Stovetop Firestop Plus Sensor Bedienungsanleitung

FIRE SAFETY MANUFACTURER’S INFO

WARNING CAUTION

Designed & Manufactured

by WilliamsRDM in Texas, USA

Designed solely for suppressing

stove top grease ﬁres in

indoor residential kitchens using no more

than 1” of oil before food is added.

Contents: Potassium Bicarbonate

For storage and disposal information,

or to learn more about StoveTop FireStop,

please visit our website at www.STFS.com,

or call 1-888-616-7976.

• Keep away from children.

• Avoid exposure to suppressing powder if you

wear contacts, or have a respiratory illness or

skin allergies.

• Contents may be harmful if swallowed.

• Suppressing powder is non-toxic but could

cause skin irritation. In case of contact with

powder, ﬂush from affected area with water.

• If irritation persists, contact a physician

immediately.

• Discard product after activation.

• Discard product if dropped or damaged.

• Do not clean unit.

679-S-35 Rev A 05/2018

AUTOMATIC FIRE SUPPRESSION FOR GREASE FIRES

ON INDOOR RESIDENTIAL STOVE TOPS

(CLASS K)

www.STFS.com

• Not intended for cooking with more than 1” oil

depth before food is added.

• Not recommended for gas stoves; powder may

extinguish burner ﬂame on a gas stove top

• If safe, turn burner OFF immediately after

activation.

• Reignition is possible.

• When suppressing powder comes in contact

with ﬁre, it may brieﬂy ﬂare and/or cause

grease to splash. This is a normal and

temporary reaction.

• This product may not suppress all stove top

ﬁres.

Read this user manual carefully prior to installation

FCC NOTICE

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modiﬁcations not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

HOW IT WORKS

NOTICE

• Failure to remove or replace by the “remove

or replace before” date, as shown on the

product label, could diminish the effective-

ness of the product.

• Primary activation method is through

electronic sensors.

• At time of activation (deployment), a loud

“POP” will occur, followed by 3 long,

repeating tones. This is normal and meant

to alert occupants, if present.

• Device is equipped with a fuse that works

as a secondary activation method in case

of dead batteries.

• Replace batteries as required to ensure

optimum performance. Do not mix old and

new batteries. It is recommended that you

not mix brands.

• When testing the unit, do not expose

bottom of the canister toward bright lights

while testing the device.

• A self-test should be manually performed

once every month for the life of the product.

• Unattended cooking is the leading cause of

ﬁres in the kitchen. Many injuries occur when

occupants attempt to ﬁght the ﬁre themselves.

• Never leave anything cooking on the stove top

unattended! If you have to leave the kitchen

—even for a short time— turn off the stove.

• Never leave home or fall asleep while you are

cooking.

• Never pick up a ﬂaming pan. You may be

burned, or if the pan is dropped, ﬂames may

quickly spread to other ﬂammable areas.

• Never use water to ﬁght a grease ﬁre! A violent

explosion may result. Wet dishcloths or towels

are also dangerous.

• Always follow National Fire Protection

Association (NFPA) guidelines for proper

cooking safety. Visit www.nfpa.org.

USER MANUAL

The Next Evolution in StoveTop FireStop®

Burner on. Cooking surface

and pan left unattended.

Smoke ﬁrst visble at 18-25

minutes* after stove has

been turned on.

Heavy smoke starts about

28-35 minutes* after stove

has been turned on.

Fire starts at XXXºF (XXX

C)*, or approximately 43

minutes after stove has

been turned on.

STFS Plus S detects

ﬁre conditions. Sounds

warning for 30 seconds

until conditions are safe or

deployment.

STFS Plus S deploys

powder onto cooking

surface, and emits 3 long,

loud tones.

Once STFS Plus S has

deployed powder, the ﬁre

should be suppressed.

An alert will sound until

batteries run out or unit

is silenced. Stove must

be turned off to prevent

reﬂash.

(not drawn to scale) IN THE BOX (not drawn to scale)

STFS PLUS SENSOR CANNISTERS ONE ASSEMBLED PAIR FOR EACH 4-BURNERS

STFS PLUS SENSOR CANISTERS

WHAT’S IN THE BOX

Bottom View

Sensor Board Detail ViewSide View

Top View

STFS PLUS S MECHANICAL INSTALLATION

(3)

(2)

1) Must have 15-32” (38-81 cm) between surface of cooktop and mounting point in range hood. Clean and dry areas in range hood where both

magnets will attach.

2) Position canisters in range hood at the midpoint between the center of front and back burners on each side.

3) Raise canisters to the spot directly above in range hood.

