PRODUCT MANUAL
8-Zone RGB Remote Control
8-Zone RGB Remote Control
™
Toll Free: 866.592.3873
www.SolidApollo.com
HOW TO TURN OFF A ZONE, AND TURN ON A ZONE:
Any light zone can be turned o completely by pushing and holding a zone button:
1.With the Remote on, Press and Hold one of the 1-8 Zone Buttons until the lights turn o
2. Repeat this process to turn the lights back on, the turned o zone will not turn on using the
ON/OFF button.
HOW TO CHANGE COLOR OF LED LIGHTING FIXTURES:
You can change a single receiver color, brightness and saturation individually or in-group.
To change the color of a single receiver follow the following procedure:
1. Press the power button in the remote if the remote is o
2. Select the zone to be controlled pressing any of the 1-8 keys on the remote
3. Move your nger across the touch color wheel, until you see the color that you want
HOW TO CHANGE COLOR OF ALL THE LED LIGHTING FIXTURES SIMULTANEOUSLY:
To change the color of some or all the receivers follow the following procedure:
1. Press the power button in the remote if the remote is o.
2. Press in a rapid succession buttons from 1-8. For example, if we want to change the color of
receiver 1,2,3,4, and 5 we will press in a rapid succession the buttons from 1-5 and then use the
color wheel to change color of that group of receivers.
FAST SELECT OF COLOR AND FINE-TUNING COLORS:
The 4 color buttons (at right) are used to access a primary color quickly, and or to create mixing
of colors in a very easy way.
1. If you press the red button, you will see your selected receivers and LED lights turn to red. If
you press RED again, you will turn o the RED in all selected receivers. This principle applies for
the rest of the buttons (Green, Blue and White)
2. Mixing colors: You can create a mix of color by pressing 2 or more buttons. For example, if we
want to create a “purple color” we need to use RED and BLUE for this. Therefore press the red and
then the blue color.
3. Every time you press a color button, you either turn on the color or turn it o.
Example: If we press the red button, we will get RED lights. If then we press the Blue Button,
we will get, Purple (Red + Blue). If now we press the green button, we will get white lights (Red
+ Green + Blue). If we now press the blue button we will turn o the blue, but RED and green
will still be on, therefore creating yellow (Red + Green)
1.
1.
1.
1, 2, 3
2.
2. 3.
Press 1-5 in Rapid Succession
HOW TO FINE TUNE COLORS:
Imagine you want to create a very strong purple color made of the RED and
Blue colors. Nevertheless you don’t wish to have so much blue in the color mix.
You can increase and decrease the brightness of any of the colors individually, in this case we want
to decrease the Blue. First make sure that you have selected the zone you want to change using the
1-8 zone buttons on the remote, and that you have pressed the power button on the remote.
1. Tap the red button and you will see te lights in that zone turn red.
2. Now press the blue button for more than 2 seconds until the blue LED turns on.
3. Now place your finger in the rainbow color wheel and start moving your finger clockwise to in-
crease the Blue color until it reaches your taste.
You will see that if you move your finger around the color wheel you will increment the blue and
if you move your finger counter clockwise you will reduce the amount of blue in the color mix….
If you want to stop controlling the brightness press the “Blue” color button for
more than 2 seconds or until the LED light turns off.
Move Finger in
Circular Motion
1.
2.
3.
Page 6
...continued on next page
