Sony ECM HW1 Bedienungsanleitung
Sony EMCS Co.
2006A1600-1
©2006.01
Published by DI Technical Support Department
9-876-928-11
ECM-HW1
ECM-HW1
WIRELESS MICROPHONE
US Model
Canadian Model
AEP Model
E Model
Chinese Model
Korea Model
SERVICE MANUAL
Ver 1.0 2006. 01
SPECIFICATIONS
Wireless communication
Communication system Bluetooth specification Ver.1.2
Output Bluetooth specification Power Class 1
Compatible Bluetooth Profile Advanced Audio Distribution Profile
Working range* Approx. 30 m (100 ft.) (line of sight)
* Depending on recording location, such as if obstacles or reflective surfaces are
between Bluetooth devices, radio wave conditions, etc.
Receiver
Power requirements Supplied via Active Interface Shoe (approx. 7.2 V)
Power consumption Approx. 0.7 W (When the receiver is attached, the
operating time of the camcorder’s battery is
reduced by about 20%.)
Dimensions (w/h/d) Approx. 48 ×71 ×53 mm
(1
15
/
16
×2
7
/
8
×2
1
/
8
in.)
Mass Approx. 58 g (2 oz.)
Microphone (transmitter)
System Monaural, non-directional
Power requirements 3.0 V (two size AAA alkaline dry batteries or two
size AAA Ni-MH rechargeable batteries**)
** Batteries not included. Manganese dry batteries
should not be used.
Power consumption Approx. 0.6 W
Frequency response 300 - 9,000 Hz
Continuous operating time Approx. 3 hours
(With Sony alkaline dry batteries at 25 ºC (77 ºF))
When used at low temperature, the operating time
with alkaline dry batteries will shorten. Use of Ni-
MH rechargeable batteries is recommended.
Dimensions (w/h/d) Approx. 34 ×65 ×23 mm
(1
3
/
8
×2
5
/
8
×
29
/
32
in.) (excluding the clip)
Mass Approx. 25 g (0.9 oz.) (excluding the batteries and
the clip)
Receiver/microphone (transmitter)
Operating temperature 5 - 40 ºC (41 - 104 ºF)
Storage temperature –20 - 60 ºC (–4 - 140 ºF)
Included items
Receiver (ECM-HW1R) (1), Microphone (transmitter) (ECM-HW1T) (1), Clip
(attached to the microphone) (1), Neck strap (1), Wind screen (1), Carrying pouch
(1), Arm band (1), Set of printed documentation
Design and specifications are subject to change without notice.
(Receiver) (Microphone)
— 2 —
ECM-HW1
PARTS LIST
1 A-1181-026-A MICROPHONE RECEIVER ASSY (SERVICE)
2 2-657-617-01 LID, BATTERY
3 2-657-614-01 CASE, LOWER
4 A-1184-691-A CLIP
5 2-669-436-01 NECK STRAP
6 2-669-437-01 WIND SCREEN
7 2-669-438-01 ARM BAND
8 2-669-439-01 CARRYING POUCH
2-669-441-01 MANUAL, INSTRUCTION (JAPANESE/
ENGLISH/FRENCH/SPANISH/SIMPLIFIED CHINESE/
TRADITIONAL CHINESE/KOREAN)
*2-669-441-11 MANUAL, INSTRUCTION (GERMAN/DUTCH/
SWEDISH/PORTUGUESE/ITALIAN/
RUSSIAN/ARABIC)
Ref. No. Part No. Description
1
3
2
ns
ns
567
8
4
Note: When replaceing the microphone receiver assembly, be sure to change the labels (See the next page).
• Supplied accessories
— 3 —
ECM-HW1
1
Remove
the
serial number label from the service receiver.
2
Remove the model number plate from the part to be repaired, and attach it on the service part.
3
Attach the serial number label which is removed from the service receiver (
1
)
on the serial number part of the model number plate.
4
Remove the all labels except for the model number plate from the parts to be repaired,
and attach these labels to service parts.
1
Remove the all labels except for the battery label from the parts to be repaired,
and attach these labels to service parts.
Changing labels
Microphone
Receiver
Service receiver
(only with serial number label)
Service microphone
(only with battery label with serial No.)
(1) Because communication is possible only between the matched pair of this product when the product is shipped from the factory
or supplied as the repair part, the same serial number should be carried both by a microphone and a receiver that enables
identification of the matched pair among the mixed use of the multiple units.
(2) If the approved certificate labels of the respective countries in which this product is marketed and customer uses is not attached
to the product before use, ignorance of this requirement may be punishable.
Repaired microphone
(with all the labels except for the battery
label from the part to be repaired)
Leave the battery label.
Repaired receiver
(with all labels from the part to be repaired)
Model number
plate
Korea label (T)
(Korea model only),
Taiwan label (R)/
Chaina label (R)
(Chinese model only)
Korea label (T)
(Korea model only),
Taiwan label (R)/
Chaina label (R)
(Chinese model only)
Model number plate
WEEE label
(AEP model only)
Serial number label
Serial number part
Revision History
987692811.pdf
ECM-HW1
Ver.
1.0
Date
2006.01
History
Official Release
Contents
—
S.M. Rev.
issued
—
Reverse
Inhaltsverzeichnis
Andere Sony Mikrofon Handbücher
Sony
Sony WRT-807A Bedienungsanleitung
Sony
Sony C-38B Bedienungsanleitung
Sony
Sony ECM-011 Bedienungsanleitung
Sony
Sony ECM HW1 Bedienungsanleitung
Sony
Sony ECM-S1 Referenzhandbuch
Sony
Sony ECM-W3 Referenzhandbuch
Sony
Sony ECM680S Bedienungsanleitung
Sony
Sony DWZ Series Bedienungsanleitung
Sony
Sony ECM-166BMP Bedienungsanleitung
Sony
Sony F-V310 Bedienungsanleitung
Sony
Sony SXA-J750 Bedienungsanleitung
Sony
Sony UWP-C1 Bedienungsanleitung
Sony
Sony WRT-807B Bedienungsanleitung
Sony
Sony ECM-TL3 Bedienungsanleitung
Sony
Sony ECM680S Bedienungsanleitung
Sony
Sony Electret Bedienungsanleitung
Sony
Sony ECM-W1M Bedienungsanleitung
Sony
Sony ECM-ALST1 Bedienungsanleitung
Sony
Sony handycam ecm-hst1 Bedienungsanleitung
Sony
Sony ECM-33F Einrichtungshandbuch
Beliebte Mikrofon Handbücher anderer Marken
IK Multimedia
IK Multimedia iRig Stream MIC PRO Bedienungsanleitung
DAPAudio
DAPAudio RM-101 Bedienungsanleitung
AKG
AKG CHM 21 Bedienungsanleitung
Sennheiser
Sennheiser evolution wireless series EM 100 Bedienungsanleitung
GIGAMEDIA
GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung
Shure
Shure WH30TQG Bedienungsanleitung