4) Place the enclosed decal where it can be seen in the ventilation hood.

If the magnet does not attach, go to www.STFS.com to order an alternative mounting kit.

(4)

(1)

A. STFS Plus Sensor Canister

B. Magnet

C. Sensor Board

D. Test / Reset Button

E. Board Screws (3 per canister)

F. Pull Tab

G. Decal, 1 per pair

H. Expiration Date (on Label)

STFS PLUS S ACTIVATION & TEST

INITIAL ACTIVATION

1) Pull out the red tab to activate the product. The product should

emit an ‘activation jingle’, one time.

(2)

(1)

TESTING

1) To test the device, hold Test button for more than 3 seconds until

a tone is heard.

2) When the button is released, or has been held down for 5

continuous seconds, the tone will stop.

Do not point the sensors at bright lights when performing a self test.

If no sound is heard, Test was successful.

(1)

(2)

TROUBLESHOOTING

CONDITION SOUND ACTION CYCLE MEANING

TESTING

Power On Activation

jingle

Initial activation by pulling tab,

or batteries have been replaced

Only once when tab is

pulled, OR when batteries

are replaced.

Device is powered on and

working properly

Self Test Continuous

tone

Press and Hold self-test button

until tone sounds (approximately

3 seconds)

Tone sounds for a

duration of 5 seconds or

until button is released

Device has initiated a self-test.

See below for results.

CONDITION SOUND MEANING CYCLE REMEDY

ALERTS

No Power No tone Batteries contact impeded, or

battery life expired None

Remove then reinstall existing

batteries, clearing any debris

preventing battery contact.

Retest. If no sound, replace

with new batteries. Retest.

If still no sound, contact

manufacturer immediately.

Low Battery 1 tone Low Battery

Repeats every 60 seconds

until batteries run out or

are replaced, or unit is

silenced.*

Replace old batteries with

two (2) new, 1.5V alkaline,

N-cell batteries

Fault 2 tones An error has been detected

within the sensor board

Repeats every 60 seconds

until batteries run out, or

unit is silenced.*

Go to STFS Plus Sensor

Troubleshooting Section

at www.STFS.com. Do not

dismount canisters. The unit

will still function if ﬂames from

a cooking ﬁre come in direct,

sustained contact with the fuse.

Warning 3 tones

The conditions for a ﬁre to

start have been detected.

Action needed to prevent ﬁre or

deployment.

Repeats every 2 seconds

for 30 seconds until

conditions improve, or

unit is silenced.*

If safe to do so, turn off stove.

Do not reach across the pan.

Press button to silence alarm.

If nothing changes, unit will

deploy powder onto stove top.

Deploy

3 LOUD

tones

A ﬁre has been detected, and

deployed suppression powder

Repeats every 1.5

seconds until batteries

run out or are removed, or

unit is silenced.*

Leave dwelling immediately,

then call 911. Once powder has

been deployed, the unit must

be replaced.

* Alarms can be silenced by pressing the TEST/SILENCE button on the bottom of the unit. This will only silence the alarm for about one day. Speciﬁc

action must be taken to permanently silence any of the alarms.

2) If no sound is heard, proceed to TESTING section and/or BATTERY

REPLACEMENT sections.

See chart below for explanation of additional alerts.

3 secs

5+ secs

Manufactured by WilliamsRDM

200 Greenleaf Street

Fort Worth, TX 76107

817 872-1500 tel

888 616-7976 toll free

[email protected]

STFS.com

BATTERY REPLACEMENT

1) Use #2 Phillips head screw driver to unscrew the

three (3) small screws from the sensor board.

2) Remove the sensor board, taking care not to

damage or disconnect the wires.

3) Properly dispose of the existing batteries. Check for

any debris in the battery compartment that would

interfere with battery contact.

4) Replace with two (2) new, 1.5V alkaline N-cell,

batteries. Do not mix new and old batteries.

5) Fold the wires back into place, taking care

not to damage the wires.

6) Reattach the sensor board with the three (3) small

screws, and reinstall per installation instructions.

Do not tamper with any sensors, or any other

parts of the product or you risk device malfunction

and voiding manufacturer’s warranty.

(5)

(2)

(1) (3)

(6)

(4)

trademarks or trademarks of WilliamsRDM, Inc. in the United States, and/or other countries. Model No. 679-S-3A. Patent info at www.STFS.com/patents.

WilliamsRDM, Inc. (“WRDM”) warrants this StoveTop FireStop®

product against defects in material or workmanship for the time

periods and under the terms set forth below. Pursuant to this

Limited Warranty, WRDM will, at its option, (i) repair the product

using new or refurbished parts or (ii) replace the product with a

new or refurbished product. For purposes of this Limited Warranty,

“refurbished” means a product or part that has been returned to its

original speciﬁcations. In the event of a defect, these are your

exclusive remedies.

