Solenco 5LLE Bedienungsanleitung

DEHUMIDIFIER

USER

MANUAL

MODEL:5LLE

CAUTION: NEVER CONNECT THE APPLIANCE TO AN EXTERNAL TIMER OR REMOVE THE

DEVICE FROM THE OUTLET WHILE IN OPERATION.

Use only the POWER button located on the control panel to turn the unit off. Failure to comply with

this safety precaution could damage the appliance and void the warranty.

Carefully read the instructions before operating the unit. This appliance is for indoor use only

and intended for use in a domestic environment only. Any other use is not recommended by

the manufacturer and may cause fire, electrical shocks or other injury to user or property.

Installation must be in accordance with regulations of the country where the unit is used.

Disconnect the power before dismantling, assembling, or cleaning. Avoid touching any

moving parts of the appliance. Never insert fingers, pencils, or any other objects though the

guard.

Do not leave children unsupervised with this appliance. Do not clean the unit by spraying it

or immersing it in water. Never connect the unit to an electrical outlet using an extension

cord. Never operate this appliance if the cord, power adapter or plug is damaged. A

damaged power supply cord should be replaced by the manufacturer or a qualified

electrician to avoid a hazard.

Any service other than regular cleaning or filter replacement should be performed by an

authorized service representative. Failure to comply could result in a voided warranty. Do not

use the appliance for any purpose other than its intended use.

Always place the unit on a dry and stable surface. The appliance should not be installed in

laundry or wet rooms where the humidity is higher than 85% RH. Do not dry laundry above the

unit to prevent water entering the dehumidifier. Place the laundry at least 1 meter away from

your dehumidifier.

If the appliance is installed, used, or stored in an unventilated room, the room must be such

as to prevent stagnation of possible leaks of refrigerant gas. Do not use the product and

contact the retailer for advice if damage has occurred to the unit which may have

compromised the refrigerant system. Any repairs or maintenance must only be carried out on

WARNING: THE APPLIANCE MUST WORK IN THE VERTICAL POSITION. DO NOT TURN IT OVER!

The dehumidifier must be stored and transported vertically; otherwise, irreparable damage to

the compressor may occur. You should wait for 24 hours with the appliance upright before

starting the appliance. Failure to do so may damage the unit and void the warranty.

If you turn off the dehumidifier, wait 10 minutes before turning it back on. This prevents the

compressor from being damaged.

SAFETY INSTRUCTIONS

ENERGY SAVING AND UNIT SAFETY PROTECTIONTIPS

FEATURES AND FUNCTIONS

the unit by a suitably qualified engineer. The refrigerant system should not be perforated or

punctured.

Do not cover or restrict the airflow from the outlet or inlet grills. For maximum

performance the minimum distance from a wall or objects should be 20 cm.

Keep the filters or grills of the unit clean. Under normal conditions, filters or grills should

only need cleaning once every three weeks (approximately).

Since the filters remove airborne particles, more frequent cleaning maybe necessary,

depending on the air quality. Wash the mesh filters with hot soapy water and dry them

before placing them back in the unit.

The dehumidifier uses compressor technology to extract water from the environment.

Compressor dehumidifiers are ideal for normal domestic or office environments which are

heated during the winter months and maintain a temperature above 12-15 oC.

The dehumidifiers are designed to extract unwanted humidity while saving money due to their

power saving logic. They feature an intelligent humidistat where the desired relative

humidity can be adjusted in increments of 5% between 35% and 80% ensuring your room is

not dried too much and power is not wasted.

Auto-Restart

If the unit stops unexpectedly due to the power cut, it will restart with the previous function

selected automatically when the power resumes, and the compressor will start after 3

minutes protection.

Features

Easyto use controls.

Cost effective way to combat mould, condensation, and damp.

Designed to complement any modern space.

IntelligentCPU controlled digital humidistat with 35%-80% RH and room humidity display.

24 hours start / stop timer.

Tank operation or permanent drainage option with splash proof tank

Water tank full alarm & auto -stop function.

Handle

Air outlet

Control panel

Water tank

Silicone pad

Air inlet

Pre-filter

Power cord

OVERVIEW OF THE COMPONENTS

POWER Button

Turn the appliance on/off.

MODE Button

Select

the

function

the

unit

between

SMART

and

FAN

modes.

