Snapper 2690946 Handbuch
Tractor - Setup Instructions
1752827 (REV. -)
Attention Setup Personnel:
unit contain important information that must be followed
when assembling, setting-up, operating, servicing,
transporting, or storing the unit.
These warnings are highlighted by the safety alert
triangle symbol shown above, which signifies that an
important safety message is being provided.
You must read, understand, and follow these warnings
and instructions, and use safe shop and work practices
at all times while working on or around this unit and all
other outdoor power equipment.
The safety warnings
provided in this guide and
in the tractor's operator
manual included with the
This unit should NOT be delivered to a customer until
assembly has been completed according to these
instructions.
AVOID SERIOUS INJURY OR DEATH:
AVOID SERIOUS INJURY OR DEATH:
WARNING
Read and follow the tractor operator
manual before running engine.
Tools
EYE PROTECTION
WORK GLOVES
CUTTING SAW - packing crate
(optional)
PRY BAR
CUTTING TOOL for tie downs
WRENCHES
7/16˝,1/2˝, 15/16˝
TORQUE WRENCH
ANTI-SEIZE LUBRICANT
TIRE PRESSURE GAUGE
CLOTH (checking oil)
ANTI-SEIZE
lb-ft
( Nm)
Models
2690945
2690946
Note: Follow the procedures that apply to your model.
42˝
46˝
Not for
Reproduction
Using a saw, cut offtop crate (a) first, then cut crate
away from bottom pallet (b).
IMPORTANT NOTE: When cutting crate from bottom
pallet, use caution around tractor tires.
Uncrating
a
b
Note: Apply anti-seize lubricant to the steering shaft.
Then install steering wheel with center spoke facing
down.
Assemble Steering Wheel
Removing Tractor from
Shipping Pallet
Important: The hydraulic attachment lift and power
steering will not operate when the brake pedal is
engaged. Releasing the brake pedal restores operation.
Important: When the engine is not running, steering
ability is reduced. The tractor can still be maneuvered
by slowly turning the steering wheel.
1. Check to be sure there are no nails or sharp
objects on bottom of skid to puncture the tractor
tires.
2. Place a board in front of the pallet to act as a
step while unloading the tractor.
3. Place mower in the highest height of cut position.
4. Pull the roll release lever until it locks in the
release position.
5. Tap the brake pedal to release the parking brake.
6. Attach a strap or rope on axles as shown.
7. Pull the tractor offthe skid with a second person
guiding it.
8. After moving the tractor, re-engage the roll
release lever by pushing the lever into the drive
position.
1
7
6
2
5
+
6
5
4
3
2
1
34
8
ANTI-SEIZE
20 lb-ft (27 Nm)
1
2
3
4
15/16
2
Not for
Reproduction
Notes:
Assemble seat to seat support (a).
Fasten seat harness (b) to switch (c).
Fasten tie (d) as shown (zip tie is in literature pack).
3
Assemble Seat and Switch
Check Oil Level
Note: Engine is shipped with oil, however, oil should be
checked prior to use.
• Tractor should be on a level surface.
• Check oil level on dipstick.
• See Operator's Manual for complete instructions.
Charge / Connect Battery
WARNING
RISK OF BATTERY EXPLOSION FROM HYDROGEN
GAS MAY RESULT IN SERIOUS INJURY OR DEATH.
• ALWAYS wear safety glasses for your protection
while handling the battery.
• To avoid an explosion, keep flames and sparks away
from the battery, especially while charging.
• Battery acid causes severe burns. Avoid contact
with skin.
Note: If the unit is being put into service after the month
and year indicated on the battery date tag (a) (located
on top of battery) charge the battery before use.
• Remove ignition key.
• Charge battery according to the instructions
provided by the charger manufacturer.
Note: Read and understand any warnings by the
battery manufacturer.
• When charging is complete connect the NEGATIVE
(-) battery cables.
• Coat the cable ends and the battery terminals with
battery terminal protector.
Battery posts, terminals, and related
accessories contain lead and lead
compounds - chemicals known to the State of
California to cause cancer and reproductive
harm. Wash hands after handling.
13 lb-ft
(18 Nm)
1/2
c
b
d
a
1
2
3
( )
WARNING
DONOT REMOVE
COVER
7/16
APR 11
a
Not for
Reproduction
4
Tires are over-inflated for shipping purposes.
The maximum inflation is stamped on the sidewall of
the tires. Do not exceed the maximum tire pressure.
The recommended pressures shown below provide
proper traction, improve cut quality, and extended
tire life.
12-14 psi
(0,82-0,96 bar)
10 psi
(0,68 bar)
Check Tire Pressure Mower Leveling
PREPARATION
WARNING
For your personal safety, do not handle the sharp
mower blades with bare hands. Careless or
improper handling of blades may result in serious
injury.
