System Sensor APA151 Bedienungsanleitung

APA151 Annunciator

with Piezo Alert

INSTALLATION AND MAINTENANCE INSTRUCTIONS

3825 Ohio Avenue, St. Charles, Illinois 60174

1-800-SENSOR2, FAX: 630-377-6495

www.systemsensor.com

NOTICE: These models were only tested at the 16-33 Volt DC limits. This does

not include the 80% low-end or 110% high-end voltage limits. This manual

shall be left with the owner/user of this equipment.

GENERAL INFORMATION

The National Fire Protection Association (NFPA) has published codes, stan-

dards, and recommended practices for the installation and use of this product.

It is recommended that the installer be familiar with these requirements, with

local codes, and any special requirements of the local authority having juris-

diction. For further information, consult NFPA 72 and 90A requirements.

The System Sensor APA151 annunciator with piezo alert is an audible signal

appliance for fire alarm service. It is intended for use in System Sensor 4-wire

conventional duct smoke detector applications without a system control panel

to comply with NFPA 90A.

The APA151 provides a red alarm LED, with an audible annunciation of an

alarm signal, and a green power LED.

SPECIFICATIONS

Dimensions: 4.6˝ L × 2.9˝ W × .45˝ D

Weight: .17 lbs.

Electrical Requirements

Voltage: Regulated 24VDC

Operational Voltage: 16–33 VDC

Maximum Operating Current: 30mA

Connections: #6 binding head screws, 12 AWG to 18 AWG wire

UL Reverberant Room: 81 dBA min. @ 10 ft.

Standard Operating Temperature: 0°C to 49°C (32°F to 120°F)

Humidity Range: 10% to 93% non-condensing

FIGURE 1:

A0360-01

I56-2964-004

APA151 CONTENTS

1 APA151 annunciator with piezo alert

1 screw pack (containing two mounting screws)

FIGURE 2: WIRING DIAGRAM FOR D4120 TO APA151:

FIGURE 3: WIRING DIAGRAM FOR D4120/DH100ACDC TO APA151:

D4120

APA151/451

(GREEN LED) POWER

FIELD

INSTALLED

JUMPER

–

AUX OUT +

AUX OUT –

ALARM

R TEST

ACC +

ACC –

R RESET

SUP, NO

SUP, C

NOTE: WIRING DIAGRAM SHOWN IS FOR D4120 4-WIRE DUCT SMOKE

DETECTOR SYSTEM EQUIPPED WITHOUT A CONTROL PANEL.

NOTE: A TROUBLE CONDITION IS INDICATED

BY LOSS OF GREEN LED

COMMON

(RED LED) ALARM

Alarm Signal

Aux. Power +

Sup. N. O.

Sup. COM

Aux. Power –

NOTE: Wiring diagram shown is for DH100ACDC 4-wire duct

smoke detector system equipped without a control panel.

Alarm

(Red LED)

Power

(Green LED)

Common

4-Wire Wiring to APA151

APA151DH100ACDC

H0581-01

INSTALLATION

Wire the APA151 as shown in Figure 1 thru Figure 3 depending on what duct

smoke detector is being utilized. Limit wire runs to 25 ohms or less per inter-

connecting wire.

Secure the APA151 to the single gang box using the two screws provided, or

directly to the wall or ceiling.

OPERATIONAL TEST

Consult the wiring diagrams below to insure proper wiring to the APA151.

Supply power to the duct smoke detector. Visually check the supervisory LED

(green) to make sure it is operational.

Put the detector into alarm state. The alarm LED (red) will light, and the piezo

horn will sound. Reset the detector.

H0584-02

1 I56-2964-004

06-10

System Sensor warrants its enclosed product to be free from defects in materials and

workmanship under normal use and service for a period of three years from date of

manufacture. System Sensor makes no other express warranty for the enclosed product.

No agent, representative, dealer, or employee of the Company has the authority to in-

crease or alter the obligations or limitations of this Warranty. The Company’s obligation

of this Warranty shall be limited to the replacement of any part of the product which is

found to be defective in materials or workmanship under normal use and service during

the three year period commencing with the date of manufacture. After phoning System

Sensor’s toll free number 800-SENSOR2 (736-7672) for a Return Authorization number,

send defective units postage prepaid to: Honeywell, 12220 Rojas Drive, Suite 700, El Paso

The sounder will not operate if the power is cut off for any reason.

