- 1 -
Version 1.2 October 2023
IMPORTANT SAFETY INFORMATION
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
DO NOT EXPOSE TO RAIN OR MOISTURE.
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of
uninsulated "dangerous voltage" within the product's enclosure. It may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating
and maintenance (servicing) instructions in the literature accompanying the product.
W rnings
Connect this unit’s power supply to an AC outlet of the type stated in this Owner’s Manual or as marked on the
unit. Failure to do so is a fire and electrical shock hazard.
Do not allow water to enter this unit or allow the unit to become wet. Fire or electrical shock may result.
Do not place a container with liquid or small metal objects on top of this unit. Liquid or metal objects inside this
unit are a fire and electrical shock hazard.
Do not remove the unit’s cover. You could receive an electrical shock. If you think internal inspection,
maintenance, or repair is necessary, contact your dealer.
Do not modify the unit. Doing so is a fire and electrical shock hazard.
If the power supply cord is damaged (i.e., cut or a bare wire is exposed), ask your dealer for a replacement.
Using the unit with a damaged power cord is a fire and electrical shock hazard.
If you notice any abnormality, such as smoke, odor, or noise, or if a foreign object or liquid gets inside the unit,
turn it off immediately. Remove the power supply from the AC outlet. Consult your dealer for repair. Using the
unit in this condition is a fire and electrical shock hazard.
The antennas should be mounted at least 20cm or 8 inches from a nearby person.
C utions
Keep this unit away from the following locations:
o Locations exposed to oil splashes or steam.
o Unstable surfaces, such as a wobbly table or slope.
o Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that
produce large quantities of heat.
o Locations subject to excessive humidity or dust accumulation.
o Metal objects that can interfere with its radio transmission.
Do not touch the power plug with wet hands. Doing so is a potential electrical shock hazard.
Certific tions
FCC ID: MCQ-X EEPRO2
The enclosed device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (i.)
this device may not cause harmful interference and (ii.) this device must accept any interference received, including
interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures: Re-orient or relocate the receiving antenna, Increase the separation between the equipment and
transmitter, or connect equipment and transmitter to outlets on different circuits.
