Swiss Madison SM-WC427 Bedienungsanleitung

Concealed In-Wall Toilet Tank

Carrier System 2x4

SM-WC427

@SwissMadison

#WellMadeForever

INSTALLATION INSTRUCTIONS

Wall-Hung Carrier System

well made forever

www.swissmadison.com | 1-434-623-4766 | [email protected]

Plumbers

Grease Flat File Drill

—1 —

If you have any questions or concerns please contact us:

1-434-623-4766

[email protected]

PRIOR TO INSTALLATION:

· Inspect carrier to ensure no damages have occurred while in shipping.

· Observe all plumbing and building codes in accordance with your state and local requirements.

· All dimensions are nominal! Be sure to measure your toilet prior to installation.

· The step-by-step guidelines in the installation instructions are a general reference. Should there be

any discrepancies, Swiss Madison cannot be held liable. It is recommended to install all Swiss

Madison products by hiring a licensed professional.

· Read installation and maintenance instructions thoroughly before installing. Be sure to use proper

tools and always wear proper personal safety accessories for your protection.

· Be sure to properly bleed all air from the piping system, trapped air can cause damage to the flushing

system and toilet bowl.

· Additional floor and wall preparations may be necessary to avoid damage to the product· Swiss

Madison recommends using a cement board or tile backer board for the wallboard backing, avoid

gypsum board as it may compromise the load strength of the toilet installation.

SUGGESTED TOOLS & MATERIALS:

Safety

Glasses Wrench Level

Hacksaw Tape

Measure

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

—2 —

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

2345

1. Measure Frame

· Measure frame to confirm cistern installation location

Included Parts (Carrier):

· Cistern cover

· Mounting box

· Mounting box cover

· Flush pipe assembly

· Drain pipe assembly

· Discharge pipe assembly

· Pipe clamp

· Ground fixation screws

· Allen screws

· Anchor & screw components

· Bellows

· Braided hose

· Stop valve

· Bolt components

· Tee

· Panel holder and rods

· Mounting panel

· Dust Covers

· Power wire

· Off-seat flushing module

· Flush Plate

Included Parts (Toilet):

· Smart toilet

· Transition pieces

· Nuts & washers

· Bolt covers

· Ball valve switch

· Volcros

· Remote control

· Water inlet hose

· Power cord

· Mounting pad

535mm Ø10 x 75mm

Ø10 x 75mm

381mm

500mm

1256mm

—3 —

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

2. Fasten Mounts

3. Connect Discharge Pipe

· After adjusting bowl height, fasten four mounts (A).

· Screw carrier to wood framing flush across the front.

NOTE: It is recommended to use 2 1/2” screws and 1 1/4” fender washers (4 of each total).

· Ensure frame is flush and level before fastening.

· Install the stop valve on water line in unfinished wall

· Find the center of the discharge pipe before fastening. Drill a 3 5/8” hole through framing

for later installation.

· Once discharge hole is drilled through framing, connect bracket as shown.

Water supply pipe

Control valve

W=5 ”

W=6 ”

—4 —

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

4. Install T-Connector

5. Install Auto Flush Module

· Install the t-connector inside the mounting box.

· Insert module to the designated location at the top right of the mounting box.

· Connect the 3 corresponding wires.

· Turn on the stop valve to do a water test.

—5 —

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

6. Install Cistern Cover, Mounting Box & Dust Covers

7. Connect Power Source

A) For wired connection to junction box/circle breaker.

· Attach corrugated pipe (below) to the frame by running pipe through the

bottom right hole of the frame.

· Pass the pipe through the lower right side of the frame through the designated

hole and connect the opposite end to your junction box/circuit breaker.

· After connecting the corrugated pipe to the junction box, you may finish the

wall and proceed with power connection after wall is sealed.

· Remove the dust covers and protective sleeves.

· Cut off excess corrugated pipe and detach mounting box.

· Install the power cord connector as shown below.

FFL

500mm

—6 —

WALL-HUNG CARRIER SYSTEM INSTALLATION INSTRUCTIONS

8. Connect Power Source cont.

· Install the power cord connector.

· Cut plug from end of power cord.

· Pass power cord through corrugated pipe and into junction box.

· With the power turned off, install the circuit breaker in accordance with the circuit breaker manual.

1. Remove Seat

· Open seat lid and remove fixing screws/washers from seat lid.

· Remove the bidet seat from the toilet bowl.

2. Dry Fit Outlet Pipe and Inlet Pipe

· Attach mounting pad.

· Fully insert straight tube into cistern flushing outlet then connect pipe into discharge outlet.

· Draw lines to mark the finished wall location on each pipe as pictured below.

Toilet Installation

50mm

—7 —

SMART TOILET INSTALLATION INSTRUCTIONS

3. Determine Pipe Size

· Apply lubricant on rubber washers of straight tube and connecting pipe, then insert into holes.

· Draw lines on pipes as pictured below.

4. Cut Pipes

· Measure the distance between both marked lines on pipe. Take measured distance, deduct from

bald end of pipe and cut pipes as shown below.

· After cutting, take a file and remove all burrs. Try and bevel pipe edge.

L1: The distance between the two lines on the straight tube.

L2: The distance between the two lines on the connecting pipe.

L1+5mm

L1 L2

L2+3mm

—8 —

SMART TOILET INSTALLATION INSTRUCTIONS

5. Mount Toilet Bowl

· Apply lubricant to the joint surface on straight tube and connecting pipe.

· Mount the toilet bowl to the wall.

6. Level and Attach Bowl

· Attach bowl using the washers and bolts, make sure the bowl is level, then cover with included cap.

· Remove extra liner along the outline of the toilet.

· Fill any gaps with cement or sealant.

—8 —

SMART TOILET INSTALLATION INSTRUCTIONS

Inhaltsverzeichnis

Andere Swiss Madison Sanitärprodukte Handbücher

Swiss Madison

Swiss Madison SM-BF23 Bedienungsanleitung

Swiss Madison

Swiss Madison SM-UM621 Bedienungsanleitung

Swiss Madison

Swiss Madison Concorde SM-SB510 Bedienungsanleitung

Swiss Madison

Swiss Madison Vivante SM-STS01 Bedienungsanleitung

Swiss Madison

Swiss Madison VESSEL SM-VS242MB Bedienungsanleitung

Swiss Madison

Swiss Madison Claire SM-CS741 Bedienungsanleitung

Swiss Madison

Swiss Madison SM-PS307 Bedienungsanleitung

Swiss Madison

Swiss Madison SM-WC426 Bedienungsanleitung

Swiss Madison

Swiss Madison Claire SM-CS771 Bedienungsanleitung

Swiss Madison

Swiss Madison SM-VS201 Bedienungsanleitung

Swiss Madison

Swiss Madison Cache SM-WS321 Bedienungsanleitung

Swiss Madison

Swiss Madison Pierre SM-BV551 Bedienungsanleitung

Swiss Madison

Swiss Madison Delice Ceramic Farmhouse Kitchen Sink Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Kohler

Kohler K-6228 Montageanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Kohler

Kohler K-12183 Montageanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Kohler

Kohler Centerset K-15240 Montageanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

Kohler

Kohler Mira Eco Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema