Summit 2014 ZTR-22 Bedienungsanleitung
2014 ZTR-22 & ZTR-22-SE
Owner's Manual
Version 1.0
Summit Lawn Mower Co.
Summit Lawn Mower Co. | (662)-266-7256 | www.SummitMowers.com
TABLE OF CONTENTS
Chapter 1) Operation
Chapter 2) Safety
Chapter 3) Service & Maintenance
Chapter 4) Troubleshooting
Chapter 5) Warranty Information
CHAPTER 1
Operation
- The transmitter has two joysticks and a toggle switch. The
right joystick moves the mower in all directions while the left
joystick starts and stops the engine. The toggle switch is for
high or low speed. Use slow gentle movements with the right
joystick and avoid sudden full throttle movements keeping a
finger on the joystick at all times. You do not want to "flick"
the spring loaded joystick.
-The transmitter has a green and red mark on the left
joysitck. Red will stop the engine and green will start the
engine. Avoid starting the engine while the engine is running
by glancing down at your transmitter when starting and
stopping your engine.
- When powering up the system, it is best to always power on
the transmitter first and last when powering the system off so
the transmitter will always be able to communicate with your
mower.
-The transmitter has "trim control" to make small
adjustments to each joystick's "center". Example: If your
mower is pulling to the right when driving straight, adjust the
bottom trim control on the right joystick to the left until it
drives straight.
-The transmitter has "servo reversing". These are set and
configured from the factory to operate your mower properly.
If for some reason these are tampered with, you will need to
set them so the mower does what you tell it to do. The top
two switches relate to the movement control of your mower.
-The transmitter is equipped with "channel mixing". This
allows you to control movement with one joystick instead of
"tank steer" with two joysticks. If you ever replace the
transmitter, holding both joysticks down and out while turning
the new transmitter on will activate channel mixing. It will
give 3 beeps indicating channel mixing is enabled.
-The power switch on the rear of your mower will power on
your mower's electronics. Always remember to turn it off
while not in use.
-The deck height adjustment is a manual design allowing you
to raise and lower the deck from 2-6 inches. Never raise or
lower the deck while the engine is on and always shut the
engine off before approaching your mower.
Chapter 2
Safety
1) NEVER operate or allow someone to operate your mower
under the influence of drugs or alcohol.
2) NEVER place your hands or feet near moving parts.
Always allow the engine to cool before servicing.
3) NEVER approach your mower while the engine is running.
Always shut off the engine before approaching the mower.
4) NEVER adjust the deck height adjustment while the engine
is running.
5) NEVER operate your mower out of range. Always be at a
safe distance to observe the mower's surroundings. Be aware
of any objects that may be on the ground before mowing.
NEVER "test" the mower's 300 ft range of operation.
6) NEVER allow children to operate your mower. It is not a
toy.
7) ALWAYS make sure the batteries are charged before
operation. A weak mower battery can cause the on-board
electronics to have poor response characteristics. If the
battery struggles to start the mower, STOP! It is too weak to
safely operate the on-board electronics.
8) NEVER use a transmitter that has been dropped or may
have been subject to water damage. If your transmitter tells
your mower to do something, it WILL do it. Always know it is
telling your mower to do what you tell it to do.
9) In the event the electronics compartment is submerged or
exposed to excessive amounts of water, do not "test" the
mower to see if it works. Replace the electronic components
that were exposed to water.
10) When servicing the cutting blades from underneath the
mower, always remove the engine's spark plug first. It doesn't
take much to start the engine by turning the blade.
13) When mowing steep slopes, use caution not to lose
footing. NEVER attempt a zero-turn maneuver on a steep
slope.
14) When mowing steep slopes, NEVER keep the mower on
one side for long periods at a time. While the engine is
equipped with pressurized filtration, it is still better to alternate
sides when slope mowing.
15) For slopes too steep to maintain control, and going down
hill only is the only option, keep the spark plug side of the
engine up and this should only be used for short periods and
NEVER a continuous duty technique.
Chapter 3
Service and Maintenance
Blade Maintenance
Sharpening or replacing the blade on your mower is best
performed with the mower on the ground. For blade
replacement, use a 22" mulching blade with 3/8" center hole
and blade adapter slots. ALWAYS replace the lock washer and
use an impact/torque wrench to torque to 70-ft-lbs.
*CAUTION*
If hoisting the front end of your mower for easy acces to the
blade, use extra caution as serious injury or death may occur
from droppng the mower on you.
*DANGER*
When servicing the blade, ALWAYS remove the engine's spark
plug wire to prevent accidental engine start up from turning the
blade manually.
*DANGER*
Improper blade installation can result in serious injury,death or
property damage. ALWAYS install the blade with the proper
torque and new lock washer.
Sharpening the blades is easiest using a 60 grit flap disk
attachment on an angle grinder. A 45 degree edge is the best
balance between cut quality and blade durability.
Leveling the Deck
To level the deck, add/remove 3/8" flat washers
(shims)between the deck and linkage posts. Start with the
Dieses Handbuch passt für folgende Modelle
1
Andere Summit Rasenmäher Handbücher
Beliebte Rasenmäher Handbücher anderer Marken
TALEN TOOLS
TALEN TOOLS AVR HGM30 Bedienungsanleitung
DEWEZE
DEWEZE ATM-725 Bedienungsanleitung
Weed Eater
Weed Eater 180083 Bedienungsanleitung
Husqvarna
Husqvarna Poulan Pro PP185A42 Bedienungsanleitung
Better Outdoor Products
Better Outdoor Products Quick Series Bedienungsanleitung
Cub Cadet
Cub Cadet 23HP Z-Force 60 Betriebsanleitung
