Sundstrom SR562 Installations- und Benutzerhandbuch

…assemble the SR562 head-top

BEFORE YOU START:

Check that the equipment is complete in

accordance with the packing list and has not

been damaged in transport.

Packing list:

•Hood with breathing hose.

•User instructions

•Cleaning tissue

Place the head top in the flow meter and start

the fan unit.

Grip the lower part of the bag to seal around the

breathing hose.

Grip the flow meter tube with the other hand so

that the tube points vertically upwards from the

bag.

Read the position of the ball in the tube. This

should hover at a level with or slightly above the

upper marking on the tube.

If minimum flow is not achieved, check that:

–The flow meter is held upright.

–The ball moves freely.

–The bag seals well around the hose.

Check that the O-ring of the hose is in place

Connect the hose to the fan unit and turn it

clockwise about 1/ 8 of a turn.

…put on the hood

Grip the hose mounting with one hand and the

neck section of the hood with the other. Insert

your chin into the hood. Keep your grip of the

hood and draw it over your head.

Adjust the hood so that it seals all the way round

your face and fits closely and comfortably. The

rubber band in the face seal can be adjusted to

the required length.

If necessary, adjust the circumference of the

head harness by means of the knob at the rear of

the head harness.

The knob is on the inside of the hood behind the

hose. You can reach it without taking off the

hood. Turn clockwise to tighten and counter

clockwise to widen.

If necessary, adjust the head harness in height by

lengthening or shortening the strap for the top

of the head.

Make sure that the breathing hose runs along

your back and is not twisted.

…remove the hood

Leave the polluted area before taking the

equipment off.

Slacken the neck band. In emergency situations,

the hood can be taken off with the rubber band

tightened.

Take the hood off. Switch off the fan, release the

belt and take the fan unit off.

…clean the head-top

Sundström cleaning tissues SR 5226 that clean

and disinfect are recommended for daily care.

If the equipment is more heavily fouled, use a

soft brush or sponge moistened with a solution

of water and dishwashing detergent or the like.

Rinse the equipment and leave it to dry.

N.B. Never use a solvent for cleaning.

…store the head-top and parts

After cleaning, store the equipment in a dry and

clean place at room temperature. Avoid

exposing it to direct sunlight. The flow meter can

be turned inside out and can be used as storage

bag for the head-top.

…schedule maintenance

The schedule represents the minimum

requirements for maintenance routines in order

to ensure that equipment will always be in

functional condition.

…change the sweatband

The sweatband is secured with velcro tape to the

forehead band. Proceed as follows: Pull the

sweatband off.

Fit the velcro strip with the ruffled side towards

the forehead strap and with relief upwards.

…change the Tyvek hood

Release the face seal rubber band secured to the

forehead band next to the Velcro tapes.

Remove the Velcro tapes.

Release the three press studs at the top edge of

the visor.

Lift the head harness out of the hood and

withdraw the hose.

Place the new hood in front of you, with the

visor facing up.

Thread the hose from the inside of the hood,

through the passage at the rear of the hood.

During this operation, the head harness should

rest with the opening facing upwards. Note that

the hose should not be drawn all the way

through, and around 20 cm should be left on the

inside of the hood.

Grip the front part of the head harness with one

hand and insert the head harness into the hood,

first inserting the rear part fitted with the hose.

Make sure that the Velcro tape is stretched

under the forehead band of the head harness.

Secure the hood by means of the press-studs at

the top edge of the visor.

Fold the Velcro tapes around the forehead band

and secure them as firmly as possible.

Take the face seal rubber band and insert the

knot into the keyhole opening in the head

harness.

Secure it by pulling the rubber band into the

narrow part of the slot.

Check that the head harness is straight in the

hood and that the hose passage of the hood is

not twisted around the hose.

…change the hose

Release the face seal rubber band secured to the

forehead band next to the Velcro tapes.

Remove the Velcro tapes.

Release the three press studs at the top edge of

the visor.

Lift the head harness out of the hood and

withdraw the hose.

Turn the locknut a quarter of a turn and remove

it. Use polygrip pliers if the lock nut is stiff to

turn.

Thread the pin on one side of the hose coupling

down through the recess in the head harness,

turn the hose through 180 degrees and insert

pin.

Pull the hose out of the hood.

Andere Handbücher für SR562

Inhaltsverzeichnis

Andere Sundstrom Atemwegsprodukt Handbücher

Sundstrom

Sundstrom SR 90 Airline Bedienungsanleitung

Sundstrom

Sundstrom SR500EX Installations- und Benutzerhandbuch

Sundstrom

Sundstrom H06-0321 Bedienungsanleitung

Sundstrom

Sundstrom SR 200 Bedienungsanleitung

Sundstrom

Sundstrom SR540 Bedienungsanleitung

Sundstrom

Sundstrom SR 100 Bedienungsanleitung

Sundstrom

Sundstrom SR570 Bedienungsanleitung

Sundstrom

Sundstrom SR 63 Bedienungsanleitung

Sundstrom

Sundstrom SR 100 Bedienungsanleitung

Sundstrom

Sundstrom SR 530 Bedienungsanleitung

Sundstrom

Sundstrom SR 84 Bedienungsanleitung

Sundstrom

Sundstrom SR 200 APR Bedienungsanleitung

Sundstrom

Sundstrom SR 99 Bedienungsanleitung

Sundstrom

Sundstrom SR561 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 90 Airline Montageanleitung

Sundstrom

Sundstrom SR 90-3 Bedienungsanleitung

Sundstrom

Sundstrom SR561 Bedienungsanleitung

Sundstrom

Sundstrom SR 200 Bedienungsanleitung

Sundstrom

Sundstrom SR 520 Installations- und Benutzerhandbuch

Sundstrom

Sundstrom SR 905 Bedienungsanleitung

Sundstrom

Sundstrom SR570 Bedienungsanleitung

Sundstrom

Sundstrom SR 100 APR Bedienungsanleitung

Sundstrom

Sundstrom SR 520 Montageanleitung

Sundstrom

Sundstrom SR 900 Bedienungsanleitung

Beliebte Atemwegsprodukt Handbücher anderer Marken

Omron

Omron COMP A-I-R NE-C801 Bedienungsanleitung

CERES

CERES nosko nebulizer kit Bedienungsanleitung

Dr.Frei

Dr.Frei NE-SM1 Bedienungsanleitung

North

North 5400 series Bedienungsanleitung

John Bunn

John Bunn Neb-u-Lite LX2 Bedienungsanleitung

DeVilbiss

DeVilbiss UltraNeb Bedienungsanleitung

Sperian

Sperian Panther Hip-Pac P9684 Series Bedienungsanleitung

Dräger

Dräger X-plore 6570 Bedienungsanleitung

3M 8000 Series Bedienungsanleitung

Respironics

Respironics SideStream HS860 Bedienungsanleitung

JARDIBRIC

JARDIBRIC KPBRU20 Bedienungsanleitung

Ombra

Ombra 63506 Bedienungsanleitung

Lotus

Lotus M-9520A Bedienungsanleitung

Philips

Philips Respironics EE Leak 1 AF541 Bedienungsanleitung

EVOLU

EVOLU Nano AiR MINI Bedienungsanleitung

Ambu

Ambu SPUR II Bedienungsanleitung

MSA AUER

MSA AUER 3S-PF Bedienungsanleitung

MSA

MSA C420 Bedienungsanleitung