Sony ECM-Z60 Bedienungsanleitung

ECM-Z60

US Model

Canadian Model

AEP Model

E Model

SERVICE MANUAL

ELECTRET CONDENSER MICROPHONE

SPECIFICATIONS

Type Electret condenser microphone

Dimensions Microphone parts:

16 ×106 ×22 mm (21/32 ×41/4×7/8in.)(diameter/

length/height)

(Maximum width of stand: 26 mm (11/16 in.))

Battery box parts:

40 ×16.5 ×46 mm (w/h/d)

(15/8×21/32 ×113/16 in.)

Mass Microphone parts (including cord):

Approx. 21 g (0.75 oz.)

Battery box parts (including lithium battery and

cord):

Approx. 17 g (0.6 oz.)

Cord Microphone parts:

OFC litz cord (1 cord shielded)

1.5 mm (1/16 in.) dia.

Length: approx. 1 m (393/8in.)

Battery box parts:

OFC litz cord (2 core shielded)

2.2 mm (3/32 in.) dia.

Length: approx. 0.3 m (117/8in.)

Supplied accessories

Battery box (1)

Frequency response

100 -10,000 Hz

Directivity Super-directional

Output impedance

2.8 kΩ± 30 %

Sensitivity Open circuit output voltage

level –36 ± 3.5 dB

0 dB = 1 V / Pa, 1,000 Hz

(1 Pa = 10 µbar = 94 dB SPL)

Battery life Approx. 300 hours (with Sony CR2025 lithium

battery (not supplied)

Maximum sound pressure input level

Approx. 102 dBSPL

1 % wave distortion at 1,000 Hz

(0 dBSPL = 2 ×10 -5 Pa)

Operating temprerature range

0 °C –40 °C (32 °F –104 °F)

Design and specifications are subject to change without notice.

SECTION 1

GENERAL Thissectionis extractedfrom

instruction manual.

1POWER switch

2Battery check indicator

3L-shaped monaural miniplug (gold plated)

4Battery box

5Microphone jack

6L-shaped monaural miniplug (gold plated)

7Battery compartment

8Microphone

9Attached microphone stand

— 2 —

Notes on chip component replacement

• Never reuse a disconnected chip component.

• Notice that the minus side of a tantalum capacitor may be

damaged by heat.

Flexible Circuit Board Repairing

• Keep the temperature of soldering iron around 270˚C

during repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

ADVARSEL

Eksplosjonsfare ved feilaktig skifte av batteri.

Benytt samme batteritype eller en tilsvarende type

anbefalt av apparatfabrikanten.

Brukte batterier kasseres i henhold til fabrikantens

instruksjoner.

VARNING

Explosionsfara vid felaktigt batteribyte.

Använd samma batterityp eller en likvärdig typ som

rekommenderas av apparattillverkaren.

Kassera använt batteri enligt gällande föreskrifter.

VAROITUS

Paristo voi räjähtää, jos se on virheellisesti asennettu.

Vaihda paristo ainoastaan laitevalmistajan suosittelemaan tyyppiin.

Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.

ADVARSEL!

Lithiumbatteri-Eksplosionsfare ved fejlagtig håndtering.

Udskiftning må kun ske med batteri

af samme fabrikat og type.

Levér det brugte batteri tilbage til leverandøren.

CAUTION

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by

the manufacturer.

Discard used batteries according to the manufacturer’s instructions.

Ver 1.0 2000.2

ECM-Z60 SECTION 2

DIAGRAMS

2-1. SCHEMATIC DIAGRAM

— 3 — — 4 —

Note on Schematic Diagram:

• All capacitors are in µF unless otherwise noted. pF: µµF

50 WV or less are not indicated except for electrolytics

and tantalums.

• All resistors are in Ωand 1/4W or less unless otherwise

specified.

• % : indicates tolerance.

•C: panel designation.

• Signal path.

