This instrument is guaranteed to be free from defects in material and workmanship for a period of
one year from the date of original purchase. The probe is guaranteed to be free from defects in
material and workmanship for a period of six months from the date of original purchase. Damages
brought on by abuse, operator negligence, accident, misapplication, mishandling or acts of God will
void this warranty. This warranty is limited to the repair or replacement of the product at the
discretion of the manufacturer and will not include transportation costs. This product cannot be
returned without a return authorization number from Solaxx. For warranty support or a Return
Authorization number, log onto and click on support or email: www.solaxx.com
WARRANTY
Meter will not turn ON
PROBLEM
Salt Reading are
drifting or changing
TROUBLESHOOTING
Low Batteries
Batteries dead
Wrong Battery Polarity
CAUSE
Salt or Temperature
is out of range
Probe is dirty
Replace Batteries
Replace Batteries
Confirm batteries are installed
properly
SOLUTION
Make sure test sample is within
operating ranges.
Salt: 200-9800ppm
Temperature: 41-122°F (5-50°C)
Clean Probe with WATER ONLY and a soft sponge.
Check calibration after cleaning using directions on bottle
SALTDIP™ Pro QUICK START GUIDE
· Store the SALTDIP™ PRO inside carrying case and keep from extreme temperature.
· Remove metal probe guard and rinse the probe in fresh water after each use to avoid cross contamination
· To change the displayed temperature units between °C or °F:With the unit turned ON, press and hold START button
for 4 seconds.
Toggle °C/°F
4. Battery level indicator will show when low. Replace as necessary.
IMPORTANT! CARE AND STORAGE
3. Replace the battery compartment cap and make sure it is tightly secured to avoid water intrusion.
1. Peel back rubber casing from top of unit and twist off the battery compartment cap.
· Operating ranges: 41-122°F (5-50°C), 200-9800ppm (Salt and TDS).
2. Observe polarity on back of meter and Insert two AAA batteries.
· Auto-power off to save batter after 1 minute idle.
· 42x34mm viewing area LCD, Grey background with Black characters, White LED backlight.
Install Batteries (Requires two AAA batteries)
· Automatically saves last recorded reading until new measurement is taken.
· Temperature sensor: Selectable °C/°F system. Resolution: 0.1°C/.01°F (1°F if >=100°F).
Specifications / Features
· DO NOT soak the probe in any cleaning solution or chemicals. Doing so may cause degradation in performance.
When cleaning the probe, use fresh water only
