ENGLISH
8
CONTROLS, CONNECTORS, AND
INDICATORS
qPOWER 33
33
3
Slide to turn POWER ON and slide again to turn POWER OFF.
wOPEN 33
33
3
Slide to open the disc cover.
• Be sure to stop the disc before opening the disc cover.
• A grip bar has been added to the front of the CD door in case it
does not open fully.
e66
66
6(PLAY/PAUSE)
Press to start playback.
Press during playback to pause playback temporarily.
Press during pause to restart playback.
r77
77
7(STOP)
Press to stop playback.
Press during a setting operation to cancel it.
Press once during the stop mode to cancel the Program or Repeat
modes.
Press twice during stop mode to charge the optional rechargeable
battery.
t11
11
1/ 44
44
4, ¢¢
¢¢
¢/ ¡¡
¡¡
¡
Press during playback to select the previous or next track.
Pressbeforeplaybackto select the track fromwhichto start playback.
Press during programming to select the track number.
Pressandhold during playbackforaudible fast reverseorfast forward
search.
yPROGRAM
Press to set or check the contents of a program.
uSINGLE
Pressing this button will place the CD player in the single track play
mode and “TRACK” indicator in the display will begin to flash.
Pressduringsingletrack play mode to returntothenormal play mode.
• A complete definition of this function is on page 13.
iREPEAT
Press to switch the repeat mode.
Press during A-B repeat mode to return to the normal play mode.
oA-B
Press to perform A-B repeat.
Press during A-B repeat to change the B point.
!0 TEMPO “+”, “–”
Pressing these buttons will change the playback speed (tempo) of
the CD by up to +/- 50% without changing the key (musical pitch).
Pressing the “+” button increases the tempo in 1% increments.
Press and hold the “+” button to quickly increase the tempo.
Pressing the “–” button decreases the tempo in 1% increments.
Press and hold the “–” button to quickly decrease the tempo.
Press both “+” and “–” at the same time to return the tempo back to
0% (normal tempo).
• A complete definition of this function is on page 15.
!1 KEY “+”, “–” (PSD230)
Pressing these buttons will change the key (musical pitch) of the CD
by up to +/- 1 octave without changing the tempo.
Pressing these buttons while the tempo is changed, or after the
TEMPO buttons are pressed, will change the tunning (fine key
control) of the CD by up to +/- 2% without changing the tempo.
The following applies to changing the key:
The “+” button raises the key in 12 1/2 cent increments. Press and
hold the “+” button to quickly increase the key.
The “–” key lowers the key in 12 1/2 cent increments. Press and hold
the “–”button to quickly decrease the key.
Press both “+” and “–” at the same time to reset the key to 0.00
(normal key).
The following apply to changing the tuning:
Pressing the "+" button increas the key in 0.1% increments. Press
and hold the "+" button to quickly increase the key.
Pressing the "-" button decreases the key in 0.1% increments. Press
and hold the "-" button to quickly decrease the key.
• A complete definition of these functions is on page 15.
!2 LOCK
Slide the LOCK switch to the on position (£) to lock the setting of
all the switches in the recessed portion of the top panel.
!3 IR
Receives remote control signals from a compatable wireless remote
control.
!4 HEADPHONE
Output for a set of headphones.
!5 DISPLAY
Shows the current status of the unit as described in the DISPLAY
INDICATORS section (page 9).
!6 BASS, MID, and TREBLE
Turn these knobs to adjust the tone of the CD. Turning each control
toward “+” boosts the corresponding frequency range and toward
“–” attenuates it.
TREBLE : Controls the tone of the high frequencies. (6 kHz)
MID : Controls the tone of the mid frequencies. (2 kHz)
BASS : Controls the tone of the low frequencies. (300 Hz)
!7 VOL
Turn to adjust the output volume of the HEADPHONES jack and built-
in speaker.
!8 TIME
Press to switch the time display.
!9 SCROLL (PSD230)
Press this button to sequence through the available CD-TEXT
information on a CD. The message “NO TEXT” will appear if this
button is pressed when the current CD does not contain any CD-
TEXT information.
@0 LIGHT
Press this button to illuminate the LCD display when it is difficult to
see. A single press of the LIGHTbuton will illuminatetheLCDdisplay
for 3 seconds and then turn off. If the LIGHT button is held down for
more than 1 second, the LCD display will stay illuminated until the
LIGHT button is pressed again.
@1 FOOT PEDAL IN
An optional foot pedal (model FT200) can be input to this jack to
provide start/stop control.
@2 DIGITAL OUT
The digital data is taken directly off the CD and output to this jack.
@3 LINE OUT
ThesejacksoutputthesoundoftheCD,alongwithanyenhancements
madetothesound,to another analog amplification device (amplifier,
powered speakers, stereo system, etc.), a recording device (tape
deck, CD recorder, etc.), or a mixer.
@4 VOICE REDUCTION (PSD230)
Whenthisswitch is ON, thevocaltrack of the CDwillbe reduced. The
performance of this system depends on how the CD was recorded.
@5 SPEAKER
This switch selects if the built-in speaker is on or off.
@6 LEVEL (PSD230)
This control determines the amount of signal from the MIC/LINE IN
that is mixed with the CD.
@7 MIX/SPLIT (PSD230)
This switch determines how a signal from the MIC/LINE IN is mixed
with the sound from the CD. The MIX position will mix (combine) the
input signal with both the left and right channels of the CD playing
back. The SPLIT position will separate the input signal and the CD
playing back by sending the input signal to the right channel and
both channels of the CD to the left channel.
@8 MIC/LINE IN (PSD230)
A microphone or music instrument (line level) can be plugged into
this jack using either a XLR or 1/4” plug.