F: MIC

TOTAL CURRENT : 0.21mA

LITHIUM BATTERY

UDZ4.7B

2-2. PRINTEDWIRING BOARD

AMP BOARD (SIDE B)

UNIT BOARD

(SIDE B)

UNIT BOARD

(SIDE A)

AMP BOARD (SIDE A)

1-671-999-

(11)

1-671-999- 11

(11)

1-672-000-

(11)

1-672-000-

(11)

MIC IN

SW1

POWER

D10

R13

JC1

C14

C1 C2

OFF

SW1

(MIC OUT) MINI

PLUG

(MIC OUT)

MIC1

MINI

PLUG

LITHIUM

BATTERY

CR-2025

MIC UNIT

BATTERY

CHECK

LAMP

34567

Note on Printed Wiring Board:

•X: parts extracted from the component side.

•a:Through hole.

•b: Pattern from the side which enables seeing.

Caution:

Pattern face side: Partsonthe patternfaceside seenfrom

(Conductor B) the pattern face are indicated.

Parts face side: Parts on the parts face side seen from

(Component A) the parts face are indicated.

Ref. No. Location

D1 F-2

D2 F-2

D3 D-2

D10 B-4

• Semiconductor

Location

—5 — — 6 —

SECTION 3

EXPLODEDVIEWS

NOTE:

•-XX, -X mean standardized parts, so they may

have some differences from the original one.

•Items marked “*”are not stocked since they

are seldom required for routine service. Some

delayshould be anticipated when ordering these

items.

•Themechanical parts with noreference number

in the exploded views are not supplied.

•Aaccessories and packing materials are given

in the last of this parts list.

3-1. BATTERY BOX SECTION

3-2. MICROPHONE SECTION

MIC1

not supplied

Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks

1 1-790-104-11 CORD,MICROPHONE (1 CORE)

2 2-545-592-01 BUSHING

4 X-2542-165-1 CASE(UPPER) ASSY, BATTERY

5 2-545-588-01 KNOB,SWITCH

*6 A-4542-610-A AMP BOARD, COMPLETE

7 2-545-589-01 TERMINAL, PLUS

8 2-545-590-01 TERMINAL, MINUS

9 2-545-599-01 SHEET, BLIND

10 2-545-586-01 CASE(LOWER), BATTERY

11 2-545-587-01 HOLDER, BATTERY

12 2-545-953-01 LABEL, MODEL NUMBER

#1 7-685-103-19 SCREW +P 2X5 TYPE2 NON-SLIT

51 X-2542-196-1 CAPASSY, FRONT

52 2-545-947-01 CAP,REAR

53 2-545-944-01 CASE(R)

54 2-545-943-01 CASE(L)

55 2-545-951-01 FOOT, RUBBER

56 1-791-753-11 CORD, MICROPHONE

57 2-545-948-01 HOLDER, STAND

58 2-545-952-01 SCREEN, CASE

59 X-2542-197-1 STAND ASSY

*60 1-671-999-11 UNIT BOARD

MIC1 1-418-258-11 MICROPHONE UNIT

#1 7-685-103-19 SCREW +P 2X5 TYPE2 NON-SLIT

Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks

SECTION 4

ELECTRICAL PARTS LIST

NOTE:

•Due to standardization, replacements in the

parts list may be different from the parts

specifiedinthediagrams or the components

used on the set.

•-XX, -X mean standardized parts, so they

may have some difference from the original

one.

•Items marked “*”are not stocked since they

are seldom required for routine service.

Some delay should be anticipated when

ordering these items.

•CAPACITORS:

uF: µF

•RESISTORS

All resistors are in ohms.

METAL: metal-film resistor

METAL OXIDE: Metal Oxide-film resistor

F: nonflammable

•COILS

uH: µH

•SEMICONDUCTORS

In each case, u: µ, for example:

uA...: µA... , uPA... , µPA... ,

uPB... , µPB... , uPC... , µPC... ,

uPD..., µPD...

When indicating parts by reference number,

please include the board name.