The sounder may not be heard. The loudness of the sounder meets or exceeds the current

standards. However, the sounder may not alert a sound sleeper or one who has recently

used drugs or has been drinking alcoholic beverages. This sounder may not be heard if

it is placed in an area that is separated by a closed door, or if it is located on a different

floor from the person in a hazardous situation, or if it is placed too far away to be heard

THE LIMITATIONS OF SOUNDERS

over ambient noise, such as, traffic, air conditioners, machinery or musical appliances

that may prevent alert persons from hearing the alarm.

The sounder may not be heard by persons who are hearing-impaired. In this case, a

visual indicator shall also be used.

For these reasons, Pittway recommends that sounders (85dBA minimum at 10 feet)

used in a residence shall be placed on every level and in every bedroom that does not

have a smoke detector with a built-in sounder.

THREE-YEAR LIMITED WARRANTY

TX 79936, USA. Please include a note describing the malfunction and suspected cause

of failure. The Company shall not be obligated to replace units which are found to be

defective because of damage, unreasonable use, modifications, or alterations occurring

after the date of manufacture. In no case shall the Company be liable for any consequen-

tial or incidental damages for breach of this or any other Warranty, expressed or implied

whatsoever, even if the loss or damage is caused by the Company’s negligence or fault.

Some states do not allow the exclusion or limitation of incidental or consequential dam-

ages, so the above limitation or exclusion may not apply to you. This Warranty gives you

specific legal rights, and you may also have other rights which vary from state to state.

WARNING

2 I56-2964-004

Andere System Sensor Sicherheitssystem Handbücher

System Sensor

System Sensor ExitPoint PF24V Bedienungsanleitung

System Sensor

System Sensor ECO 2000 Technische Daten

System Sensor

System Sensor APA151 Bedienungsanleitung

System Sensor

System Sensor PS24LO Bedienungsanleitung

System Sensor

System Sensor P4RLA Bedienungsanleitung

System Sensor

System Sensor SpectrAlert S900RLFIRE Bedienungsanleitung

System Sensor

System Sensor SpectrAlert Series Bedienungsanleitung

System Sensor

System Sensor CH1224 Bedienungsanleitung

System Sensor

System Sensor CO1224A Bedienungsanleitung

System Sensor

System Sensor APA451 Bedienungsanleitung

System Sensor

System Sensor SSM24-6 Technische Daten

System Sensor

System Sensor FL0111E Bedienungsanleitung

System Sensor

System Sensor B200SR-LF Bedienungsanleitung

System Sensor

System Sensor 2012/24AUS Bedienungsanleitung

System Sensor

System Sensor SpectrAlert Advance P2R Bedienungsanleitung

System Sensor

System Sensor ExitPoint PF24VA Bedienungsanleitung

System Sensor

System Sensor SpectrAlert S1224MCW Bedienungsanleitung

System Sensor

System Sensor SpectrAlert S1224MCW Bedienungsanleitung

System Sensor

System Sensor LASS-WSS-NC Bedienungsanleitung

System Sensor

System Sensor L-Series Bedienungsanleitung

System Sensor

System Sensor P2R Bedienungsanleitung

System Sensor

System Sensor PS24LO Bedienungsanleitung

Beliebte Sicherheitssystem Handbücher anderer Marken

Inner Range

Inner Range Concept 2000 Bedienungsanleitung

Climax

Climax Mobile Lite R32 Montageanleitung

CADDX

CADDX NX-6 Bedienungsanleitung

FBII

FBII XL-31 Series Bedienungsanleitung

Johnson Controls

Johnson Controls PENN Connected PC10 Bedienungsanleitung

Aeotec

Aeotec Siren Gen5 Bedienungsanleitung

Blaupunkt

Blaupunkt SA 2700 Bedienungsanleitung

IDEAL

IDEAL Accenta Betriebsanleitung

AJAX

AJAX DoubleButton Bedienungsanleitung

Swann

Swann SW-P-MC2 Bedienungsanleitung

Ecolink

Ecolink Siren+Chime Bedienungsanleitung

Digital Monitoring Products

Digital Monitoring Products XR150 Bedienungsanleitung

EDM

EDM Solution 6+6 Wireless-AE Bedienungsanleitung

Highway Safety Group

Highway Safety Group EA401 Bedienungsanleitung

Siren

Siren LED GSM Bedienungsanleitung

Detection Systems

Detection Systems 7090i Montageanleitung

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 Bedienungsanleitung

Siemens

Siemens FDM273 Bedienungsanleitung