Status EVP300 Bedienungsanleitung

innovations

izvirni pripomočki

izvorna pomagala

innovations

izvirni pripomočki

izvorna pomagala

innovations

izvirni pripomočki

izvorna pomagala

ELECTRICAL VACUUM PUMP

USER MANUAL

Figure 1: Components*

The gure below shows the electrical vacuum pump. Important points are marked with numbers and explained

in the table:

1. Outer casing

2. Start/Stop Button

Initiation and interruption of vacuum packing process.

3. Stand

4. Silicon gasket

By vacuum packing process it should be placed precisely on the valve of the chosen container.

5. Rubber tap

6. Rib

In the case the pump is placed on the wall, remove the ribs.

7. Wall inserted piece

8. Screws

* Components are marked with the same numbers also on Figures 3 and 4.

1. COMPONENTS AND FUNCTION BUTTONS

1.1. TECHNICAL DATA

Dimensions

(with the stand)

Width: 80 mm

Depth: 180 mm

Height: 136 mm

Weight Pump with the stand approximately 0,49 kg, adapter approximately 0,6 kg.

Material ABS plastic

Pump Single–piston pump (self-oiling – no maintenance necessary)

Vacuum pressure - 500 mbar

Motor 12 V DC

Automatic cut-off after one minute in case of improper use.

Max RPM 3500

Pump volume 11 l/min

Controls Electronic

Adapter input: 110-240 V ~ 50-60 Hz, 250 mA

output: 12 V DC, 2000 mA

a) Pay attention on the place, where vacuum pump

will be positioned. Working surface must be dry,

normal temperature (not hot) and clear from ob-

structions or water source.

b) Check the power cable and electrical outlet before

you plug in the appliance. Make sure there are no

breakdowns.

c) Appliance should be cleaned only with a dry or sli-

ghtly damp cloth.

d) Use the appliance only for the purposes described

in the User Manual.

e) Warranty is invalid if:

• the appliance has been repaired by somebody who

is not an authorised person or a professional.

• you use the appliance for unintended purposes.

• you do not respect safety regulations and do not

follow the instructions in the User Manual.

The manufacturer will not accept responsibility for any

damage that may occur as a result of not following the

User Manual or improper use.

1.2. IMPORTANT SAFETY

INSTRUCTIONS

1.3. OPERATING CONDITIONS

Maximum ambient temperature in normal use is

+40°C; the average of temperatures over a 24-hour

period should not exceed +35°C. Minimum ambient

temperature is –5°C.

Surrounding air should be clean; relative humidity

should not exceed 50% at the maximum temperature

of +40°C. Higher relative humidity is allowed at lower

ambient temperature (e.g. 90 % at +20°C).

2. USAGE

2.1. GENERAL INSTRUCTIONS

a.) When taking the appliance out of its packaging

check that all its components are included and

undamaged. Make sure no polystyrene fragments

are left inside silicon gasket.

b.) Read the User Manual before you use the machi-

ne for the rst time.

a) Electrical vacuum pump is a professional appliance

adapted to everyday use in households.

a) Plug in the appliance.

b) Place the pump right-angled on the container or lid

and push slightly. Make sure that silicon gasket

(item 4) is placed on the middle of the valve.

c) Press Start/Stop Button (item 2). The pump will

automatically turn off when the vacuum process is

completed.

d) In case of improper use the pump will automatically

cut-off after one minute.

e) During vacuum packing process the pump could be

stopped at any time by pressing Start/Stop Button.

Figure 2: Proper vacuum pump position on the

vacuum container

2.2. INSTRUCTIONS FOR USE

2.3. STORAGE

Electrical vacuum pump can be put and storaged on

the kitchen counter or xed to the kitchen wall.

Figure 3: Position when stored on the counter or on

the wall

When xing stand on the wall remove ribs on the lower

side of the stand (see item 6), make holes for the

attached wall screws and screw them into the wall. See

gures bellow:

Figure 4: Compound parts and xing the bottom stand

on the wall

2.4. MAINTENANCE AND CLEANING

a.) Always unplug the appliance before cleaning.

b.) Use a soft, damp cloth to clean the machine. Do

not use anything which could scratch or damage

the surface. Never submerge the appliance in wa-

ter or place it under running water. Never squirt de-

tergent directly onto or into the machine.

c.) Before using the appliance make sure that it is

completely dry.

d.) If any case the liquid enters the appliance consult

an authorised repair service.

2.5. TIME INTERVALS FOR USING

ELECTRICAL VACUUM PUMP

When using electrical vacuum pump for vacuum pack

larger amounts of food let the pump cool down every

20 minutes for at least 2 minutes.

If you have any comments or questions concerning the

functioning of the appliance or warranty, please con-

tact us on the following address:

STATUS d.o.o. Metlika

Ulica Belokranjskega odreda 19, 8330 Metlika

Service phone: + 386 (0)7/36 91 228

e-mail: [email protected]

More information available also on www.status.si.

The appliance complies with all European directives:

a.) Rules on Electrical Equipment Designed for Use wi-

thin Certain Voltage Limits

(Ofcial Journal of RS, Nos. 27/2004, 17/2011,

71/2011)

LVD Directive 2014/35, 2006/95/EC

b.) Rules on Electromagnetic Compatibility

(Ofcial Journal of RS, Nos. 84/2001, 32/2002,

132/2006)

EMC Directive 2014/30, 2004/108/EC

EC declaration of conformity guarantees that the ap-

pliance is safe and has been inspected and tested to

meet all the requirements specied in the applicable

standards, directives and regulations.

EC Declaration of conformity for CE marking is loca¬ted

at the seller and can be provided per customer’s

request.

4. DECLARATION OF CONFORMITY

This warranty is valid for two years from the date of

purchase. Evidence of original purchase is required

for warranty services, so it is important to keep your

sales receipt.