*A-4542-610-A AMP BOARD, COMPLETE

********************

< CAPACITOR >

C1 1-119-749-11 CAP, CHIP TANTALUM ELECT 33MF

C2 1-110-569-11 CAP, CHIP TANTALUM ELECT 47MF

C14 1-164-222-11 CAP, CERAMIC 0.22uF (2012)

< DIODE >

D1 8-719-072-95 DIODE 015AZ3.9-X-TPL3

D2 8-719-063-83 LED SML-510MWT86(BATTERY CHECK LAMP)

D3 8-719-056-29 DIODE 015AZ4.7-TPL3

< JACK >

J1 1-764-624-41 JACK (MIC IN)

< JUMPER >

JC1 1-216-864-11 CONDUCTOR, CHIP (1608)

< RESISTOR >

R1 1-216-833-11 RES, CHIP 10K (1608)

R3 1-216-813-11 RES, CHIP 220 (1608)

R13 1-216-827-11 RES, CHIP 3.3K (1608)

< SWITCH >

SW1 1-692-397-21 SWITCH, SLIDE (POWER)

**************************************************************

*1-671-999-11 UNIT BOARD

**********

< DIODE >

D10 8-719-976-96 DIODE DTZ4.7C

**************************************************************

MISCELLANEOUS

**************

1 1-790-104-11 CORD, MICROPHONE (1 CORE)

56 1-791-753-11 CORD, MICROPHONE

MIC1 1-418-258-11 MICROPHONE UNIT

**************************************************************

ACCESSORIES & PACKING MATERIALS

********************************

3-043-185-11 MANUAL, INSTRUCTION

(ENGLISH/FRENCH/SPANISH)

3-043-185-21 MANUAL, INSTRUCTION

(GERMAN,ITALIAN,PORTUGUESE)(AEP.E)

AMP UNIT

ECM-Z60

—8 —

Sony Corporation

Personal Audio Division Company 2000B1674-1

Published by General Engineering Dept.

9-927-604-11

—7 —

Andere Sony Mikrofon Handbücher

Sony

Sony FV 820 Bedienungsanleitung

Sony

Sony ECM Z60 Bedienungsanleitung

Sony

Sony ECM-PC60 Bedienungsanleitung

Sony

Sony F-112 Bedienungsanleitung

Sony

Sony ECM-W3 Referenzhandbuch

Sony

Sony Electret ECM-Z37C Bedienungsanleitung

Sony

Sony ECM-LV1 Bedienungsanleitung

Sony

Sony ECM66B Bedienungsanleitung

Sony

Sony ECM-55B Bedienungsanleitung

Sony

Sony C-357 Bedienungsanleitung

Sony

Sony ECM-S200 Bedienungsanleitung

Sony

Sony C-47 Bedienungsanleitung

Sony

Sony DWM-01 Bedienungsanleitung

Sony

Sony ECM ZS90 Bedienungsanleitung

Sony

Sony ECM T6 Bedienungsanleitung

Sony

Sony ECM-55B Bedienungsanleitung

Sony

Sony ECM-W2BT Referenzhandbuch

Sony

Sony STM10 Bedienungsanleitung

Sony

Sony C-55P Technisches Dokument

Sony

Sony XA-MC10 Bedienungsanleitung

Sony

Sony C-38B Bedienungsanleitung

Sony

Sony ECM MS908C Bedienungsanleitung

Sony

Sony ECM-S930C Bedienungsanleitung

Sony

Sony ECM-77B Bedienungsanleitung

Beliebte Mikrofon Handbücher anderer Marken

IK Multimedia

IK Multimedia iRig Stream MIC PRO Bedienungsanleitung

DAPAudio

DAPAudio RM-101 Bedienungsanleitung

AKG

AKG CHM 21 Bedienungsanleitung

Sennheiser

Sennheiser evolution wireless series EM 100 Bedienungsanleitung

GIGAMEDIA

GIGAMEDIA GGM PAMICUHFG Bedienungsanleitung

Shure

Shure WH30TQG Bedienungsanleitung

auna PRO

auna PRO MIC-900 Bedienungsanleitung

AKG

AKG D 3800 Bedienungsanleitung

Shure

Shure KSM141 Bedienungsanleitung

MAIIN SOUND

MAIIN SOUND IIN style Bedienungsanleitung

Earthworks

Earthworks TC25 Bedienungsanleitung

Sennheiser

Sennheiser evolution D1 Bedienungsanleitung

Alesis

Alesis MicLink Wireless Bedienungsanleitung

DSPPA

DSPPA D6234 Bedienungsanleitung

Monacor

Monacor IMG STAGELINE ECM-300B Bedienungsanleitung

Ansr Audio

Ansr Audio Scan16 Bedienungsanleitung

Shure

Shure MXA710 Series Bedienungsanleitung

JLab

JLab GO TALK Bedienungsanleitung