Sundstrom SR 200 Bedienungsanleitung

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

1 of 18

Operating instruction

APR SR 200 full face

mask

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

2 of 18

General information

The SR 200 full face mask can be used in three configurations:

Together with filters/cartridges from the Sundström filter range in

accordance with NIOSH approval label.

Together with Powered Air-Purifying Respirator (PAPR) with filters

/ chemical cartridges from the Sundström filter range in accordance

with NIOSH approval label.

Together with compressed air attachment SR 307 and SR 358 or

SR 359 in accordance with NIOSH approval label.

When selecting equipment for SR 200 some of the factors that

should be taken into account are as follows:

•Type of pollutant

•Concentrations

•Work intensity

•Protection requirements in addition to respiratory protective advice.

Risk assessment should be carried by a person who has suitable

training and experience in the area.

User´s Instruction for SR 200 should be read before use.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

3 of 18

2.1 Unpacking

2.2 Packing list

Check that the equipment is complete in

accordance with the packing list, and that

no transport damages have occurred.

Packing list:

Full face mask

Filter adapter

Pre-filter holder

Pre-filter

Cleaning tissue

Test disc

User instruction

Approval Label

2.3 Filter selection

To fit the filter in a mask

Check that you have selected the right

filter / filter combination and that the

used-by date has not been passed.

Press the filter/cartridge together so that

the arrows on the particulate filter point

towards the chemical cartridge.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

4 of 18

Fit the filter/combined filter in the filter

adapter SR 280-3 so that the arrow on

the filter points towards the filter adapter.

Carefully check that the edge of the filter

is in the internal groove of the filter

mounting.

Fit pre-filter SR 221 in the pre-filter holder

and press it into place on the filter.

Turn the filters into the mask.

Screw until the thread reaches the seal at

the bottom of the filter connection, then

another 45 degrees.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

5 of 18

2.5 Inspection points before use

Check that the mask is complete,

correctly assembled, thoroughly cleaned

and undamaged.

Check particularly carefully the inhalation

and exhalation membranes and their

seats.

The membranes are consumables and

must be replaced if there are any signs

of damage or ageing.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

6 of 18

Check that the surface at the bottom of

the filter connection is in good condition.

Check that the seal at the bottom of the

filter connection is in good condition.

Check the condition of the head harness.

The head harness is a consumable item

and should be replaced if there are any

signs of wear or reduced elasticity.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

7 of 18

3 A. Donning

Remove any hood, glasses or ear

protection from head.

Slacken the four elastic straps by moving

the strap holders forward, at the same

time pulling the straps.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

8 of 18

Slacken the upper two inelastic straps by

opening the buckles.

Move the head harness upwards, place

your chin in the face piece chin support

and pull the head harness over your

head.

Tension the elastic straps in pairs by

pulling the free strap ends towards rear.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

9 of 18

Adjust the fit of the mask on your face,

so that it fits firmly but comfortably.

Adjust the lengths of the upper pair of

straps and fix by means of the buckles.

Perform a fit check

3 B. Fit Check

Place the palm of your hand lightly over

the hole on the pre-filter holder to make

it tight.

NOTE! Do not push so hard that the

respirator´s shape is affected.

• Inhale gently, the respirator should pull

inward on the face.

• Hold your breath; the respirator should

remain collapsed on the face.

• Remove the palm of your hand from

the pre-filter holder.

• Breathe normally.

Drawn up by:

2010-09-13 / RK

HI-SR 200 USA

Revision:

Reviewed:

2014-03-27 / PA

Page:

10 of 18

4.1 Cleaning

Proceed as follows:

Remove the adapter/filter.

Remove the covers for the exhalation

valves and remove the exhalation

membranes (two.)

Remove the inhalation membranes

(three.)

Remove the head harness.

If necessary, remove the visor. See

action 4.4.1

Clean as described above. Critical areas

are the exhalation membranes and the

valve seats which must have clean and

undamaged contact surfaces.

Inspect all parts and replace with new

parts if necessary.

Leave the mask to dry, and then

assemble it.

Carry out fit check as described in 3B

N.B. Never use solvent for cleaning

Sundström cleaning tissues (SR 5226)

Andere Handbücher für SR 200

Inhaltsverzeichnis

Andere Sundstrom Atemwegsprodukt Handbücher

Sundstrom

Sundstrom SR570 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 507 Montageanleitung

Sundstrom

Sundstrom SR76-2 Bedienungsanleitung

Sundstrom

Sundstrom SR 700 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 Bedienungsanleitung

Sundstrom

Sundstrom SR 90-3 Bedienungsanleitung

Sundstrom

Sundstrom SR 900 Bedienungsanleitung

Sundstrom

Sundstrom SR561 Technisches Handbuch

Sundstrom

Sundstrom SR 200 Technisches Handbuch

Sundstrom

Sundstrom SR561 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR570 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 Bedienungsanleitung

Sundstrom

Sundstrom SR 90 Airline Bedienungsanleitung

Sundstrom

Sundstrom SR 99 Bedienungsanleitung

Sundstrom

Sundstrom SR 530 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 700 Bedienungsanleitung

Sundstrom

Sundstrom SR561 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR307 Montageanleitung

Sundstrom

Sundstrom SR540EX Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 200 Bedienungsanleitung

Sundstrom

Sundstrom SR500EX Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 905 Bedienungsanleitung

Sundstrom

Sundstrom SR 500 Bedienungsanleitung

Sundstrom

Sundstrom SR 520 Montageanleitung

Beliebte Atemwegsprodukt Handbücher anderer Marken

Omron

Omron COMP A-I-R NE-C801 Bedienungsanleitung

CERES

CERES nosko nebulizer kit Bedienungsanleitung

Dr.Frei

Dr.Frei NE-SM1 Bedienungsanleitung

North

North 5400 series Bedienungsanleitung

John Bunn

John Bunn Neb-u-Lite LX2 Bedienungsanleitung

DeVilbiss

DeVilbiss UltraNeb Bedienungsanleitung

Sperian

Sperian Panther Hip-Pac P9684 Series Bedienungsanleitung

Dräger

Dräger X-plore 6570 Bedienungsanleitung

3M 8000 Series Bedienungsanleitung

Respironics

Respironics SideStream HS860 Bedienungsanleitung

JARDIBRIC

JARDIBRIC KPBRU20 Bedienungsanleitung

Ombra

Ombra 63506 Bedienungsanleitung

Lotus

Lotus M-9520A Bedienungsanleitung

Philips

Philips Respironics EE Leak 1 AF541 Bedienungsanleitung

EVOLU

EVOLU Nano AiR MINI Bedienungsanleitung

Ambu

Ambu SPUR II Bedienungsanleitung

MSA AUER

MSA AUER 3S-PF Bedienungsanleitung

MSA

MSA C420 Bedienungsanleitung