The appliance must be connected to the power mains and
grounded in compliance with the effective standards and
regulations.
• The appliance may not be used outdoors and should not be
exposed to rain.
• The appliance must be disconnected from the power mains
(unplug the power cord from the wall outlet) before cleaning or
before replacing the bulb.
• If the power cord is damaged, it should be replaced by a
service technician or other authorized person.
• If the appliance is not used for a longer period of time, switch
it off with the relevant button and disconnect it from the power
mains. Empty the appliance, defrost it, clean it, and leave the
door ajar.
• To protect the environment, dispose of the appliance after its
useful life by taking it to an authorized waste collection center.
• The packaging is made of environment-friendly materials that
can be recycled, disposed of, or destroyed without hazard to
the environment.
• Children should not play with the appliance.
• The label with basic information on the appliance is attached in
the appliance interior. If the label is not in your local language,
replace it with the one supplied with the appliance.
• Warning! Ventilation slots on the appliance or a built-in
element must always be clean and unobstructed.
3
Important warnings
305888
• Warning! Do not use mechanical devices or tools to defrost the refrigerator, nor any other
methods except for those recommended by the manufacturer.
• Warning! When installing, cleaning, or removing the appliance, make sure the insulation on the
refrigeration system parts is not damaged. Thus you will also prevent damage to the environment.
• Warning! Do not use electric appliances in the refrigerator or freezer interior, except for those
expressly allowed by the refrigerator-freezer manufacturer.
The symbol on the product or on its packaging indicates that this product may not be
treated as household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused
by inappropriate waste handling of thisproduct. For more detailed information about
recycling of this product, please contact your local city office, your household waste
disposal service or the shop where you purchased the product.
• Observe the installation instructions.
• Do not open the appliance door more frequently than necessary.
• Occasionally check whether air can circulate freely behind the appliance.
• Condenser unit mounted on the appliance back wall must be kept clean at all times (see section
“Cleaning the appliance”).
• If the seal is damaged or loose, replace it as soon as possible.
• Store your food in closed containers or other appropriate packaging.
• Before placing the food in the refrigerator, let it cool down to room temperature.
• Defrost your frozen food in the refrigerator compartment.
• Remove the freezer drawers and door as described in the instructions, in order to make use of
the entire capacity.
• Defrost your conventional freezer when a frost layer approximately 3-5 millimetres thick has
accumulated on the surfaces in the freezer compartment.
• Make sure the shelves are evenly distributed and that the food is arranged in a way that
allows free circulation of air (heed the recommended food arrangement as described in the
instructions).
• In appliances fitted with a fan, do not block the fan slots.
4
A few tips on how to save power with your
refrigerator-freezer combo
305888
• Appliance interior equipment may change subject to appliance model.
• The drawers are protected against pulling out. If you wish to remove a drawer, pull it out as far as
it will go, then lift its front part and pull it out completely.
* Only with some models.
A Refrigerator compartment
B Freezer compartment
1 Control unit
2 Interior illumination lamp
3 Shelf (height adjustable)
4 Water discharge groove/gutter
5 Fruit and vegetables bin / drawer
6 Refrigerator door shelf (deep and shallow version)
7 Bottle shelf
8 Freezer shelf (height adjustable)
9 Freezer door shelf*
10 Foot
5
Appliance description
305888
• The appliance should be installed in a dry and well ventilated
room. The appliance will operate correctly if the environment
temperature is within the ranges listed in the table below.
The appliance class is indicated on the label with the basic
information on the appliance.
Class Temperature
SN (subnormal) from +10°C to +32°C
N (normal) from +16°C to +32°C
ST (subtropical) from +16°C to +38°C
T (tropical) from +16°C to +43°C
Appliance installation should be carried out by at least two
persons to avoid any physical injury or damage to the appliance.
• The appliance should stand firmly in an upright position on a
sufficiently solid base. At the front, the appliance is fitted with
two adjustable legs that can be used to level the appliance.
• If there is a kitchen furniture element above the appliance,
there should be a clearance of at least 5 centimeters between
this element and the refrigerator, to ensure sufficient cooling of
the condenser unit.
• Do not expose the appliance to direct sunlight and do not
place it near sources of heat. If this cannot be avoided, install
an insulation panel.
• The appliance may stand freely or it can be placed next to a
kitchen furniture element or a wall. Mind the space required
to open the door and pull out the drawers and shelves (see
installation diagram).
Selecting the room
Installing the appliance
6
Installation and connection
305888
• Use the power cord to connect the appliance to the power
mains. The wall outlet should be fitted with a ground contact
(safety socket). Nominal voltage and frequency are indicated
on the label with basic information on the appliance.
• The appliance should be connected to the power mains and
grounded in compliance with the relevant effective standards
and regulations. The appliance will withstand short-term
deviations from the nominal voltages, but not more than from
-6 % to +6%.
