Star Micronics Star SCP700 Series Bedienungsanleitung

COMBINATION PRINTER

SCP700 SERIES

USERS MANUAL

GUIDE D’UTILISATION

BEDIENUNGSANLEITUNG

MANUALE DI ISTRUZIONI

Federal Communications Commission

Radio Frequency Interference

Statement

This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial envi-

ronment. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction manual, may cause harmful interference

to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to corect the interference at his

own expense.

For compliance with the Federal Noise Interference Standard, this equipment requires a

shielded cable.

This statement will be applied only for the printers marketed in U.S.A.

Statement of

The Canadian Department of Communications

Radio Interference Regulations

This digital apparatus does not exceed the Class A limits for radio noise emissions from digi-

tal apparatus set out in the Radio Interference Regulations of the Canadian Department of

Communications.

Le présent appareil numérique n’émet pas de bruits radioélectiques dépassant les limites

applicables aux appareils numériques de la classe A prescrites dans le Règlement sur le

brouillage radioélectrique édicté par le ministère des Communications du Canada.

The above statement applies only to printers marketed in Canada.

Manufacturer's Declaration of Conformity

EC Council Directive 89/336/EEC of 3 May 1989

This product, has been designed and manufactured in accordance with the International Standards EN 50081-1/01.92 and

EN 50082-1/01.92, following the provisions of the Electro Magnetic Compatibility Directive of the European Communi-

ties as of May 1989.

EC Council Directive 73/23/EEC and 93/68/EEC of 22 July 1993

This product, has been designed and manufactured in accordance with the International Standards EN 60950, following

the provisions of the Low Voltage Directive of the European Communities as of July 1993.

The above statement applies only to printers marketed in EU.

Trademark acknowledgments

SCP700

: Star Micronics Co. Ltd.

ESC/POS, TM-295, TM-T85

: Seiko Epson Corporation

Notice

mission, is strictly forbidden.

• The contents of this manual are subject to change without notice.

• All efforts have been made to ensure the accuracy of the contents of this manual at the time of printing. However,

should any errors be found, STAR would greatly appreciate being informed of them.

• The above notwithstanding, STAR can assume no responsibility for any errors in this manual.



TABLE OF CONTENTS

Chapter 1: Printer Setup ............................................................................. 1

Choosing a place for the printer ................................................. 1

Unpacking the printer ................................................................. 2

General guide ............................................................................. 3

Opening the printer cover ........................................................... 4

Installing the ribbon cassette ...................................................... 4

Removing the ribbon cassette ..................................................... 5

Connecting to a power outlet and turning power on and off ...... 6

Connecting to your host computer ............................................. 7

Loading thermal roll paper ......................................................... 9

Loading thermal roll paper manually ....................................... 11

Using slip paper ........................................................................ 13

Removing jammed thermal paper ............................................ 14

Adjusting the near-end sensor .................................................. 14

Chapter 2: Control Panel Operations ...................................................... 17

Indicator lights .......................................................................... 17

Buttons ...................................................................................... 18

Producing a test print ................................................................ 18

Adjusting the slip printer’s dot alignment ................................ 19

Hexadecimal dump ................................................................... 21

Errors ........................................................................................ 21

Chapter 3: Printer Handling and Care .................................................... 23

Operating Precautions .............................................................. 23

Safety Precautions .................................................................... 23

Cleaning the receipt printer mechanism ................................... 23

Chapter 4: Command Summary .............................................................. 26

Chapter 5: Installing Optional Accessories ............................................. 32

Installing an optional interface board ....................................... 32

Installing the customer display ................................................. 33

Appendix A: General Specifications .......................................................... 151

Appendix B: Paper Specifications ............................................................. 153

Appendix C: Setting the DIP Switches ...................................................... 154

Appendix D: Setting the Memory Switches .............................................. 159

Appendix E: Standard Serial Interface .................................................... 160

Appendix F: Optional Interface ................................................................ 163

Appendix G: Peripheral Unit Driver Circuit ............................................ 169

Please access the following URL

http://www.star-micronics.co.jp/service/u_mans_e.htm

for the lastest revision of the manual.

