Snapper CLT195420 (7800313) Handbuch

SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST for SNAPPER

19” STEEL DECK WALK BEHIND MOWERS

INTRODUCTION: The SNAPPER 19” Walk Behind Mowers are shipped almost fully assembled and require

minimal set-up. Complete each of the following steps carefully. Review and complete each item as instructed

on the Pre-Operation checklist. The Snapper Product Registration card must be filled out and sent to Customer

Service department at Snapper when completed.

STEP 1: Remove machine from shipping carton. Machine

is shipped in carton with handles disconnected. Remove

and discard cardboard from between all handles. Raise

upper handle until it is seated in both lower handles.

Securely tighten handle T-Knobs on both sides. Position

handles and secure with nuts and bolts to the lower deck

brackets. Tighten nuts and bolts securely. See Figure 1.

NOTE: Handles are mounted on the inside of the deck

brackets. Insert bolts so that the nuts will be towards the

inside of the brackets. See Figure 2.

FIGURE 1

IMPORTANT: DO NOT tip machine with carburetor or

spark plug down. Oil from crankcase will saturate the air

filter and cause the engine to be hard to start or not start

at all. If contamination does occur, the air filter will have to

be replaced.

STEP 2: Tip mower back against the upper handle to gain

access to cutting blade. Remove foam shipping block

from cutting blade. This must be removed before starting

the engine.

STEP 3: Route recoil rope up to rope guide on upper

handle. Move blade control bail up to handle. Pull recoil

handle to extend rope past guide. Insert rope into guide.

STEP 4: Handle height is adjustable for different height of

operators. Loosen the two nuts on the inside of each of

the lower handles. See Figure 2. Move the handle up or

down to the desired height. Retighten all nuts securely

after adjustment.

FIGURE 2

STEP 5: CHECKLIST: Complete all items on the Pre-

Operation Checklist as instructed.

INSTRUCTION NO. 7-5114 (I.R. 6/21/02)

T-KNOBS

LOWER HANDLE

NUTS

PER

HANDLE

LOWER

HANDLE

LOWER

BRACKETS

ROPE

GUIDE

RECOIL ROPE

BLADE

CONTROL BAIL

PRE-OPERATION CHECKLIST for SNAPPER

19” STEEL DECK WALK BEHIND MOWERS

Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due

to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be

verified and necessary final adjustments made at time of setup. It remains good practice and is strongly

recommended that all the items also be checked prior to placing the machine into service. It is very important

that setup is verified and all operational tests completed and results are acceptable. After completing this form,

sign and retain for future reference.

SET-UP

_____ FOAM SHIPPING BLOCK removed from cutting blade.

_____ UPPER HANDLE & LOWER HANDLE secured in place and hardware tightened securely.

_____ SIDE CHUTE, RECYCLING COVER or GRASS BAG installed on mower.

_____ BLADE retaining bolt(s) checked and tightened securely.

LUBRICATION

_____ ENGINE OIL added to bring level up to full mark on 4-cycle engines (Refer to Engine Manual).

OPERATIONAL TEST

_____ ENGINE started, engine control settings checked and adjusted as needed.

CPSC (Consumer Product Safety Commission) COMPLIANCE TEST

_____ BLADE CONTROL stops engine when released.

CONSUMER INFORMATION

Purchase Date ___________________ Model_______________________ Serial No.________________________

Retailers Name ___________________________________ Signature ____________________________________

Address _____________________________________ City ____________________ State _______ Zip _______

MOWER WILL BE USED COMMERCIALLY? _______ YES _____ NO

Purchaser’s Name _________________________________ Signature ____________________________________

Address ____________________________________ City _____________________ State _______ Zip _______

IMPORTANT: This form is to be retained for future reference regarding Warranty, proof of purchase, traceability

for product recall or service, etc. Complete the Product Registration Card and Mail to Customer Service

Department at SNAPPER, P.O. BOX 1379, McDonough, Georgia, 30253.

INSTRUCTION NO. 7-5114 (I.R. 6/21/02)

Dieses Handbuch passt für folgende Modelle

Andere Snapper Rasenmäher Handbücher

Snapper

Snapper SP60V Bedienungsanleitung

Snapper

Snapper 1685336 Bedienungsanleitung

Snapper

Snapper SGT27540D Bedienungsanleitung

Snapper

Snapper Z-RIDER ZM5202M Bedienungs- und Wartungshandbuch

Snapper

Snapper DLW359T Bedienungsanleitung

Snapper

Snapper EZF2100DKU, EZF2300GKU, EZF520 Bedienungs- und Wartungshandbuch

Snapper

Snapper Finishing Mower Bedienungsanleitung

Snapper

Snapper C21400R2, CP21400R2, CP21550V Bedienungs- und Wartungshandbuch

Snapper

Snapper "MR" SERIES 17 EMRP216017B Bedienungsanleitung

Snapper

Snapper LT23420 Bedienungsanleitung

Snapper

Snapper 7800604 Bedienungsanleitung

Snapper

Snapper 281323BVE (84876) Bedienungs- und Wartungshandbuch

Snapper

Snapper 2-8450 Handbuch

Snapper

Snapper 41085S Series Bedienungs- und Wartungshandbuch

Snapper

Snapper NP2167519B Bedienungs- und Wartungshandbuch

Snapper

Snapper MR216015T Bedienungs- und Wartungshandbuch

Snapper

Snapper LT160H42HBV Bedienungsanleitung

Snapper

Snapper 6124 Bedienungsanleitung

Snapper

Snapper 500Z Series Bedienungs- und Wartungshandbuch

Snapper

Snapper SP2265FC Bedienungsanleitung

Snapper

Snapper BH140G42AB Bedienungsanleitung

Snapper

Snapper PR5001 Bedienungsanleitung

Snapper

Snapper YARD CRUISER YZ145332BVE Bedienungs- und Wartungshandbuch

Snapper

Snapper NZM19480KWV Bedienungs- und Wartungshandbuch

Beliebte Rasenmäher Handbücher anderer Marken

RHINO

RHINO 1958 Bedienungsanleitung

Wolf Garten

Wolf Garten Compact plus 40 B Bedienungsanleitung

Cub Cadet

Cub Cadet LTX 1045 Bedienungsanleitung

GGP ITALY SPA

GGP ITALY SPA CR/CS 434 SERIES Bedienungsanleitung

Challenge

Challenge CH18V2 Betriebsanleitung

TALEN TOOLS

TALEN TOOLS AVR HGM30 Bedienungsanleitung

DEWEZE

DEWEZE ATM-725 Bedienungsanleitung

Weed Eater

Weed Eater 180083 Bedienungsanleitung

Husqvarna

Husqvarna Poulan Pro PP185A42 Bedienungsanleitung

Better Outdoor Products

Better Outdoor Products Quick Series Bedienungsanleitung

Cub Cadet

Cub Cadet 23HP Z-Force 60 Betriebsanleitung

MTD

MTD 795, 792, 791, 790 Bedienungsanleitung

Toro

Toro Groundsmaster 3505-D Bedienungsanleitung

Dennis

Dennis FT 610 Bedienungsanleitung

MTD

MTD 126-220-000 Bedienungsanleitung

Toro

Toro 74806 Bedienungsanleitung

Stihl

Stihl RMA 443 PV Bedienungsanleitung

Yard-Man

Yard-Man 3700-0 Bedienungsanleitung