Connecting the
appliance
7
305888
Appliance: HZZS3067/ HZZS3067F
Tools required: ring spanner (box-end wrench) No. 8, screwdriver, torx25, flathead
screwdriver
1. Use a flathead screwdriver to remove the hole plugs/covers A and B1.
2. Unscrew and remove – one by one, in the specified order from top to bottom – the hinges (C, D,
and E1) and the door (F, G). Make sure the door is not damaged.
3. Move the hole plugs / covers (H) to the opposite side.
4. Attach the lower hinge (E2, supplied in a bag) to the opposite side of the housing and add the
washer (I).
5. Upper door (F): Move the upper hinge (C) with the bearing (J) to the opposite side. Remove the
door stopper with the hinge (K1) and attach a symmetrical door stopper (K2, supplied in a bag)
to the opposite side.
6. Lower door (G): move the hinges (L) and the cover (M) to the opposite side.
7. Install / attach, from bottom up, the hinges (D, C) and doors (G, F). Do not forget to install the
washers in the same way they were installed before disassembling (I).
8. Install the covers A and B2 (cover B2 from the supplied bag).
9. Replacing the handle: remove the hole plugs/covers, unscrew the screws and attach the
handle to the opposite side. Insert the plugs into the holes on the opposite side.
Save the elements B1, E1, and K1 in case you need them to change the door opening direction
again at a later time.
8
Changing the door opening direction
305888
Appliance: HZZS2767 / HZZS2767F
Tools required: socket wrench / spanner Nr. 8, slot and cross screwdriver
1. Use the slot screwdriver to remove the covers A and B.
2. Undo / remove the hinges (C, D, E1) and the door (F, G), starting from the top and working your
way down. Make sure the door is not damaged.
3. Move the covers (H) to the opposite side.
4. Upper compartment door (F): move the hinges (J) and the cover (M) to the opposite side.
5. Lower compartment door (G): move the hinges (L) and the cover (M) to the opposite side.
6. Start from the bottom and work your way up: attach and secure the lower hinge (E2) supplied in
a bag; mount the door (G); fasten the hinge (D); mount the door (F); and fasten the hinge (C). Do
not forget to use the washers, placing them as they were before the door was removed.
7. Attach the covers A and B.
8. Changing the handle position: remove the covers, undo the screws, and attach the handle to
the opposite side. Place the covers on the opposite side. Use the covers supplied in a bag to
cover the slot where the handle was initially attached.
Save the hinge E1 in case you need to change the direction of door opening again at a later time.
9
305888
A Temperature setting and on/off knob
B Super Freeze switch
Turn on: rotate the thermostat knob clockwise towards position 7.
Turn off: rotate the knob back to position STOP (0).
Setting the temperature
• Higher settings (towards 7) selected with the knob
correspond to lower (cooler) temperatures. The temperature
in the refrigerator interior may drop below 0°C. Only use
higher settings when a lower temperature is desired and
recommended or when environment temperature is lower than
16°C. When the environment temperature is normal, a medium
setting is recommended.
• A change in the environment temperature affects the
temperature in the appliance. Hence, the thermostat setting
should be adjusted accordingly.
• When the thermostat knob is set to position STOP (0), the
appliance will not operate (cooling system is off); however,
the appliance is still powered (a light will illuminate the interior
when the refrigerator door is opened).
Turning the appliance
on/off
CONTROL UNIT I
10
Appliance operation
Inhaltsverzeichnis
Andere Smeg Kühlschrank Handbücher
Smeg
Smeg FA35PX Bedienungsanleitung
Smeg
Smeg FD238AP Bedienungsanleitung
Smeg
Smeg SCV36X Bedienungsanleitung
Smeg
Smeg S7212LS2P1 Bedienungsanleitung
Smeg
Smeg FAB30QAZ Bedienungsanleitung
Smeg
Smeg FC20UXDNE Bedienungsanleitung
Smeg
Smeg FAB32RSV5 Bedienungsanleitung
Smeg
Smeg FD43PSNF2 Bedienungsanleitung
Smeg
Smeg FR150SE Betriebsanleitung
Smeg
Smeg FAB32X Bedienungsanleitung
Smeg
Smeg C3172NP1 Bedienungsanleitung
Smeg
Smeg FZ Bedienungsanleitung
Smeg
Smeg FC344BNF Bedienungsanleitung
Smeg
Smeg Fridge-freezer Bedienungsanleitung
Smeg
Smeg FR166SE Bedienungsanleitung
Smeg
Smeg Fridge Freezer CR325ANF Bedienungsanleitung
Smeg
Smeg FAB28AZ Bedienungsanleitung
Smeg
Smeg FQ60XPE Bedienungsanleitung
Smeg
Smeg FAB5RDGME5 Bedienungsanleitung
Smeg
Smeg F23-S Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
