Page 7/17
Assembly Instructions
MINI Control
www.sorotec.de V 1.0.0
Assembly of the modules
Motherboard („MiniBOB“)
For this section you will need: #
1 Motherboard 4
4 Cylinderhead screw M3 x 6 35
4 Spacer nut M3 x 18 28
2 Spacer nut M3 x 20 29
1Fuse 2 A 18
Note
Before you touch one of the circuit boards, always
rst touch a good conductive earth connection
(e.g. a water pipe) in order to dissipate any static
charge that may be present.
• Assemble the main circuit board 4with
cylinder head screws 35 and the spacers 28
and 29 , as shown in Fig. 9.
• Insert the 2 A fuse 18 into the fuse holder.
Fig. 9: Motherboard
4
18
35
35
28 29
Jumper
• Check the jumpers on the circuit board.
Without using the optional axis extension, the
jumper contacts of CH-A and CH-B should be
unassigned.Ifnecessary,youcanndtheexact
assignment in the option description on page 16.
The jumpers on the main circuit board from top
to bottom (see also Fig. 10 and sheet 4/5 of the
circuit diagram):
1. n/a
2. Probe: Tool length sensor connection to main
board (“MB” for motherboard) or to IO module
(“HomeA”, 4th channel). Default is MB.
3. LPT24: For Beamicon „HomeA“, other „GND“.
4. WDT: not used
5. AUXS: AUX selectable. The default is „OPT2“.
When using the optional IO module FC laser
alarm „OPT1“.
6. ESTOP-Signal: Type of emergency stop
release. For EstlCam and Benezan „H-active“
(default).
Attention!
Correct setting of the jumpers is absolutely essen-
tial for the correct functioning of the control. If you
have any questions, we are happy to answer them
by phone.
Fig. 10: Jumper setting for EstlCam without option modules
