Sound Storm SCD-450R Bedienungsanleitung

INSTALLATION

Notes:

• Choose the mounting location where the unit will not interfere with the normal

driving function.

• Before final installation, connect the wiring temporarily and make sure the unit and

the system work properly.

• Use only the parts included with the unit to ensure proper installation. The use of

unauthorized parts can cause malfunctions.

• Consult with your nearest dealer if installation requires the drilling of holes or other

modifications of the vehicle.

• Install the unit where it does not get in the driver’s way and cannot injure the

passenger if there is a sudden stop, like an emergency stop.

• If installation angle exceeds 30˚ from horizontal, the unit might not give its optimum

performance.

• Avoid installing the unit where it would be subject to high temperature, such as from

direct sunlight, from hot air of the heater, or where it would be subject to dust, dirt

or excessive vibration.

DIN FRONT/REAR-MOUNT

This unit can be properly installed either from “Front” (conventional DIN Front-mount)

or “Rear” (DIN Rear-mount installation, utilizing threaded screw holes at the sides of

the unit chassis). For details, refer to the following illustrated installation methods.

DIN FRONT-MOUNT (Method A)

Installation of the unit

1. Dashboard

2. Mounting Bracket

After inserting the mounting bracket into

the dashboard, select the appropriate

tabs according to the thickness of the

dashboard material and bend them

outward to secure the holder in place.

3. Screw

30˚

182

(Fig. 1)

1. Dashboard

2. Nut (5mm)

3. Spring washer

4. Screw (5 x 25mm)

5. Screw (5 x 28mm)

6. Backstrap

Be sure to use the backstrap to secure

the back of the unit in place. The strap

can be bent by hand to the desired angle.

7. Plain washer

Removing the unit

1. Frame

2. Insert fingers into the groove in the front

of frame and pull out to remove the

frame. (When reattaching the frame,

point the side with groves downward

and attach it.)

3. Lever

Insert the levers supplied with the unit

into the grooves at both sides of the unit

as shown in figure until they click.

Pulling the levers makes it possible to

remove the unit from the dashboard.

DIN REAR-MOUNT (Method B)

Installation using the screw holes on the sides of the unit.

Fastening the unit to the factory radio

mounting bracket.

1. Select a position where the screw holes

of the bracket and the screw holes of

the main unit become aligned (are fitted),

then tighten the screws at 2 places on

each side.

Use either truss screws (5 x 5mm) or

flush surface screws (4 x 5mm),

depending on the shape of the screw

holes in the bracket.

2. Screw

3. Factory radio mounting bracket

4. Dashboard or Console

5. Hook (Remove this part)

Note: The trim piece, backstrap, and

mounting bracket are not used for method

B installation.

(Fig. 2)

HOW TO REMOVE AND INSTALL THE FRONT PANEL

1. Press the release button and pull-off the front panel.

Keep front panel into the case.

2. To install the front panel, insert the panel into the housing and make sure the panel

is properly installed, otherwise, abnormalities occurs on the display or some keys

will not function properly.

REMOVING THE FRONT PANEL

INSTALLING THE FRONT PANEL

Release Button

Front Panel

WIRING CONNECTION

Note:

1. For 2-speakers system, green, violet, white/black and grey/black wire leads are

unconnected and isolated.

2. For 2-speakers system, keep the fader indicator at center position to maintain the

existing volume level.

WHITE

WHITE/BLACK

GREEN

GREEN/BLACK

Lch

SPK.

WHITE

GREEN/BLACK

GREY

GREY/BLACK

VIOLET

VIOLET/BLACK

4-SPEAKERS SYSTEM 4-SPEAKERS SYSTEM

FRONT

Lch SPK.

REAR

Lch SPK.

FRONT

Rch SPK.

REAR

Rch SPK.

2-SPEAKERS SYSTEM 2-SPEAKERS SYSTEM

Rch

SPK.

GREY

VIOLET/BLACK

MAIN UNIT

Rch RED

Lch WHITE

(GREY)

REAR RCA CABLE

Rch RED

Lch WHITE

(BROWN)

FRONT RCA CABLE

ANTENNA CONNECTOR

RED

YELLOW

BLUE

POWER

ANTENNA

GROUND (B–)

MEMORY

BACK-UP

IGNITION

SWITCH (B+) SUBWOOFER

CABLE

(GREEN)

Rch RED

Lch WHITE

(BLACK)

AUX. AUDIO IN

FUSE

BLACK

OPERATION

GENERAL OPERATION

• ON/OFF

Switch on the unit by pressing any button (except button (4) and REL button (7)).

