Summit CP171 Series Bedienungsanleitung

REFRIGERATOR WITH BOTTOM FREEZER

CP171 Series

User's Manual

FELIX STORCH, INC.

770 Garrison Avenue

Bronx, NY 10474

www.summitappliance .com

IMPORTANT SAFEGUARDS

WARNING: Keep ventilation openings in the appliance’s cabinet or in the built-in structure clear

of obstruction.

WARNING: Do not use other mechanical devices or other means to accelerate the defrosting

process than those recommended by the manufacturer.

WARNING: Do not damage the refrigerant system.

WARNING: Do not use electrical appliances inside the refrigerated storage compartment

unless they are of a type recommended by the manufacturer.

WARNING: Do not expose the appliance to rain.

WARNING: This appliance is not intended for use by young children or infirm persons unless

they have been adequately supervised by a responsible person to ensure that they can use

the appliance safely. Young children should be supervised to ensure that they do not play

with the appliance.

WARNING: Risk of child entrapment.

Before you throw away your old refrigerator or freezer:

Take off the doors.

Leave the shelves in place so that children may not easily climb inside.

Always keep the keys in a separate place and out of reach of children.

Before servicing or cleaning the appliance, disconnect the electrical power supply.

If the power supply cord is damaged, it must be replaced by the manufacturer, its service

agent, or similarly qualified persons in order to avoid a hazard.

Frost formation on the interior evaporator wall and upper parts is a natural phenomenon.

Therefore, the appliance should be defrosted during normal cleaning or maintenance.

Directions for replacing the light bulb are included in the instructions.

Please note that changes to the appliance construction will cancel all warranty and product

liability.

Table of Contents

Important Safeguards ................................................................................................2

Before your first use ..................................................................................................3

Location of Parts .......................................................................................................4

Electrical Connection .................................................................................................5

Installation and Start-up .......................................................................................6 - 8

Reversing the Doors ..................................................................................................9

Operation and Function ....................................................................................10 - 12

Defrosting ................................................................................................................13

Cleaning and Maintenance ......................................................................................14

Disposal ..................................................................................................................14

Troubleshooting .......................................................................................................15

Warranty ..................................................................................................................16

Before your first use

This appliance is for indoor use only.

On receipt, check to ensure that the appliance has not been damaged during transport.

Transport damage should be reported to the local distributor before the appliance is put

to use.

Wash the cabinet and inner lining with a mild unscented detergent and wipe it dry. Do

not use scouring powder, steel wool or similar abrasive material.

Before operating your new appliance, please read the following instructions carefully as

they contain important information on safety, installation, operation and maintenance.

Keep the instructions for future reference.

If during transport the appliance has been laid down, or if it has been stored in cold

surroundings (colder than 41°F, or 5°C), it must be allowed to stabilize in an upright

position for at least an hour before being switched on.

Location of Parts

Control panel

Light

Shelf with storage boxes

Bottle rack

Glass shelf

Door shelf

Rating label

Crisper bins

Freezing tray

Sealing strip

Freezer drawers

Door handle

Defrost water drain

Kickplate

Adjustable feet

fig. 1

Electrical Connection

The technical information for the appliance can be seen on the rating plate on the right

inner wall of the refrigerator compartment.

Important: Wiring and connections in power supply systems must be in accordance

with all applicable (local and national) electrical codes. Consult these code lengths and

sizes prior to cabinet installation.

Power supply: (Grounded through 3 wire power supply cord) 115V ac, 60 Hz single

phase

Maximum fuse size: 10 amps

This appliance is equipped with a three-prong (ANSI type 5-15P grounded) plug for your

protection against shock hazards. The appliance should be plugged into a properly

grounded three-prong receptacle

Do not under any circumstances cut or remove the round grounding prong from the

appliance plug.

Do not under any circumstances use extension cords.

Installation and Start-up

Placement

For safety and operational reasons, the appliance must not be installed outdoors. The

appliance should be placed on a level surface in a dry, well ventilated room (max. 75%

relative air humidity). Never place the appliance close to sources of heat such as ovens

or radiators, and avoid placing it in direct sunlight.

Installation

The surface on which the appliance is to be placed must be level.

The appliance can be installed as a free-standing unit against a wall or built into a

kitchen element (fig. 2). If two appliances are placed side by side, there must be at least

30 mm (just over 1") clearance between them (ﬁg. 3).

After installation, the plug should be accessible.

fig. 3

The appliance viewed from above

If the appliance is placed beside a wall,

there must be sufficient room for the

freezer door to be opened wide enough

to allow the drawers to be pulled out

(fig. 4).

Spacers

The spacers on the rear of the appliance

ensure sufficient air circulation. Fit the two

spacers supplied with the appliance as

shown in fig. 5.

Ventilation

It is important that the appliance be well

ventilated and that air can circulate unhindered

above, below and around it. The figures to the

right illustrate how the necessary air circulation

can be ensured (figs. 6 and 7).

fig. 6 fig.7

Setting up

It is important that the appliance be absolutely level. To level the appliance, remove the

kick plate below the door and screw the adjustable feet up or down (figs. 8 and 9). If

necessary, it is possible to adjust the back feet before the upright is installed. Use a

spirit level to check that the appliance is absolutely level.

