4
This quick guide provides basic installation and commissioning guidance based on the Somfy
Rollixo RTS controller and safety edge solutions. Refer to the main Rollixo RTS controller and
safety edge installation guides where more in-depth information relating to the installation
procedure of the Rollixo RTS system is required.
Rollixo RTS Safety Edge Solutions
There is one Somfy hardwired safety edge solution available with the Rollixo RTS:
Rollixo RTS OSE - OSE stands for ‘Optical Safety Edge’.
This is supplied with a safety edge via a hard wired spiral cable and is connected to a Somfy optical
safety edge system. The optical safety edge consists of two optical cells mounted at each end of a
rubber profile. The cells project an optical beam through a hollow section of the profile, it becomes
obscured once the rubber profile is depressed. This in turn results in a signal from the safety edge,
indicating that an obstacle has been detected.
Aditional steps must be taken to ensure the straight edge of the door meets with the straight edge of a
floor extending into the guides. Failure to do so will result in; air + light gaps, false activations of the edge
etc.
“Please refer to the Installer Guide provided
with every Rollixo, here you will find the
basic principles and operating parameters
for any CE compliant safety edge system”
L1 L2N
M
1 2 3 4
Bleu
Marron
Noir
Green/Yellow
Brown
Blue
Black
L1 L2N
M
1 2 3 4
Bleu
Marron
Noir
Sec
Safety EdgeStop
K
5 6 7 8 9 1
Green/Yellow
Brown
Blue
Black
Sec
Safety EdgeStop
K
5 6 7 8 9 1
Connect the motor wires into terminals 1,
2, 3 and 4 as illustrated above.
Note: The motor direction can be reversed during the
commissioning procedure.
Secure the motor supply cable in
place with the cable clamp.
Rollixo RTS Solutions
Somfy motor wiring
✓