See Operator's Manual for complete control panel
instructions.
Park tractor on a hard level surface.
Turn front wheels straight.
Place mower approximately in the
middle height of cut position.
Disengage mower blades.
Set parking brake.
Turn ignition OFF and remove key.
Disconnect spark plug wires and
place away from plugs.
Not for
Reproduction
5
SIDE-to-SIDE LEVELING
Arrange the blades (two rear blades - 46") so they
are pointing from side-to-side. Using a measuring tool,
measure the distance between the outside tips of each
blade (a / b) and the ground.
The difference should be: less than 1/8˝(3 mm).
IF AN ADJUSTMENT IS NEEDED:
Tighten / loosen nuts (c) (right and left side) as needed
to adjust side-to-side leveling.
MEASURING TOOL - for leveling mower
(4 inch / 100 mm - stiff card board)
FRONT-to-BACK LEVELING
Arrange the blades so they face front to back.
Using a measuring tool, measure:
(a) - the distance between the rear tip of one
of the back blades and the ground.
(b) - the distance between the front tip of the
center blade and the ground.
This should be the same as measurement (a).
Important: Side-to-side leveling must be performed
first.
9/16˝
a
b
a
c
c
b
42˝
46˝
42˝
46˝
a
b
a
b
ab
Not for
Reproduction
To LOWER the front of mower deck (b).
Turn locknuts (c) counterclockwise. Locknuts
must be turned evenly on both sides to keep deck
level (Side-to Side).
Recheck measurement (b).When correct, turn jam
nuts (d) counterclockwise against the bracket (e) to
secure.
IF AN ADJUSTMENT IS NEEDED:
IF AN ADJUSTMENT IS NEEDED:
To LOWER front of mower deck (b).
Turn locknuts (c) counterclockwise. Locknuts
must be turned evenly on both sides to keep
deck level (Side-to-Side).
Recheck measurement (b).
To RAISE front of mower deck (b).
Turn locknuts (c) clockwise. Locknuts must be
turned evenly on both sides to keep deck level
(Side-to-Side).
Recheck measurement (b).
42˝ 46˝
To RAISE front of deck (b).
Turn jam nuts (c) clockwise. Nuts must be turned
evenly on both sides to keep deck level (Side-to
Side). Turn locknuts (d) clockwise against the
spacer / bracket (e) to secure.
Recheck measurement (b).
3/4˝ 3/4˝ c
e
b
e
ee
dd
c
cc
d
3/4˝ 3/4˝
c
b
c
cc
6
Not for
Reproduction
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Snapper Rasenmäher Handbücher
Snapper
Snapper SPV2270HW Bedienungsanleitung
Snapper
Snapper 7800764 Bedienungsanleitung
Snapper
Snapper LT145H38GBV Bedienungs- und Wartungshandbuch
Snapper
Snapper 250815BE Bedienungsanleitung
Snapper
Snapper XL Series Bedienungsanleitung
Snapper
Snapper SP320 Bedienungs- und Wartungshandbuch
Snapper
Snapper Y30080, Y30081B, Y30120B, Y301 Bedienungsanleitung
Snapper
Snapper BH140G42AB Bedienungsanleitung
Snapper
Snapper 6413 Bedienungsanleitung
Snapper
Snapper SCRAMBLER YZ16335BVE Bedienungs- und Wartungshandbuch
Snapper
Snapper 5900859 Bedienungsanleitung
Snapper
Snapper SPE1250K, SPE140KW, SPE150KH, Bedienungs- und Wartungshandbuch
Snapper
Snapper 700 Bedienungsanleitung
Snapper
Snapper 21" Series 8 Bedienungsanleitung
Snapper
Snapper 7-4172 Handbuch
Snapper
Snapper EZT20500BV Bedienungsanleitung
Snapper
Snapper GM2515KAW Bedienungsanleitung
Snapper
Snapper ERP2187519BV, EP2187519BV Bedienungs- und Wartungshandbuch
Snapper
Snapper 21500PRC Bedienungs- und Wartungshandbuch
Snapper
Snapper 250612T Bedienungs- und Wartungshandbuch
Beliebte Rasenmäher Handbücher anderer Marken
TALEN TOOLS
TALEN TOOLS AVR HGM30 Bedienungsanleitung
DEWEZE
DEWEZE ATM-725 Bedienungsanleitung
Weed Eater
Weed Eater 180083 Bedienungsanleitung
Husqvarna
Husqvarna Poulan Pro PP185A42 Bedienungsanleitung
Better Outdoor Products
Better Outdoor Products Quick Series Bedienungsanleitung
Cub Cadet
Cub Cadet 23HP Z-Force 60 Betriebsanleitung