This warranty only covers breakdown caused by electri-

cal or mechanical failure. It does not cover damage ca-

used by liquid entering the machine or breakdown cau-

sed by failure to follow the manufacturers instructions.

3. WARRANTY

5. TROUBLESHOOTING

Problem: What to do:

Pump does not react when

pushing the Start/Stop

Button.

• Check the power cord for any damage – cracks or splitting.

• Make sure the machine is plugged in.

• Your machine may switch off automatically due to improper use. Wait app.

one minute.

Pump does not vacuum the

containers or vacuum does

not hold.

• Check if cover of vacuum container and silicone gaskets are clean and correc-

tly adjusted on the container.

• Check if the valve on the container cover is clean and dry, If not, detach it

from the cover and clean it.

Machine won’t work at all &

I’ve tried all of the above.

It is obligatory to contact the service.

The manufacturer can not accept responsibility for any damage that may occur as

a result of improper use or appliances where home repairs have been undertaken.

Vacuum appliance, containers and universal lids are

indispensable in every kitchen. They are intended for

natural storing of food and extending shelf life of raw

and boiled food without losing its quality. Storing in the

refrigerator, pantry or packaging that extends food fre-

shness does not prevent the oxygen coming in contact

with food.

We also have to mention that Status' electrical vacuum

pump helps you save money, since you can buy in bulk,

repackage your purchase in portions and then vacuum

package. Food can be divided into smaller serving por-

tions, vacuum packaged and stored in the refrigerator

for a longer period of time.

Oxygen provokes a chemical change on food and is an

important factor in the formation of moulds and bac-

teria. As a consequence, grease can go rancid, food

colour changes, moulds and bacteria multiply, and

avour, vitamins, aroma and minerals are lost. Vacuum

packaging holds up such undesired effects, prolongs

shelf life and preserves food quality. Only with the help

of vacuum packaging, i.e. removing air from packaging

using vacuum pump, a suitable environment required

to extend food freshness can be established. The pro-

cess of vacuum packaging in containers or bags crea-

tes negative pressure.

6. BENEFITS OF VACUUM PACKING

When the equipment or parts of the device are no

longer t for use they must be disposed of at the in-

dustrial waste landll in accordance with applicable

regulations:

• Decree on the Management of Waste Electrical

and Electronic Equipment (WEEE) (Ofcial Journal

of RS, no. 107/2006)

Directive 2012/19/EU on Waste Electrical and

Elec¬tronic Equipment (WEEE)

• Rules on the Restriction of the Use of Certain Ha-

zardous Substances in Electrical and Electron¬ic

Equipment (RoHS) (Ofcal Journal of RS, no.

102/2012)

• Rules amending the Rules on the Restriction of the

Use of Certain Hazardous Substances in Electrical

and Electronic Equipment (Ofcial Journal of RS,

no. 20/2014)

Directive 2011/65/EU on the Restriction of the

Use of Certain Hazardous Substances in Electrical

and Electronic Equipment

Environmentally hazardous components and parts

that were built into the device have to be disposed of

at specialized sites.

7. CORRECT DISPOSAL OF YOUR ELECTRICAL

VACUUM PUMP

The symbol on the product or its

packaging indicates that at the

end of its life, the product may

not be treated as other household

waste.

It is your responsibility to dispo-

se the waste appliance in spe-

cial areas intended for separate

collection of waste in your local

community or to deliver it to the provider of WEEE col-

lection services.

Separate collection of individual components of EE

equipment prevents negative effects of environmental

pollution and minimizes danger to human health, whi-

ch may occur as a result of improper product disposal.

In addition, it enables reuse and recovery of the mate-

rial, thus saving energy and raw materials.

For detailed information on collecting, sorting, reuse

and recycling of the product contact the provider of

WEEE collection services or the shop where you bou-

ght the equipment.

Date of manufacture of vacuum pump appliance can

be found on the warranty sheet which you received at

purchase.

8. ELECTRICAL VACUUM PUMP SET

The set includes:

a) 1 Electrical vacuum pump,

b) 1 Adapter

c) Stand with 4 rubber taps,

d) Wall inserted piece,

e) Screws,

f) User Manual.

Inhaltsverzeichnis

Andere Status Wasserpumpe Handbücher

Status

Status BVP300 Bedienungsanleitung

Beliebte Wasserpumpe Handbücher anderer Marken

Neptun

Neptun NPHW 5500 Bedienungsanleitung

Sensidyne

Sensidyne Gilian BDX-II Montage- und Bedienungsanleitung

Draper

Draper 47808 Bedienungsanleitung

Trolla

Trolla 12820 Bedienungsanleitung

Sunfab

Sunfab SVH Series Bedienungsanleitung

WilTec

WilTec 50740 Bedienungsanleitung

Fieldmann

Fieldmann FVC 5015 EK Bedienungsanleitung

Everbilt

Everbilt EFSUB5-122HD Bedienungsanleitung

Graco

Graco Husky 3300e Bedienungsanleitung

esotec

esotec 101018 Bedienungsanleitung

Becker

Becker BASIC VASF 2.80/1-0.AC230 Bedienungsanleitung

Sykes AmeriPumps

Sykes AmeriPumps GP100M Fehlerbehebungshandbuch

DUROMAX

DUROMAX XP WX Series Bedienungsanleitung

BRINKMANN PUMPS

BRINKMANN PUMPS SBF550 Bedienungsanleitung

Franklin Electric

Franklin Electric IPS Bedienungsanleitung

Xylem

Xylem e-1532 Series Bedienungsanleitung

Milton Roy

Milton Roy PRIMEROYAL Bedienungsanleitung

STA-RITE

STA-RITE ST33APP Bedienungsanleitung