WRDM warrants to the original retail purchaser all WRDM products

for a period of one (1) year against defective material and faulty

workmanship. Any unit found to be defective during the warranty

period will be repaired if possible, or replaced free of charge upon

the buyer’s prepaid return of the defective unit—only after receipt

of an ofﬁcial Return Material Authorization (RMA) number. Proof of

retail purchase is required. This warranty gives the buyer speciﬁc

legal rights which may vary by state (or country.)

THE FORGOING WARRANTY IS MADE IN LIEU OF ALL OTHER

WARRANTIES WITH RESPECT TO THIS PRODUCT, INCLUDING

ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE—WHICH ARE HEREBY

DISCLAIMED. THERE ARE NO IMPLIED WARRANTIES WHICH

EXTEND BEYOND THE DESCRIPTION ON THE FACE HEREOF. NO

PERSON IS AUTHORIZED TO GIVE ANY OTHER WARRANTY, OR

TO ASSUME FOR WRDM ANY OTHER LIABILITY IN CONNECTION

WITH THE SALE OR INSTALLATION OF ITS PRODUCTS.

REPLACEMENT OF THE PRODUCT WILL BE THE SOLE REMEDY

WITH RESPECT TO ANY LOSS OR DAMAGE TO PROPERTY.

BUYER IS NOT RELYING ON SELLER’S JUDGMENT REGARDING

BUYER’S PARTICULAR REQUIREMENTS AND BUYER HAS HAD

AN OPPORTUNITY TO INSPECT THE PRODUCT TO BUYER’S

SATISFACTION. UNAUTHORIZED SERVICE OF ANY KIND

INVALIDATES ALL WARRANTY PROVISIONS.

This Limited Warranty covers only the hardware components

packaged with this product. It does not cover technical assistance

for hardware. Any parts or product replaced under this Limited

Warranty will become the property of WRDM.

LIMITATION ON DAMAGES: WRDM SHALL NOT BE LIABLE FOR

ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING

BUT NOT LIMITED TO ANY SUCH DAMAGES FOR ANY BREACH

OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT.

Instructions: To obtain warranty service, you must deliver the

product, freight prepaid, in either its original packaging, or

packaging affording an equal degree of protection, to WRDM’s

speciﬁed manufacturing facility.

This Limited Warranty only covers product issues caused by defects

in material or workmanship during ordinary consumer use; it does

not cover product issues caused by any other reason, including but

not limited to product issues due to commercial use, acts of God,

misuse, limitations of technology, or modiﬁcation of or to any part

of the WRDM product. This Limited Warranty is invalid if either the

factory-applied work order number or date code has been altered

or removed from the product. This Limited Warranty is valid only in

the United States.

For StoveTop FireStop customer service:

go to www.STFS.com or call 1-888-616-7976.

LIMITED WARRANTY

Andere Stovetop Firestop Sicherheitsprodukt für Zuhause Handbücher

Stovetop Firestop

Stovetop Firestop PLUS SENSOR Bedienungsanleitung

Beliebte Sicherheitsprodukt für Zuhause Handbücher anderer Marken

First Alert

First Alert Fire Escape Ladder EL52W-2 Bedienungsanleitung

AOSafety

AOSafety GoggleGear Dust Bedienungsanleitung

Westfalia

Westfalia 69 86 96 Bedienungsanleitung

Summer

Summer 7260 Bedienungsanleitung

LST

LST M400DKMB-AS Bedienungsanleitung

FireAngel

FireAngel WFS-627 Bedienungsanleitung

Samsung

Samsung SSA-R2001 Bedienungsanleitung

Hydreon

Hydreon FakeTV FTV-10 Bedienungsanleitung

KIDPRO

KIDPRO Monofilament net Abmessungen und Installationsanleitung

Fiessler

Fiessler ESPE Type 4 Bedienungsanleitung

Maretron

Maretron MD-6517-N Bedienungsanleitung

LST

LST MGE8-1 Bedienungsanleitung

P3 International

P3 International Mini Bug Detector P7050 Bedienungsanleitung

FireAngel

FireAngel Stove Guard SGEL-SN-1 Bedienungsanleitung

Smanos

Smanos PB1000 Bedienungsanleitung

Innohome

Innohome SGK4010 Bedienungsanleitung

Pima

Pima RMC Series Bedienungsanleitung

Mustang Survival

Mustang Survival MD3183 Bedienungsanleitung