ENGLISH

Chapter 1: Printer Setup

This chapter contains important information on setting up your printer. Be sure

to read this chapter carefully before using the printer for the first time. In this

chapter you will learn about:

❏

Choosing a place for the printer

❏

Unpacking and setting up the printer

❏

Installing the ribbon cassette

❏

Connecting to a host computer

❏

Loading roll paper

❏

Inserting sheet paper

❏

Adjusting the near-end sensor

Choosing a place for the printer

Before actually unpacking the printer, you should take a few minutes to think

about where you plan to use it. Remember the following points when doing this.

✓

Choose a ﬁrm, level surface where the printer will not be exposed to

vibration.

✓

The power outlet you plan to connect to for power should be nearby and

unobstructed.

✓

Make sure that the printer is close enough to your host computer for you to

connect the two.

✓

Make sure that the printer is not exposed to direct sunlight.

✓

Make sure that the printer is well away from heaters and other sources of

extreme heat.

✓

Make sure that the surrounding area is clean, dry, and free of dust.

✓

Make sure that the printer is connected to a reliable power outlet. It should

not be on the same electric circuit as copiers, refrigerators, or other

appliances that cause power spikes.

✓

Use a power outlet that matches the power rating noted on the label afﬁxed

to the bottom of your printer.

✓

Make sure that the room where you are using the printer is not too humid.

ENGLISH

Unpacking the printer

Check to make sure that the carton contains each of the items shown in the

following illustration.

If anything is missing, contact the dealer where you bought the printer and ask

them to supply the missing part. Note that it is a good idea to keep the original

box and all the packing materials just in case you need to pack the printer up

again and send it somewhere at a later date.

Printer Sample paper roll

Ribbon cassette

User’s Manual

Ferrite core Fastener

ENGLISH

General guide

The following illustrations describe the major components, buttons, and

connectors of your printer.

Printer cover

Protects internal components.

Control panel

Three indicators show 

the printer status, and two 

switches provide control 

over printer functions.

Printer cover release

Press here to release the printer 

cover when opening it.

Power switch

Turns printer power 

on and off.

Document table

Supports slip paper feed 

into the slip printer.

Roll paper exit slot

Ejects roll paper after printing 

by the receipt printer.

AC adaptor cable connector

For connection of the AC 

adaptor. Never unplug the AC 

adaptor while the printer is on.



Peripheral unit connector

Modular jack for connection of 

cash drawers, etc. Do not 

connect a telephone line to 

this connector.



Interface connector

For connection to a host 

computer.



Optional interface slot

Insert the optional RS-232C serial 

interface (D-sub 25 pin) or centronics 

parallel interface.

ENGLISH

Opening the printer cover

❏

Press in on the printer cover release to disengage the hook that holds the

printer cover in place and swing the cover up to open it. Allow the cover to

swing all the way open until it stops.

❏

To close the cover, swing it back down into position. Next, press in on the

printer cover release and guide the tab into the slot so the cover locks

securely in place.

Installing the ribbon cassette

❏

Make sure that the printer is turned off and unplugged from its power

outlet.

❏

Open the printer cover.

❏

Remove the ribbon cassette from its packaging, and turn the knob on the

ribbon cassette in the direction indicated by the arrow to take up any slack

in the ribbon.

❏

Check if the printer is released condition.

If not, connect the printer to the power as described on page 6. Turn on the

power and press the

SLIP/RESUME

button on the control panel, then turn

off the power.

ENGLISH

❏

Holding the ribbon cassette so that the ribbon is facing down, install the

cassette into the slip printer as shown in the illustration. Note that you have

to guide the right side of the ribbon cassette into the slot provided on the

printer. The ribbon has to pass between rollers as the ribbon cassette ﬁts

into the slip printer.

❏

Press gently but ﬁrmly on the cassette until it’s tab snaps securely into

place.

❏

Rotate the knob on the cassette again to take up any slack.

❏

Close the printer cover.

Removing the ribbon cassette

Use the following procedure to remove the ribbon cassette from the slip printer

when you want to replace it with a new one.

❏

Make sure that the printer is turned off and unplugged from its power

outlet.

❏

Open the printer cover.

❏

Check if the printer is released condition.