The

corresponding light will show which mode is selected.

SMART MODE:

This is designed for maximum convenience and aims to reduce the relative humidity

to the level set and maintain the room at that level. The default level is 50% - 55%,

although this can be easily changed using the button.

FAN MODE:

Only the fan will run, and water is not extracted, which when used with filters will purify

the air.

HUMIDITY/ TIMER SETTING

In SMART mode press these buttons to select the desired relative humidity level.

Humidity level can be set within a range of 35% RH (Relative Humidity) to 80% RH in

5% increments. When it reaches 80%RH, press button again to 35%RH and repeat this circle.

Press Timer button, then press this button to adjust the timer (1-24hrs). When it reaches 24hrs,

press button again to 0hrs and repeat this circle.

CONTROL PANEL

TIMER

Press the TIMER button to program the timer. When the timer is activated the

"TIMER" light will be illuminated. Before programming the timer, ensure the timer

function has not been activated (the light must be off). The following timer programs are

available.

DELAYED POWER-ON FUNCTION:

With the appliance in stand-by, press the TIMER button, then use the

button to set in how many hours you require the unit to start (1~24 hours).

DELAYED POWER-OFF FUNCTION:

While the appliance is running with the desired settings, press the TIMER button, then

use the button to set in how many hours you require the unit to stop

(1~24 hours).

SLEEP / CHILD LOCK

Press this button to enter the sleep mode. The sleep indicator light is on. Other

indicator lights are off.

Press and hold this button for 3 seconds to enter the child lock mode. The child lock indicator

light is on, and other touch buttons are invalid; after pressing and holding this button for

another 3 seconds, the child lock indicator light is off, and other touch buttons are active

again.

Note: The SLEEP and CHILD LOCK functions are controlled by one button. When the SLEEP

function is off, press this button for three seconds enter the CHILD LOCK function, then the

SLEEP function will be turned on together. So, if you want to enter the CHILD LOCK function

only, you need turn on SLEEP mode first, press this button for three seconds. Then the SLEEP

function will be turned off and the CHILD LOCK function will be turned on.

Notes: When humidity level is outside the normal operational parameters will show LO/HI. If

ambient humidity is lower than 20%, it will show “LO”. If ambient humidity is higher than 90%, it

will show “HI”.

Your dehumidifier contains an advanced micro - CPU controlled device which is capable of

self- diagnostics. The LCD display may also show the error and protections codes.

INSTALLATION

POSITIONING THE DEHUMIDIFIER

TANK FULL

When the water tank is full, removed or incorrectly inserted the unit will stop

dehumidifying, the tank full light will illuminate, and the unit will beep. Empty

the tank and reinsert it correctly to resume operation.

HUMIDITY LEVEL & TIMER 2 DIGIT DISPLAY

The led indicator performs the following functions:

When the unit is plugged in, it will indicate the humidity level of the room.

When the button is pressed in the SMART mode, it will indicate the

desired humidity level.

When the button is pressed in the TIMER mode, it will indicate the

desired time you require the unit to start/stop.

Do not open windows or doors while the unit is running.

Place the unit on a hard / flat surface.

To reduce noise levels

Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the

unit is running.

A badly positioned dehumidifier will have little effect.

Please ensure circulation of air is not restricted around the unit.

Allow at least 20 cm space around the unit. This

dehumidifier is designed only for indoor residential or

small office applications.

WATER DRAINAGE

Use in an enclosed area for maximum efficiency. Close all doors, windows to create

an effective operating environment. Do not use outdoors.

Your dehumidifier will begin to protect your space from the harmful effects of

excessive moisture as soon as it is turned on. Excess moisture is dispersed throughout

your home. For this reason, the dehumidifier should be positioned in a central and

clear location so that it can draw this moist air towards it from all over the home. A

warm hallway or landing is an excellent position for your dehumidifier. If possible,

leave interior doors ajar to allow air circulation.

Alternatively, if you have a serious problem in one area you can begin by positioning

the dehumidifier there and moving it to a more central location later. For the most

effective use, run your dehumidifier with external doors and windows kept closed.

Please note the unit should not be placed directly against a radiator or other heat

source.

When positioning your dehumidifier, ensure that it is placed clear of any obstacle that

may limit the air movement. Place the dehumidifier on aflat dry surface.

