Syn-Apps 011411 Handbuch
Quick Reference 931312B © 2016, Syn-Apps L.L.C. ALL RIGHTS RESERVED© 2016, Syn-Apps L.L.C. ALL RIGHTS RESERVED 931312B Quick Reference
Dimensions
5
4
3
2
1
3
2
1
CLASS II WIRING
MIC IN
STROBE
www.cyberdata.net
Mono(+)/Left Spkr (+) - 12
Left Spkr (-) - 11
Right Spkr (+) - 10
Mono(-)/Right Spkr (-) - 9
Line-Out (+) - 8
Line-Out (-) - 7
Line-In (-) - 6
Line-In (+) - 5
Relay COM - 4
Relay NO/NC - 3
Door Sense/Button Common (GND) - 2
Door Sense/Button Contact (+) - 1
SAFETY WARNING!
Please read the owner’s manual for proper
installation. Incorrect wiring can lead to
and/or other attached components.
CLASS II WIRING
1.042 [26.5]
0.326 [8.3]
7.303 [185.5]
3.295 [83.7]
7.795 [198.0]
Dimensions are in Inches [Millimeter]
ø0.172 [ø4.4]
(2 Places)
Typical System Installation
Parts
Contacting Syn-Apps
Parameter Factory Default Setting
IP Addressing DHCP
IP Addressa
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username admin
Web Access Password admin
Subnet Maska255.0.0.0
Default Gatewaya10.0.0.1
Compliant PoE Ethernet Switch
VoIP Phone
SA Announce Server
Syn-Apps enabled
Paging Amplifier
(1) Screw Accessory Kit
(2) Plastic Ribbed Anchors (2) #6x1.25" Pan Head
Phillips Sheet Metal Screw
(1) Assembly
Corporate Headquarters
Syn-Apps LLC
2812 N Norwalk
Suite 112
Mesa, AZ 85215
Phone: 480-664-6071 / 866-664-6071
Fax: 480-659-8999 / 866-659-8999
Website: www.syn-apps.com
Sales: [email protected]
Support: http://www.syn-apps.com/resources/support
Email: http://www.syn-apps.com/contact-us
Installation Quick Reference
Syn-Apps-enabled Paging Amplifier
011411
© 2016, Syn-Apps L.L.C. ALL RIGHTS RESERVED 931312B QuickReference Quick Reference 931312B © 2016, Syn-Apps L.L.C. ALL RIGHTS RESERVED
Features
SPD Link/Act.
PWR Status
Volume
RTFM
VoIP
Loudspeaker
Speaker Volume
Speed (SPD) LED (AMBER)
The Speed (SPD) LED illuminates AMBER for a 100Mb link
or is off for a 10MB link when the network link to the device is established.
Status LED (GREEN)
The GREEN Status LED illuminates after supplying power to the device.
Link/Activity (Link/Act.) LED (GREEN)
The GREEN Link/Activity (Link/Act.) LED blinks to indicate network traffic.
Power (PWR) LED (GREEN/BLUE)
The Power (PWR) LED is GREEN in low power mode (802.3af)
and BLUE during high power mode (802.3at).
RTFM Switch
To broadcast the device’s current IP address, press and hold the RTFM switch for a couple
of seconds and then release it.
To restore the factory defaults, complete the following steps:
1. Press and hold the RTFM switch until you hear the device announce the words,
“restoring defaults” and “rebooting”.
2. Release the RTFM switch. The device will be restored to the factory default settings.
Connection Options
Mono(+)/Left Spkr (+) - 12
Left Spkr (-) - 11
Right Spkr (+) - 10
Mono(-)/Right Spkr (-) - 9
Line-Out (+) - 8
Line-Out (-) - 7
Line-In (-) - 6
Line-In (+) - 5
Relay COM - 4
Relay NO/NC - 3
Door Sense/Button Common (GND) - 2
Door Sense/Button Contact (+) - 1
CLASS II WIRING
Speaker Connections*
Line-Out Connection (10K Ohm)
Line-In Connection
Relay Connection
Sensor Connection
Line-In Connection Sensor Connection
Relay Connection
High PIV Ultrafast
Switching Diode
Output Contacts
AC or DC-rated
depending upon
controlled device
requirements
DC Power Supply
(Max. 30 VDC @ 1A)
Solid State or
Mechanical
Relay
AC or DC
Power
Source
IN
OUT
External device
such as an
electric door strike
or an LED strobe
light
When line-in is enabled on
the device, the audio
received from the line-in
connection will be played
to the speaker(s) and line-
out connection as the
lowest priority audio.
Music Source
Paging Amplifier
*See the Operations Guide for diagrams and
information about the connections in this section.
Paging Amplifier
Paging Amplifier
Andere Syn-Apps Verstärker Handbücher