If not, connect the printer to the power as described on page 6. Turn on the

power and press the

SLIP/RESUME

button on the control panel, then turn

off the power.

ENGLISH

❏

Grasping the ribbon cassette as shown, gently pull it away from the printing

mechanism and work it free. Take care to slide the right side of the ribbon

cassette away from the mechanism and then to the left to clear the slot.

❏

Use the procedure under “Installing the ribbon cassette” on page 4 to install

a new cassette.

Connecting to a power outlet and turning power on and off

❏

Connect a three-prong grounded power cord to the power cord connector of

the optional AC adaptor.

❏

Plug the optional AC adaptor into the printer’s AC adaptor cable connector.

Note:

The power cord and AC adaptor are not included with the printer. If these

accessories are needed, consult your sales representative.

❏

Plug the other end of the power cord to a standard household wall outlet.

Andere Handbücher für Star SCP700 Series

Inhaltsverzeichnis

Sprachen:

Andere Star Micronics Drucker Handbücher

Star Micronics

Star Micronics TSP1000 Series Bedienungsanleitung

Star Micronics

Star Micronics LC-1011C Bedienungsanleitung

Star Micronics

Star Micronics LC24-15 Bedienungsanleitung

Star Micronics

Star Micronics LC-240C Bedienungsanleitung

Star Micronics

Star Micronics SP349 Bedienungsanleitung

Star Micronics

Star Micronics SP500 Series Montageanleitung

Star Micronics

Star Micronics SM-S200 Series Montageanleitung

Star Micronics

Star Micronics NX-1020 Bedienungsanleitung

Star Micronics

Star Micronics TSP100IIIU Montageanleitung

Star Micronics

Star Micronics FVP10 SERIES Bedienungsanleitung

Star Micronics

Star Micronics SP717 Series Bedienungsanleitung

Star Micronics

Star Micronics TSP100ECO Bedienungsanleitung

Star Micronics

Star Micronics SP312F Bedienungsanleitung

Star Micronics

Star Micronics Multi-Font NX-2410 Bedienungsanleitung

Star Micronics

Star Micronics SP2000 Bedienungsanleitung

Star Micronics

Star Micronics LC-4511 Bedienungsanleitung

Star Micronics

Star Micronics SJ-144MC Bedienungsanleitung

Star Micronics

Star Micronics TSP552II Bedienungsanleitung

Star Micronics

Star Micronics SP300 Series Bedienungsanleitung

Star Micronics

Star Micronics futurePRNT TSP100 Bedienungsanleitung

Star Micronics

Star Micronics LC24-300 COLOUR Bedienungsanleitung

Star Micronics

Star Micronics LS-5 SERIES Bedienungsanleitung

Star Micronics

Star Micronics AirPrint Bedienungsanleitung

Star Micronics

Star Micronics TSP600 Series Handbuch

Beliebte Drucker Handbücher anderer Marken

Canon

Canon i70 Series Bedienungsanleitung

Evolis

Evolis Elypso Bedienungsanleitung

Kyocera

Kyocera FS-9530DN Bedienungsanleitung

Canon

Canon LASER SHOT LBP-1210 Bedienungsanleitung

Samsung

Samsung BIXOLON SRP-350plusF Bedienungsanleitung

Canon

Canon PIXMA PRO-1 Series Bedienungsanleitung

Canon

Canon PIXMA G3560 Einrichtungshandbuch

Dell

Dell Color Laser Printer 2130cn Bedienungsanleitung

Tektronix

Tektronix Phaser 840 Bedienungsanleitung

Brother

Brother 1440 - HL B/W Laser Printer Kurzanleitung

Fuji Xerox

Fuji Xerox DocuPrint P375 dw Bedienungsanleitung

WOOSIM

WOOSIM PORTI-S30 Bedienungsanleitung

Olivetti

Olivetti PG L2140 Bedienungsanleitung

Konica Minolta

Konica Minolta bizhub 224e Bedienungsanleitung

Canon

Canon LBP113w Bedienungsanleitung

Xerox

Xerox DocuColor 5000 Bedienungsanleitung

Canon

Canon PRO-500 Series Einrichtungshandbuch

Epson

Epson ET-7750 Betriebsanleitung