Sony AS-FCB-HDSDI-IFKIT Series Bedienungsanleitung

         

Version 1.0 October 2010

Page 1 of 2

AS-FCB-HDSDI-QS-GUIDE

Sony FCB-H11 – HD-SDI Interface

Part Number: AS-FCB-HDSDI-IFKIT-x



Connecting the Adapter Board to the Camera

There are five cables supplied with the kit – a 10 way video ribbon cable, a 24 way flat

cable, a power cable, a 75ΩMCX to BNC adapter and a breakout cable for video pass

through and RS-232 communications. Depending on the kit ordered, a bracket is also

supplied to fix the Adapter Board to the camera.

Video Ribbon Cable

1. Important: This uses special coaxial cables, and unlike conventional ribbon cables it

must not be folded or creased, e.g. to help give a neat cable run.

2. Connect one end of this cable into J4 on the Adapter Board, and the other end into

the matching connector on the top on the camera towards the lens end. The side of

the cable with the gold contacts faces away from the board. See photos below:

Flat Cable

s used, it is easiest to fit the cable to the Adapter Board before

the rear of the Adapter Board as follows.

24 Way

1. Note: If the bracket i

fitting the Adapter Board to the bracket.

2. Connect one end of this cable into J5 on

3. First “hinge” open the retaining clip by simultaneously lifting both brown tabs at the

ends of the connector.

Active Silicon www.activesilicon.com

         

Version 1.0 October 2010

Page 2 of 2

AS-FCB-HDSDI-QS-GUIDE



4. Carefully slide the end of the cable into the connector. The metal contacts of the

cable face away from the board, and the cable should be inserted between the brown

“ledge” of the retaining clip and the light coloured body (i.e. not between the retaining

clip and the board).

5. Lock the cable in place by simultaneously pressing down both brown tabs at the ends

of the connector.

6. See photos below:

7. Similarly the other end plugs into the connector on the side of the camera, and

furthest from the lens. With this connector the metal contacts face the board, and the

cable should be inserted close to the board.

Power Cable

1. This plugs into J2 on the Adapter Board.

2. The other end of the cable is terminated in tinned wires which can be connected as

appropriate for the application.

3. Pin 1 (marked on the cable) should be connected to 9V DC, and pins 2 & 3 to 0V.

This cable powers both the camera and the Adapter Board. The Adapter Board takes

an additional 20mA (approx), and works over the same supply tolerance as the

camera (±3V).

MCX to BNC Cable

1. This plugs into J1 on the Adapter Board until it clicks.

Video Pass Through and Control Cable

1. This plugs into J3 on the Adapter Board. Please see the ACTIVE-FCB-HDSDI

datasheet for pin connection details.

Fitting the Bracket

1. The Adapter Board is simply screwed to the base of the camera using four M2

screws (supplied).

LED Activity

1. The Adapter Board is fitted with a LED to show the camera status.

2. Green indicates that the camera is powered and providing valid video data.

3. Red indicates that the Adapter Board is powered but no valid video data is being

received. Ensure that the 10 way video cable and the 24 way flat cable are correctly

connected to the Adapter Board and the camera.

SUPPORT

USA Europe

Email: [email protected]m [email protected]

Web: www.activesilicon.com www.activesilicon.co.uk

Tel: +1 410-696-7642 +44 (0) 1753 650600

Active Silicon www.activesilicon.com

Inhaltsverzeichnis

Andere Sony Aufnahmegeräte Handbücher

Sony

Sony CXFD-S03CP Bedienungsanleitung

Sony

Sony BVT-2000 Bedienungsanleitung

Sony

Sony MG10-P1 Bedienungsanleitung

Sony

Sony XDCAM PDW-HD1200 Bedienungsanleitung

Sony

Sony BKM-103 Bedienungsanleitung

Sony

Sony ICD-SX713/ICD-SX813 Bedienungsanleitung

Sony

Sony BDX-N1000 Bedienungsanleitung

Sony

Sony SB-V66S Bedienungsanleitung

Sony

Sony CFD-RS60CP Bedienungsanleitung

Sony

Sony Walkman PCM-M1 Bedienungsanleitung

Sony

Sony TCM-4300 Bedienungsanleitung

Sony

Sony XE-8 - Graphic Equalizer Bedienungsanleitung

Sony

Sony SB-V3000 Bedienungsanleitung

Sony

Sony SRW-1 Bedienungsanleitung

Sony

Sony XDCAM PDW-HD1500 Bedienungsanleitung

Sony

Sony DPS-V77 Bedienungsanleitung

Sony

Sony TC-377 Einrichtungshandbuch

Sony

Sony TC-366 Einrichtungshandbuch

Sony

Sony DEP-100 Bedienungsanleitung

Sony

Sony PCM-R300 Bedienungsanleitung

Sony

Sony TC-177SD Einrichtungshandbuch

Sony

Sony Walkman PCM-M1 Bedienungsanleitung

Sony

Sony XDCAM EX PMW-EX30 Bedienungsanleitung

Sony

Sony MSW-2000P SERIES Installationsanleitung

Beliebte Aufnahmegeräte Handbücher anderer Marken

KV2 Audio

KV2 Audio 500 Series Bedienungsanleitung

Robotics Technologies

Robotics Technologies microBus-Cam II Bedienungsanleitung

Seca

Seca 460 Bedienungsanleitung

Cognex

Cognex MVS-8000 Series Bedienungsanleitung

Mect

Mect MPNC006 Series Bedienungsanleitung

Bad Caf

Bad Caf THE LEASH Bedienungsanleitung

Strymon

Strymon NIGHTSKY Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Bedienungsanleitung

Tews Technologies

Tews Technologies TPMC465 Bedienungsanleitung

Honeywell

Honeywell Excel 50 Bedienungsanleitung

SeaLevel

SeaLevel COMM+8.LPCI Bedienungsanleitung

Arturia

Arturia AUDIOFUSE STUDIO Bedienungsanleitung

Rukra

Rukra RK-1240 Bedienungsanleitung

Samson

Samson SCOM Bedienungsanleitung

Dynacord

Dynacord DPS260 Bedienungsanleitung

Pyle Pro

Pyle Pro PSS8 Bedienungsanleitung

Nice

Nice Core Bedienungsanleitung

RF-System

RF-System TinyGate Gebrauchs- und Pflegehandbuch