If the appliance is to be placed on a soft surface, e.g. floorboards or a carpet, it is best

to recheck whether the appliance is still level after a period of time as the underlying

surface may give under the weight of the appliance.

Do not tilt the upright more than 7 degrees to avoid damaging the floor (figs. 10 and 11).

Reversing the Doors

The doors can be changed from right-hinged to left-hinged and vice versa as follows:

1. Lay the

appliance on its

back with the

doors

uppermost.

2. Remove the

upper hinge.

3. Move the plastic plugs to where the

upper hinge was fitted.

4. Lift off the upper door and lay it aside.

5. Remove the middle hinge by

unscrewing the screws.

6. Lift off

the lower

door and

lay it aside.

emove the

lower

hinge.

Rotate the

hinge

through

180° and

refit it on

the

opposite side of the appliance.

10. Refit the kick plate

7. Remove the kick plate by pulling it

outwards and upwards.

8. Loosen lock nut with the fork

wrench enclosed and move the

pin.

11. Remove the door-closer and refit

it on

the opposite side.

12. Remember to pull the pin in the

door closer

towards

the side

before

fitting the

door.

13. Fit the

upper door.

14. Fit the

upper hinge.

15. Remove the

door handles

and refit

them on the

opposite

side.

Refit the

caps.

16. The

appliance

must be

allowed to

stabilise in an

upright

position for at

least 1 hour

before being

switched on.

17. After

reversing the

door(s), it is

important to

check that the

sealing strip

provides a

tight seal all

the way

round.

If it

does not,

carefully

heat the

strip all the

way round

using a hair

dryer. Then

ease the

strip

outwards

slightly so

that it forms

a tight seal

against the

cabinet. Be

careful not

to heat the

strip so

much that it

melts!

Operation and Function

Refrigerator section

The thermostat button can be set from 1(min.) to 7(max.). A suitable setting must be

found by trial and error. Start by setting the button to 4. Check the temperature, then

adjust the setting upwards or downwards as required. Usually, a temperature of 41°F

(5°C) is recommended for items stored in a refrigerator. To check the temperature,

place a thermometer in a glass of water positioned in the center of the cabinet for 12

hours. An average temperature of 41°F should be found in the center of the cabinet.

Freezer section

Always maintain a correct storage temperature.

The thermostat button can be set from 1(min.) to 7(max.). A temperature of 0°F

(-18°C) is recommended for items stored in a freezer. (Maintaining a temperature lower

than this consumes additional energy.) The temperature in the freezer is displayed on

the thermometer.

The control lamp lights green when the power supply is connected correctly.

The control lamp lights yellow when Super Freeze is activated.

The indicator lamp lights red and the acoustic alarm sounds if the temperature in the

freezer is too high. To switch off the acoustic alarm, set the freeze button to O(see

fig. 12). The indicator lamp continues to light red as long as the temperature in the

freezer remains too high.

When starting the freezer for the first time, switch off the acoustic alarm by setting the

freeze button to O. Once the recommended temperature (0°F, or -18°C) has been

achieved in the freezer, set the freeze button to the symbol. This will allow the

acoustic alarm to sound if the temperature in the freezer becomes too high.

It is normal that the indicator lamp lights red when the freezer is started for the first time.

It will also occasionally light red when large quantities of fresh material are put in the

freezer simultaneously.

fig. 12

Inhaltsverzeichnis

Andere Summit Kühlschrank Handbücher

Summit

Summit SP5DS2DBLK Bedienungsanleitung

Summit

Summit FF1843B Bedienungsanleitung

Summit

Summit Accucold ARS23ML Service-Handbuch

Summit

Summit BI540 SERIES Bedienungsanleitung

Summit

Summit BDR190NACSS Leitfaden

Summit

Summit MB41B Bedienungsanleitung

Summit

Summit FF43SS Leitfaden

Summit

Summit SUM-603 Bedienungsanleitung

Summit

Summit accucold FFAR21LMAN Bedienungsanleitung

Summit

Summit FFBF191SS Bedienungsanleitung

Summit

Summit FF-7 Series Leitfaden

Summit

Summit FF7BBISSHH Leitfaden

Summit

Summit SUM-P01061 Bedienungsanleitung

Summit

Summit FF520L Leitfaden

Summit

Summit FF19524 Bedienungsanleitung

Summit

Summit FF511L Bedienungsanleitung

Summit

Summit SCR600BL-BITB Leitfaden

Summit

Summit FF590 Bedienungsanleitung

Summit

Summit BAR77S Bedienungsanleitung

Summit

Summit FF1386W Bedienungsanleitung

Summit

Summit CP96 Bedienungsanleitung

Summit

Summit FF41SSTB Leitfaden

Summit

Summit FFBF240W Bedienungsanleitung

Summit

Summit FF29BL Bedienungsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung