SS-10 3G JOB AID
DOC. NO: SS-10 3G - 015 (REV. 01) Page 6 of 9
1. Analogue Line
This should be connected to a PABX trunk port or an analogue telephone.
2. Serial programming connection
The serial port is used to configure and change parameters on the SS-10 3G
unit by using a software programming tool (SS-10 Tool supplied on CD)
Use the serial cable supplied to connect the SS-10 3G to the serial port of the
PC running the SS-10 Tool Software.
3. Power Jack
Insert the jack of the power supply adapter (shipped in the SS-10 3G
package) into the POWER connector.
2.3 INSTALLING THE EXTERNAL ANTENNA
SS-10 3G have a RF connector for connecting the antenna for the wireless
network. The following may be used:
The wideband antenna supplied with the package, with cable and magnetic
base or
Other kinds of external antennas with higher gain or directivity (Yagi), if the
need arises.
2.4 POWER UP SS-10 3G
Insert the jack of the power supply adapter into the POWER connector.
Plug the adapter into the receptacle of the 230V AC mains outlet. The SS-10 3G
will start working immediately. The green LED indicator (PWR) should be
lighting up.