When the water tank is full, the unit will stop automatically. When it happens, the tank full

light will show on the control panel.

There are two ways to dispense collected water.

1. USE THE WATER TANK

When the water tank is full, the unit will automatically stop running and the water tank

full indicator will flash.

Slowly pull out the watertank. Grip the water tank by its handle securely, and carefully

pull it out. Empty the water tank before reinserting it into the dehumidifier. The tank must

be in place and securely seated for the dehumidifier to operate again. The dehumidifier

will re-start when the tank is restored to its correct position.

NOTE:Only empty the water tank when it is full or before moving or storing the unit.

WARNING:Any commercial or industrial use will invalidate the warranty.

NOTE: The pipe has 1m long.

Do not remove any parts from the water tank or tank enclosure. The water full sensor will no

longer be able to detect the water level correctly and water may leak from the water tank.

2. CONTINUOUS DRAINAGE (OPTIONAL)

Water can be automatically plumbed in or drained into a sink, a larger recipient or

through the wall into an outside drain by attaching a pipe to the unit (10mm internal

diameter). Insert the pipe into the drain outlet at the back of the unit as shown here.

Make sure the connection between pipe and the drain outlet is tight and does not leak.

Then direct the pipe to a suitable drainage point.

This unit uses gravity to dispose of water hence the drain should be lower than the water

outlet on the unit. Put the water tank back. Be sure to run the water pipe downward and let

the water to flow out smoothly. Do not kink or bend the pipe.

NOTES:When you remove the water tank, do not touch sensors or any parts which are

situated behind the tank. Doing so may damage the product. Be sure to push the water tank gently

all the way into the unit. Banging the bucket against anything or failing to push it in securely

into place may cause the unit not to operate.

CAUTION: Do not splash water directly onto the main unit. Doing so may cause an electrical

shock and can lead to the insulation to deteriorate or cause the unit to rust.

Always shut off the unit and unplug from the mains before cleaning or performing any

maintenance. When it is not in use for long periods, it is advised to remove the plug from the

power socket.

Do not use chemical solvents (such as benzene, alcohol, or gasoline) as they may cause

irreversible damage to the unit.

Clean the grill and case.

· Use water and a mild detergent to clean the washable mesh filters. Do not use bleach

or abrasives.

The air intake and outlet grilles get soiled easily, so use a vacuum

attachment or soft brush to clean.

Wipe the dehumidifier body with a soft damp cloth or kitchen

towel.

If the mesh filter is dirty, hoover it. If it is heavily soiled, wash it with warm soapy water

and dry thoroughly before reinserting it in the unit.

When filter cleaning is finished and filters are dry, place them back into the unit.

CARE AND MAINTENANCE

Inhaltsverzeichnis

Andere Solenco Luftentfeuchter Handbücher

Solenco

Solenco UD30L Bedienungsanleitung

Beliebte Luftentfeuchter Handbücher anderer Marken

Daitsu

Daitsu CD031IU-DFA Bedienungsanleitung

Fehom

Fehom PDGT701BE Bedienungsanleitung

Hitachi

Hitachi RD-190GX Bedienungsanleitung

Westpoint

Westpoint MDF1-30AE Bedienungsanleitung

SOLIS

SOLIS easy dry compact Bedienungsanleitung

ENVIROBOSS

ENVIROBOSS EB240 Bedienungsanleitung

Sinclair

Sinclair R-9112 Bedienungsanleitung

Kenmore

Kenmore 580.54701 Bedienungsanleitung

Demargo

Demargo DM828NF Bedienungsanleitung

Altrad Lescha

Altrad Lescha LDH 600 Bedienungsanleitung

BOMANN

BOMANN LE 1150 CB Bedienungsanleitung

SPT

SPT SD-46 Bedienungsanleitung

REMKO

REMKO SLN 40 Bedienungsanleitung

Haier

Haier HD458 Bedienungsanleitung

Logik

Logik L20DHW12 Bedienungsanleitung

Frigidaire

Frigidaire FDR30S1 - 30 Pint Capacity Dehumidifier Kurzanleitung

Blitz

Blitz HHD Series Bedienungsanleitung

Prem-I-Air

Prem-I-Air PD14DEN Bedienungsanleitung