Soundoff Signal ETSSLFVBK10 Bedienungsanleitung

1.800.338.7337 / www.soundo󰀨signal.com

ETSSLFVBK10 0221

FRAME MOUNT BRACKET (NO DRILL) FOR THE AFTERSHOCK LOW FREQUENCY SPEAKER

2019.5 - 2021 CHEVROLET SILVERADO 1500 (VIN STARTS WITH 1G)

ETSSLFVBK10

NOTICE:

Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.

Improper use or installation may void warranty coverage.

To review our Limited Warranty Statement & Return Policy for this or any SoundO Signal product, visit our website at www.soundosignal.com/tech-services/returns/.

If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 1.800.338.7337 (press #4).

Questions or comments that do not require immediate attention may be emailed to techservices@soundosignal.com.

ENHANCING SAFETY THROUGH INNOVATION

INSTALLATION:

1. Remove the front grille and shutter assembly to gain

access behind vehicle bumper. Consult a local Chevrolet

service center for best disassembly method. Keep all

hardware.

CONTAINS

QTY COMPONENT

1 Low Frequency Bracket

1 Installation Instruction Sheet

1 Product Warning Card

•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat build-up and

re. Follow crimp connector manufacturer instructions.

•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle Owner’s

Manual for deployment zones.

•Do NOT use system to disconnect headlights, brake lights or other safety equipment.

•Unit may become hot to touch during normal operation.

•Failure to properly install connectors, fuses or wiring may cause vehicle failure or re.

•Installation must only be performed by trained technician. Installer must determine vehicle wiring

conguration and proper integration of system.

•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal or local

chassis ground (-) must be sized to supply at least 125% of max. current and properly fused at power source.

•Install protective grommets when routing wire through rewall or metal.

WARNING

*Speaker and Speaker Hardware Sold Separately

TOP VIEW

FIG. 1

FIG. 2

FRONT VIEW

1.800.338.7337 / www.soundo󰀨signal.com

ETSSLFVBK10 0221

FRAME MOUNT BRACKET (NO DRILL) FOR THE AFTERSHOCK LOW FREQUENCY SPEAKER

2019.5 - 2021 CHEVROLET SILVERADO 1500 (VIN STARTS WITH 1G)

ETSSLFVBK10

NOTICE:

Installers and users must comply with all applicable federal, state and local laws regarding use and installation of warning devices.

Improper use or installation may void warranty coverage.

To review our Limited Warranty Statement & Return Policy for this or any SoundO Signal product, visit our website at www.soundosignal.com/tech-services/returns/.

If you have questions regarding this product, contact Technical Services, Monday - Friday, 8 a.m. to 5 p.m. ET at 1.800.338.7337 (press #4).

Questions or comments that do not require immediate attention may be emailed to techservices@soundosignal.com.

ENHANCING SAFETY THROUGH INNOVATION

INSTALLATION (CONT.):

2. Once the vehicle is disassembled loosen the large bolts

on either side of the vehicle behind the bumper, as shown

in Fig. 3, in order to slide the bracket into position.

3. When the bracket is positioned, tighten the preexisting

bolts to manufacturer specications.

4. After the bracket is installed on vehicle, attach the

universal mount bracket to the aftershock speaker(s.)

5. The aftershock speakers(s) and Universal Mount Bracket

are installed from below the vehicle. Position both sides

of the speaker bracket(s) on the back side of the bracket

mounted in the vehicle. Tighten to 15 ft-lb.

6. Connect the wire harness to back of the speaker(s.)

7. Reinstall grille using factory hardware.

FIG. 3

Passenger Side

bolt to be

removed Driver Side

bolt to be

removed

NOTE: Ensure the speaker grille is pointed

towards the ground and the Universal Mount

Brackets are positioned with the double

mounting holes facing upwards

Inhaltsverzeichnis

Andere Soundoff Signal Rack & Stand Handbücher

Soundoff Signal

Soundoff Signal ETSSVBK05 Bedienungsanleitung

Soundoff Signal

Soundoff Signal Mpower EMPSC07M Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal PINNACLE EPL7PD C Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal ETSS100BKUV-X Bedienungsanleitung

Soundoff Signal

Soundoff Signal Mpower EMPSC07M Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal Mpower EMPSC07M Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal PINNACLE EPL71M+ Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal ETSSVBK02 Bedienungsanleitung

Soundoff Signal

Soundoff Signal Pinnacle EPL71PD Series Bedienungsanleitung

Soundoff Signal

Soundoff Signal nFORCE ENFSSS**-Single Series Bedienungsanleitung

Beliebte Rack & Stand Handbücher anderer Marken

Salamander

Salamander Acadia AC/W/L400/WH Bedienungsanleitung

Fohhn

Fohhn VAT-09 Benutzerhandbuch

ricoo

ricoo FS0522 Bedienungsanleitung

AMSOIL

AMSOIL BMK-22 Kurzanleitung

Kargo Master

Kargo Master 48220 Bedienungsanleitung

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 Bedienungsanleitung

ricoo

ricoo S1222 Bedienungsanleitung

Ready-Set-Mount

Ready-Set-Mount RSMCM602 Bedienungsanleitung

VidaBox

VidaBox VB MNT FFS2 Bedienungsanleitung

Welch Allyn

Welch Allyn 48960 Bedienungsanleitung

Arkon

Arkon CM035-ST-2 Bedienungsanleitung

PROEL

PROEL PLWIN60C Bedienungsanleitung

Agilent Technologies

Agilent Technologies E2609B Bedienungsanleitung

Mustang

Mustang MV-ARM4 Bedienungsanleitung

Mounting Solutions

Mounting Solutions WRM-320 Bedienungsanleitung

Pyle

Pyle PMKSPAD1 Bedienungsanleitung

ShelterIt

ShelterIt 21208 Bedienungsanleitung

SPL

SPL RackPack?4 1040 Bedienungsanleitung