When system is on, hold PWR button (9) to turn off the unit.

• FACEPLATE RELEASE

Press REL button (7) to detach the removable faceplate.

• SOUND ADJUSTMENT

Press SEL button (10) to select the desired adjustment mode.

2526

229 2120 23 183 6 121613 10

1 2717 4 1119 24155

The adjustment mode will change in the following order:

By pressing VOL button (11) or VOL button (12), it is possible to adjust the

desired level.

• LOUDNESS

Press BND/LOU button (13) for several seconds to reinforce the bass output. The

display will show “LOUD”. Press it for several seconds again to defeat this function.

• SET THE CLOCK

Hold down the DSP button (15) until the clock is shown on the LCD display and

flashed. Then press the TUNE/SEEK/TRACK button (17) to change hours or

TUNE/SEEK/TRACK button (16) to change minutes.

• SELECT MODE

Press MOD/SW button (6) to choose desired listening mode.

• SUBWOOFER

Press MOD/SW button (6) for several seconds to toggle subwoofer output.

When subwoofer is on, display will show “SW”. Press it again for several seconds

to release this mode.

• MUTE

Press MUT button (3) to silence the receiver. Press it again to resume listening.

• LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated functions on the display (8).

• EQUALIZATION

Press P.EQ button (19) to turn on equalization function and to select desired audio

mode. There are four modes:

• REMOTE SENSOR

Point the remote control handset to the remote sensor RX (24).

Press the function keys on the handset to control the system.

• FLASHING LED

If the front panel does not install in the unit, the LED (25) will flash.

• RESET

The RESET button (26) must be activated with either a ball point pen or thin pointed

metal object. RESET button (26) is to be activated for the following reasons:

- Initial installation of the unit when all wiring is completed.

- All the function buttons do not operate.

- Error symbol on the display.

Note: If pressing the RESET button (26) doesn’t work, please use a cotton swab

soaked in isopropyl alcohol to clean the socket on the back of the front panel.

Volume Bass Treble Balance Fader

CLASSICS POP ROCK DSP OFF

RADIO OPERATION

• BAND SELECTION

For tuner mode, press BND/LOU button (13) briefly to select the desired band.

The reception band will change in the following order:

• STATION SELECTION

Press TUNE/SEEK/TRACK button (16) or TUNE/SEEK/TRACK button

(17) briefly to activate automatic seek function.

Press for several seconds until “MANUAL” appears on the display. The manual

tuning mode is now active. If both buttons have not been pressed for several

seconds, they will return to “seek tuning” mode and “AUTO” will appear on the

display.

• LOCAL/DISTANCE

Press LOC button (2) briefly to select between local and distant stations.

“Local” setting is reception of strong stations, and “distant” setting reception of

weaker stations. This function is in during AUTO SEEK operation.

• AUTOMATIC MEMORY STORING & PROGRAM SCANNING

- Automatic Memory Storing

Press AMS button (18) for several seconds. The radio searches from the current

frequency and checks the signal strength until one cycle search is finished.

The 6 strongest stations are stored into the corresponding preset number buttons.

- Program Scanning

Press AMS button (18) briefly to scan preset stations.

When the field strength level is more than the tuner threshold sensitivity level, the

tuner will hold at that preset number for several seconds with muting released,

then searches again.

• STATION STORING

Select a station. Then press any one of the preset buttons (14) (M1 to M6) to store

a station into memory. Press this button for several seconds, the station is then

stored into the number button.

• MONO/STEREO

Press MON button (1) to select mono or stereo mode. You can sometimes improve

reception of distant stations by selecting mono operation.

FM1 FM2 FM3 AM

CD OPERATION

• SELECT TRACKS

During CD operation, press TUNE/SEEK/TRACK button (16) or

TUNE/SEEK/TRACK button (17) to move to the previous track or the following

track. Track number shows on the display.

During CD operation, hold TUNE/SEEK/TRACK button (16) or

TUNE/SEEK/TRACK button (17) to fast reverse or fast forward. CD play starts

from when you release the button.

• PAUSE PLAYING

Press PAU button (20) to pause CD player. Press it again to resume play.

• REPEAT THE SAME TRACK

During CD operation, press RPT button (22) to continuously repeat the same track.

Press again to stop repeat.

• PREVIEW ALL TRACKS

During CD operation, press SCN button (21) to play first several seconds of each

track on the current disc. Press again to stop intro and listen to track.

• PLAY ALL TRACKS

During CD operation, press SHF button (23) to play all tracks on CD in random

order. Press again to cancel the function.

• EJECT

Press button (4) to stop CD playing and eject the disc from the disc slot (5).

NOTE ON CD-R/CD-RW DISCS

• On this unit, in addition to an audio CD, you can play your original CD-R or CD-RW

discs that contain audio titles.

• However, depending on the condition of the recording equipment or the CD-R or

CD-RW itself, some CD-Rs or CD-RWs may not play in this unit.

• DO NOT stick paper or tape, etc, onto label side or the recorded side of any

CD-R/CD-RW, as it may cause a malfunction.

REMOTE CONTROL HANDSET

FUNCTION KEYS & CONTROL

1. PWR = Power ON/OFF Button

2. DSP = Display Button

3. SEL = Select Button

4. VOL = Volume Up Button

5. VOL = Volume Down Button

6. BND = Band Select Button

7. MOD = Mode Button

8. TUNE/SEEK = Tune/Seek Down Button

9. TUNE/SEEK = Tune/Seek Up Button

10. AMS = Automatic Memory Storing & Program Scanning Button

11. M1 - M6 = Preset Buttons

12. PAU = Pause Button

13. SCN = Scanning Button

14. RPT = Repeat Button

15. SHF = Shuffle Button

4 3

Inhaltsverzeichnis

Andere Sound Storm Autoempfänger Handbücher

Sound Storm

Sound Storm SCP250 Bedienungsanleitung

Sound Storm

Sound Storm SD800TS Bedienungsanleitung

Sound Storm

Sound Storm SD710 Bedienungsanleitung

Sound Storm

Sound Storm SDVD550T Bedienungsanleitung

Sound Storm

Sound Storm SD545M Bedienungsanleitung

Sound Storm

Sound Storm M312USA Bedienungsanleitung

Sound Storm

Sound Storm SCD-150 Bedienungsanleitung

Sound Storm

Sound Storm SD712B Bedienungsanleitung

Sound Storm

Sound Storm DD888 Bedienungsanleitung

Sound Storm

Sound Storm SDC90R Bedienungsanleitung

Sound Storm

Sound Storm SD870TS Bedienungsanleitung

Sound Storm

Sound Storm SDC25A Bedienungsanleitung

Sound Storm

Sound Storm SDC22A Bedienungsanleitung

Sound Storm

Sound Storm SCD-500R Bedienungsanleitung

Sound Storm

Sound Storm SD812TS Bedienungsanleitung

Sound Storm

Sound Storm S1520MR Bedienungsanleitung

Sound Storm

Sound Storm SCD-350 Bedienungsanleitung

Sound Storm

Sound Storm SD720MI Bedienungsanleitung

Sound Storm

Sound Storm M305A Bedienungsanleitung

Sound Storm

Sound Storm STM93RDS Bedienungsanleitung

Sound Storm

Sound Storm SD140V Bedienungsanleitung

Sound Storm

Sound Storm SD707M Bedienungsanleitung

Sound Storm

Sound Storm MR508UABW Bedienungsanleitung

Sound Storm

Sound Storm ML39USA Bedienungsanleitung

Beliebte Autoempfänger Handbücher anderer Marken

Motorola

Motorola VWA63 Bedienungsanleitung

Nextar

Nextar D3201 Bedienungsanleitung

Alpine

Alpine CDE-163BT Bedienungsanleitung

Pioneer

Pioneer DEH-P645R Bedienungsanleitung

Axxera

Axxera XDMA7600 Betriebsanleitung

XM OnyX Bedienungsanleitung

Soundstream

Soundstream VIR-5000 Bedienungsanleitung

Avson

Avson MKT Platform Bedienungsanleitung

Sony

Sony MEX-1HD - Audio Library System Bedienungsanleitung

Pioneer

Pioneer DVH-P500UB Bedienungsanleitung

JVC

JVC KD-AHD69 Bedienungsanleitung

Blaupunkt

Blaupunkt SANTIAGO CR 87 Bedienungsanleitung

Sony

Sony CDX-4160 - Cd Receiver Bedienungsanleitung

XFIRE AUDIO

XFIRE AUDIO BMW42S Bedienungsanleitung

VDO

VDO CD 2253 Bedienungsanleitung

Volvo

Volvo 13 84 580 Bedienungsanleitung

ZENEC

ZENEC ZE-160DVD Bedienungsanleitung

Medion

Medion Car Audio Bedienungsanleitung